Gateway 200 series User Manual

							221
Cleaning your computer
www.gateway.com
To clean your trackball mouse:
1Turn the mouse upside down.
2Rotate the retaining ring on the bottom of the mouse counter-clockwise, 
then remove the retaining ring and mouse ball.
3Remove any dust, lint, or dirt from the mouse ball with a soft cloth.
4Clean the mouse rollers with a cotton swab dipped in isopropyl alcohol.
5Replace the mouse ball and lock the retaining ring into place.
Mouse rollers 
						

							222
Chapter 13: Maintaining Your Computer
www.gateway.com 
						

							14
223
Restoring
Software
Read this chapter to learn how to:
■Reinstall device drivers
■Update device drivers
■Reinstall programs
■Reinstall Windows
If you are not comfortable with the procedures covered in 
this chapter, seek help from a more experienced computer 
user or a computer service technician. 
						

							224
Chapter 14: Restoring Software
www.gateway.com
Using the Restoration CDs
Use the Gateway Restoration CDs to reinstall device drivers, your operating 
system, and other programs that were preinstalled at the factory.
ImportantBefore you try to fix a problem by reinstalling software from 
your Gateway Restoration CDs, make sure that you have 
tried these steps first:
■Use the diagnostics and troubleshooting tools found in 
HelpSpot. For more information about diagnostics and 
troubleshooting tools in Windows XP, click Start, then 
click Help and Support.
Type the keyword troubleshooting in the HelpSpot 
Search box  , then click the arrow.
■Run System Restore. For more information about 
System Restore in Windows XP, click Start, then click 
Help and Support.
Type the keyword System Restore in the HelpSpot 
Search box  , then click the arrow.
■See the Troubleshooting section of this guide.
If these steps do not resolve the problem, use the Gateway 
Restoration CDs to reinstall device drivers or programs.
If reinstalling device drivers or programs does not resolve 
the problem, reinstall Windows. 
						

							225
Reinstalling device drivers
www.gateway.com
Reinstalling device drivers
Device drivers are programs that control devices such as the computer display, 
CD or DVD drives, and modems. Drivers translate information between 
computer devices and programs.
Drivers for your original computer hardware are installed at Gateway. If you 
install a new device, you need to install the drivers provided by the device 
manufacturer.
You should reinstall device drivers:
■If directed to do so while troubleshooting
■If you see a message indicating that there is a problem with a device driver
If you need to reinstall device drivers because you are directed to do so while 
troubleshooting or if a message tells you that there is a problem with a device 
driver, reinstall the device drivers by completing the following task.
If you just reinstalled Windows XP or Windows 2000, the device drivers were 
automatically reinstalled.
To reinstall device drivers:
1Insert the red Gateway CD into the CD or DVD drive. If the program starts 
automatically, go to Step 5.
- OR -
If the program does not start automatically, go to Step 2.
2Click Start, then click Run. The Run dialog box opens.
3In the Open text box, type d:\runmenu.exe (where d is the drive letter of 
your CD or DVD drive).
4Click OK.
5If this is the first time you have inserted the red Gateway CD, accept the 
End User License Agreement (EULA) by clicking 
Yes, I accept it, then 
clicking 
Continue. The Gateway Driver and Application Recovery program 
starts and the 
Drivers and Application Recovery tab appears. 
						

							226
Chapter 14: Restoring Software
www.gateway.com
6Select a single device driver to reinstall.
- OR -
Click 
Automatic Installation, then select multiple device drivers to reinstall. 
(Grayed out drivers are not available for Automatic Installation. To select 
these drivers, click 
Manual Installation.)
7Click Install.
8Follow any additional on-screen instructions. Depending on the device 
driver you are reinstalling, you may only need to restart your computer 
to complete the installation. However, if a setup wizard opens when you 
restart your computer, follow the on-screen instructions.
Help and 
SupportFor more information about reinstalling device drivers in 
Windows XP, click Start, then click Help and Support.
Type the keyword drivers in the HelpSpot Search box 
, then click the arrow. 
						

							227
Updating device drivers
www.gateway.com
Updating device drivers
The Restoration CDs contain a device driver update utility that works over the 
Internet. If you do not have an Internet service provider, the update utility 
works by direct-dialing the device driver update service.
To update device drivers:
1Insert the red Gateway CD into the CD or DVD drive. If the program starts 
automatically, go to Step 5.
- OR -
If the program does not start automatically, go to Step 2.
2Click Start, then click Run. The Run dialog box opens.
3In the Open text box, type d:\runmenu.exe (where d is the drive letter of 
the CD or DVD drive).
4Click OK.
5If this is the first time you have inserted the red Gateway CD, accept the 
End User License Agreement (EULA) by clicking 
Yes, I accept it, then 
clicking 
Continue. The Gateway Driver and Application Recovery program 
starts and the 
Drivers and Application Recovery tab appears.
6Click the Web Updates tab.
7Click Check Now. The Connect window opens.
ImportantIf your system came equipped with a wireless device, only 
use the drivers approved for the country the device will be 
used in. See the red Gateway CD or the Gateway 
Technical Support Web site (support.gateway.com
).
If your system came equipped with an internal embedded 
wireless device, see “Safety, Regulatory, and Legal 
Information” on page 275 for general wireless regulatory 
and safety guidelines.To find out if your system has an 
internal wireless device, check the label (see “Identifying 
your model” on page 9). 
						

							228
Chapter 14: Restoring Software
www.gateway.com
8Install available updated device drivers by following the on-screen 
instructions. Depending on the device driver you are updating, you may 
only need to restart your computer to complete the installation. However, 
if a setup wizard opens when you restart your computer, follow the 
on-screen instructions.
Reinstalling programs
If you have problems running a program or if you have reinstalled your 
operating system, you can reinstall programs from the red Gateway CD and 
other program CDs. If you are reinstalling programs from other program CDs, 
follow the installation instructions on each CD. If you want to reinstall a 
program, uninstall the old version first.
To reinstall programs from the Applications CD(s):
1If you just reinstalled Windows, go to Step 4. Otherwise, go to the next 
step.
2In Windows XP, click Start, Control Panel, then click 
Add or Remove Programs.
- OR -
In Windows 2000, click 
Start, Settings, Control Panel, then double-click the 
Add or Remove Programs icon.
3In the Currently Installed Programs list, click the program you want to 
uninstall, then click 
Change/Remove and follow the on-screen instructions.
Help and 
SupportFor more information about updating device drivers in 
Windows XP, click Start, then click Help and Support.
Type the keyword updating drivers in the HelpSpot 
Search box  , then click the arrow. 
						

							229
Reinstalling programs
www.gateway.com
4Insert the red Gateway CD into the CD or DVD drive. If the program starts 
automatically, go to Step 8.
- OR -
If the program does not start automatically, go to Step 5.
5Click Start, then click Run. The Run dialog box opens.
6In the Open text box, type d:\runmenu.exe (where d is the drive letter of 
your CD or DVD drive).
7Click OK.
8If this is the first time you have inserted the red Gateway CD, accept the 
End User License Agreement (EULA) by clicking 
Yes, I accept it, then 
clicking 
Continue. The Gateway Driver and Application Recovery program 
starts and the 
Drivers and Application Recovery tab appears.
9Select a single program to reinstall.
- OR -
Click 
Automatic Installation, then select multiple programs to reinstall. 
(Grayed out programs are not available for Automatic Installation. To select 
these programs, click 
Manual Installation.)
10Click Install.
11Follow any additional on-screen instructions. Depending on the programs 
you are reinstalling, you may only need to restart your computer to 
complete the installation. However, if a setup wizard opens when you 
restart your computer, follow the on-screen instructions.
Help and 
SupportFor more information about reinstalling programs in 
Windows XP, click Start, then click Help and Support.
Type the keyword installing programs in the HelpSpot 
Search box  , then click the arrow. 
						

							230
Chapter 14: Restoring Software
www.gateway.com
To reinstall other programs from a CD:
1If you just reinstalled Windows, go to Step 4. Otherwise, go to the next 
step.
2In Windows XP, click Start, Control Panel, then click 
Add or Remove Programs.
- OR -
In Windows 2000, click 
Start, Settings, Control Panel, then double-click the 
Add or Remove Programs icon.
3In the Currently Installed Programs list, click the program you want to 
uninstall, then click 
Change/Remove and follow the on-screen instructions.
4Insert the program CD into the CD or DVD drive.
5Complete the program reinstallation by following the instructions 
included with the program CD.
Reinstalling Windows
If your computer is not working correctly, try the following options to correct 
the problem:
■Troubleshooting. For more information, see “Troubleshooting” on 
page 247.
■Run System Restore.
■Reinstalling device drivers. For more information, see “Reinstalling device 
drivers” on page 225.
If the options above do not correct the problem, you can use the Restoration 
CDs to reinstall Windows and other software.
The Restoration CDs step you through reinstalling Windows XP or 
Windows 2000. If you are reinstalling Windows XP or Windows 2000, the 
Restoration CDs automatically reinstall the hardware device drivers and some 
programs as well. You can install any remaining programs by using the program 
CDs that came with your computer. To reinstall your programs, follow the 
instructions in “Reinstalling programs” on page 228.