Fujitsu Lpf-D711 Users Manual

English
Deutsch
Espa
ñol
Fran
çais
Italiano
Portugu
ês

E-2
SAFETY PRECAUTIONS
Dear Customer:
We have prepared this USER'S MANUAL to assist you in the operation of your new LCD Projector. We thank you for your purchase and
hope you will be satisfied with the quality and performance of this projector. Please read the instructions carefully, and keep them 
available for future reference.
• A Class A digital device
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.  These...

E-3
English
Deutsch
Espa
ñol
Fran
çais
Italiano
Portugu
ês

E-4
INFORMATION
• Receptacle
Make sure that the power cable’s grounding wire is grounded.
The display comes with a 3-prong power plug; one prong is connected to the grounding wire.  If you have only a 2-hole receptacle, you 
will need to have it replaced.  Contact your dealer for more information.
• Have the display inspected and cleaned by your dealer at regular intervals.
• The liquid crystal panels are manufactured with very precision techniques resulted in 99.99% or more effective pixels. Please...

E-5
English
Deutsch
Espa
ñol
Fran
çais
Italiano
Portugu
ês

E-6
ADDITIONAL PRECAUTIONS
When transporting the projector unit, take care not to apply undue force to it.  Otherwise, lens and other breakable parts may be damaged.
• The light source lamp loses its brightness with use.  When the lamp replacement warning 
is given, or when the lamp will not light, the picture becomes dim or its color becomes 
dull, replace the lamp with a new one. (The light source lamp for replacement can be 
purchased from your dealer.)
• When the warning message at right is shown,...

E-7
English
Deutsch
Espa
ñol
Fran
çais
Italiano
Portugu
ês

E-8
ADDITIONAL PRECAUTIONS (Continued)
Both the projector and AV selector have a signal receiver for the wireless remote control on their front.  If a strong light such as fluorescent 
light strikes upon the signal receivers, the wireless remote control may not work properly.  In that case, keep the projector unit away from 
the illumination source such as fluorescent light, or re-install it at a place where light will not directly strike on the signal.
To keep the projector unit away from the...

E-9
English
Deutsch
Espa
ñol
Fran
çais
Italiano
Portugu
ês

E-10
INSTALLATION (Continued)
• Three types of installation are available; front projection, rear projection and ceiling mount projection.
• By adjusting the zoom (see page E-31), the screen size can be selected as shown in the table below.
• By adjusting the lens shift (see page E-31), a suitable projection position can be selected on the screen.
• Projectors have an error of 5% in projection distance and lens shift.
• Optimum projection screen size is 120 to 150 inches.
* "Angle of view" refers...