Epson AcuLaser C2800N User Manual

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products211
9. Lock the lock levers on both sides of the fuser unit.
Note:
Make sure that the lock levers are completely back to the locked position.
10. Close the paper guide on the top front of the printer.
 
						

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products212
11. Remove the light shielding paper from the printer.
12. Close the front cover.
 
						

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products213
Transfer Unit
Handling precautions
Always observe the following handling precautions when replacing the consumable products.
Do not touch the surface of the consumable product. Doing so may impair print quality.
w
Warning:
❏Do not dispose of the used consumable products in fire, as it may explode and cause injury. 
Dispose of it according to local regulations.
❏Keep the consumable products out of the reach of children.
Replacing the transfer unit
Follow the steps below to replace the transfer unit.
1. Press the latch on the front cover and open the cover.
c
Caution:
❏Do not leave the front cover open for more than five minutes to avoid exposing the imaging 
cartridges to light.
❏Do not expose the imaging cartridges to sunlight at all.
 
						

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products214
2. Take the light shielding paper from the new transfer unit’s package and attach it to the printer.
3. Pull up the blue tabs on both sides of the transfer unit.
w
Warning:
Be careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE, or the 
surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very 
hot. If you must touch one of these areas, wait 30 minutes to allow the heat to subside before doing 
so.
 
						

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products215
4. Raise the transfer unit and pull it up out of the printer.
5. Take the new transfer unit from its package.
6. Lower the transfer unit inside the printer making sure that the posts on the transfer unit into 
the guides, then pull down the transfer unit.
 
						

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products216
7. Remove the protective material from both sides of the transfer unit.
c
Caution:
Do not touch the transfer belt on the transfer unit to avoid damaging it.
8. Remove the protective material on the transfer unit.
 
						

							AcuLaser C2800 Series Users Guide
Replacing Consumable Products217
9. Remove the light shielding paper from the printer.
10. Close the front cover.
 
						

							AcuLaser C2800 Series Users Guide
Cleaning and Transporting the Printer218
Chapter 11 
Cleaning and Transporting the Printer
Cleaning the Printer
The printer needs only minimal cleaning. If the printer’s outer case is dirty or dusty, turn off the 
printer and clean it with a soft, clean cloth moistened with a mild detergent.
c
Caution:
Never use alcohol or paint thinner to clean the printer cover. These chemicals can damage the 
components and the case. Be careful not to get water onto the printer mechanism or any electrical 
components.
 
						

							AcuLaser C2800 Series Users Guide
Cleaning and Transporting the Printer219
Cleaning the pickup roller
1. Turn off the printer.
*OFF
2. Pull the paper cassette unit out.
*
 
						

							AcuLaser C2800 Series Users Guide
Cleaning and Transporting the Printer220
3. Gently wipe the rubber parts of the pickup roller inside the printer with a well-wrung wet 
cloth.
4. Insert the paper cassette unit.