Dell H 625 Cdw Manual

Troubleshooting |391
Wireless Problems
NOTE:
•Wireless network is available on Dell H625cdw and Dell H825cdw.
Problems With Installed Op tional 550-sheet feeder
If an optional 550-sheet feeder does not operate correctly following installation or stops 
working, perform the following:
• Turn off the printer, wait for 10 seconds, and then turn it on again. If this does not fix
the problem, unplug the printer, and  then check the connection between the
optional 550-sheet feeder and the printer.
• Print the...

392| Troubleshooting
Wi-Fi Direct Problems
NOTE:
•Wi-Fi Direct is available on Dell H625cdw and Dell H825cdw.
Scanner Driver/Printer Utility Problems
Other Problems
Problem Action
The optional 550-sheet feeder does 
not work correctly. Make sure that the optional 550-sheet feeder is correctly installed 
on the printer. Re-install the fe
eder. See "Removing the Optional 
550-Sheet Feeder," and refer to the installation instruction that 
comes with the optional 550-sheet feeder.
Make sure that the...

Troubleshooting |393
*Dell Document Hub is available on Dell H625cdw and Dell H825cdw.
Contacting Service
When you call for printer service, be prepared to describe the problem you are 
experiencing or the error message that appears.
You need to know the model type and Service Tag number of your printer. See the label 
located inside the front cover of your prin ter and write down the Service Tag number. 
For details on the location of the Service Tag, see "Express Service Code and Service...

394|
Appendix 

Appendix |395
Appendix
Dell™ Technical Support Policy
Technician-assisted technical support requires the cooperation and participation of the 
customer in the troubleshooting process and provides for restoration of the operating system, 
software program and hardware drivers to the original default configuration as shipped from 
Dell, as well as the verification of appropriate functionality of the printer and all Dell-installed 
hardware. In addition to this technician assisted technical support, online...

396| Appendix
New Zealand PTC200 Warnings
General warning
“The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has 
accepted that the item complies with minimum conditions for connection to its network. It 
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. 
Above all, it provides no assurance that any item will work correctly in all respects with another 
item of Telepermitted equipment of a different make or model, nor does...

Appendix |397
USA/Canada Wi-Fi Warnings
Class B:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may...

398| Appendix
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio 
frequency exposure limits. The Wireless Device should be used in such a manner such that the 
potential for human contact during normal operation is minimized.
This device has also been evaluated and shown compliant with the IC RF Exposure limits under 
mobile exposure conditions. (antennas are greater than 20cm from a person's body).
This device has been...

Appendix |399
Avis :• Le présent matériel est conforme aux spécifications techniques d'Industrie Canada 
applicables au matériel terminal. Cette conformité est confirmée par le numéro 
d'enregistrement. Le sigle IC, placé devant le numéro d'enregistrement, signifie que 
l'enregistrement s'est effectué conformément à une déclaration de conformité et indique 
que les spécifications techniques d'Industrie Canada ont été respectées. Il n'implique pas 
qu'Industrie Canada a...