Electrolux Eww 126410 User Manual

Clean the filter under a tap, to remove
any traces of fluff.
12
7. Remove foreign bodies and fluff from the
pump seat and from the pump impeller.
8. Check carefully whether the pump im-peller rotates (it rotates jerkily). If it
doesn’t rotate, pl ease contact your
Service Centre.
9. Replace the filter in to the pump by in-
serting it correctly  into the special
guides. Screw the pump cover firmly by
turning it clockwise.
10. Replace the emergency emptying cap
into the filter cove r and fix it firmly....

Warning! When the appliance is in use
and depending on the programme
selected there can be hot water in the
pump. Never remove the pump cover
during a wash cycle,  always wait until the
appliance has finished the cycle, and is
empty. When refitting the pump cover ,
ensure it is securely  re-tightened so as
to stop leaks and yo ung children being
able to remove it.
Cleaning the water inlet filters
If you notice that the m achine is taking longer
to fill, check that the fi lter in the water inlet
hose is...

5. Refit the emergency emptying cap intothe filter and screw the water inlet hose
back.
6. When you intend to  start the machine up
again, make sure that the room temper-
ature is above 0°C.
Important!  Every time you drain the water
through the emergency emptying hose you must pour 2 litres of water into the main wash
compartment of the de
tergent drawer and
then run the drain programme. This will
activate the  ECO Valve device avoiding that
part of the detergent remains unused at next
washing.
What to...

ProblemPossible cause/Solution
The machine does not emp-
ty and/or does not spin:
The drain hose is squashed or kinked. E20
• Check the drain hose connection.
The drain filter is clogged.  E20
• Clean the drain filter.
An option or a programme that ends  with the water still in the tub or
that eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
There is water on the floor:
Too...

ProblemPossible cause/Solution
The machine makes an un-
usual noise:The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor en-
sures a softer start and more even  distribution of the laundry in the
drum when spinning, as well as  increased stability of the machine.
No water is visible in the
drum:Machines based on modern tech nology operate very economically
using very little water wi thout affecting performance.
The machine does...

Consumption values
ProgrammeEnergy consumption(KWh)Water consumption(litres)Programme duration(Minutes)
White Cottons 90°2.061
For the duration ofthe programmes,
please refer to the
display on the con- trol panel.
Cottons 60°1.358
Cotton Energy Saving
Programme 60° 1)1.0246
Cottons 40°0.758
Synthetics 40°0.550
Delicates 40°0.5560
Wool/ Handwash 30°0.2553
1) «Cotton Energy Saving programme » at 60°C with a load of 6 kg is the reference programme for the data entered in
the energy label, in compliance...

4. Slide out the relevant plastic spacers.
5. Open the porthole and remove the poly-
styrene block fitted on the door seal.
6. Fill the smaller upper hole and the two large ones with the corresponding plastic
plug caps supplied in the bag containing
the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulat ion around the machine
is not impeded by carpets, rugs etc. Check
that the machine does  not touch the wall or
other kitchen units. Level the washing...

levelling prevents vibration, noise and dis-
placement of the machine during operation.
Caution!  Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
Warning!  This appliance must be
connected to a cold water supply.
1. Connect the water inlet hose supplied with the machine to a tap with a 3/4
thread. Always use the hose supplied
with the appliance.
Important!  Do not use the hose from
your previous machine to connect to the
water...

•In a sink drain pipe branch.  This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
• Directly into a drain pipe  at a height of
not less than 60 cm  and not more than 90
cm. The end of the drain hose must always
be ventilated, i.e. the inside diameter of the
drain pipe must be la rger than the outside
diameter of the drai n hose. The drain hose
must not be kinked.
The drain hose may be extended to a maximum  of 4 metres. An additional drain hose and
joining piece is...

Environment concerns
The symbol    on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipmen t. By ensuring this
product is disposed of correctly, you will help
prevent potential negative consequences for
the environment and  human health, which
could otherwise be cau sed by inappropriate
waste handling of this product. For more
detailed...