Dell E6530 Service Manual

Back to Contents Page    
Modem Connector  
 
Removing the Modem Connector  
   
    
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .   
3. Remove the  access panel .   
4. Remove the  subscriber identity module (SIM) card .   
5. Remove the  optical drive .   
6. Remove the  keyboard .   
7. Remove the  coin - cell battery .   
8. Remove the  hinge covers .   
9. Remove the  display assembly .   
10. Remove the  hard drive .   
11. Remove the  Latitude ON™...

Back to Contents Page    
Modem Port Plug  
 
Removing the Modem Port Plug  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Insert a paper clip into the release hole and remove the modem port plug from the computer.  
   
Replacing the Modem Port Plug  
To replace the modem port plug, slide the modem port plug back into the modem port.  
Back to Contents Page    
   
    WARNING:  Before working inside your computer, read the safety information that shipped with your...

Back to Contents Page    
Memory  
 
Removing the Memory Module(s)  
   
1. Follow the procedures in  Before Working Inside Your Computer .  
2. Remove the  battery .   
3. Remove the  access panel .   
4. Carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up. 
   
5. Remove the memory module from the connector. 
   
Replacing the Memory   
To replace the memory modules(s), perform the above steps in reverse order.  
Back to Contents Page...

Back to Contents Page    
Modem  
 
Removing the Modem  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .   
3. Remove the  access panel .   
4. Remove the screw that secures the modem to the computer. 
   
5. Using the Mylar tab, gently lift the modem up. 
   
6. Disconnect the modem cable from the modem and remove the modem from the computer. 
   
Replacing the Modem  
To replace the modem, perform the above steps in reverse order.  
Back to Contents...

Back to Contents Page    
Optical Drive  
 
Removing the Optical Drive  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the screw that secures the optical drive to the computer. 
   
3. Press in on the optical drive release latch to release the optical drive from the computer. 
   
4. Slide the optical drive out of the computer. 
   
Replacing the Optical Drive  
To replace the optical drive, perform the above steps in reverse order.  
Back to Contents Page...

Back to Contents Page    
Palm Rest Assembly  
 
Removing the Palm Rest Assembly  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .  
3. Remove the  access panel .  
4. Remove the  optical Drive .  
5. Remove the  keyboard .  
6. Remove the  hinge Covers .  
7. Remove the  fingerprint reader .  
8. Remove the  display assembly .   
9. Remove the screws that secure the palm rest to the bottom of the computer. 
   
10. Remove the screws that secure the palm...

Back to Contents Page    
Removing and Replacing Parts   
 
 
Back to Contents Page       Battery   
   Subscriber Identity Module (SIM) Card  
   ExpressCard    
   Optical Drive    
   LED Cover  
   Access Panel   
   Fingerprint Reader  
   Modem  
   Coin - Cell Battery  
   Wireless Wide Area Network (WWAN) Card   
   Heat Sink and Fan Assembly   
   Display Assembly  
   Display Hook  
   Camera and Microphone  
   Palm Rest Assembly  
   Bluetooth ®  Card  
   ExpressCard Board  
   I/O Board...

Back to Contents Page    
PCMCIA Card  
 
Removing the PCMCIA Card  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Press the PCMCIA card eject button in to release the eject button from the computer. 
   
3. Press the PCMCIA card eject button in again to release the PCMCIA card from the computer. 
   
4. Slide the PCMCIA card out of the computer. 
   
Replacing the PCMCIA Card  
To replace the PCMCIA card, perform the above steps in reverse order.  
Back to Contents Page...

Back to Contents Page    
PCMCIA Card Cage  
 
Removing the PCMCIA Card Cage  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery    
3. Remove the  PCMCIA card .   
4. Remove the  access panel .   
5. Remove the  hinge covers .   
6. Remove the  LED cover .   
7. Remove the  keyboard .   
8. Remove the  hard drive .   
9. Remove the  finger print reader .   
10. Remove the  heat sink and fan assembly .   
11. Remove the  display assembly .   
12. Remove the...

Back to Contents Page    
Processor  
 
Removing the Processor  
   
1. Follow the procedures in  Before Working Inside Your Computer .   
2. Remove the  battery .  
3. Remove the  access panel .  
4. Remove the  heat sink and fan assembly .   
5. Turn the cam screw counter - clock wise until it comes to a stop to release the processor from the system board. 
   
6. Carefully lift the processor up from its slot on the system board and remove the processor from the computer. 
   
Replacing the Processor...