Indesit Idce G45 B Manual

1
English,1
EN
IDCE H G45 B
Instruction manual
TUMBLE DRYER
!  This symbol reminds you to read this instruction manual.
! Keep this manual at hand for immediate reference whenever 
necessary. Always store this manual close to the tumble dryer and 
remember to pass it on to any new owners when selling or tran -
sferring the appliance, so they may familiarise with the warnings 
and suggestions herein contained.  
! Read these instructions carefully: the following pages contain 
important information on...

2
Failure to clean the filter after each drying cycle 
can undermine drying performance as the machine 
takes longer to dry and thus consumes more 
energy. 
Water container – empty the water container after 
each drying cycle. Step 1
Pull the water container towards 
you and remove it completely 
from the dryer.
Step 2
Empty all the water in the water 
container. 
Step 3
Replace the water container 
making sure that it is securely 
fixed. 
Failure to empty the water container may cause the 
following: 
-...

3
Condenser unit - remove any fluff build-up from the condenser on a monthly basis.
Step 1
Open the condenser cover
- grip the handle and pull 
towards you.Step 2
Remove the condenser by 
turning the 3 catches, then pull 
the condenser towards you. (It is 
normal for some residual water 
to be left in the tubes).
Step 3
Clean the condenser with 
running water over the rear side 
to remove any fluff deposits. 
Step 4
Replace the condenser unit; 
make sure that the unit is 
securely in place, that all 3...

4
Installation
Where to install the tumble dryer
• Install the dryer far from gas 
ranges, stoves, radiators or 
hobs, as flames may damage 
it.
If the dryer is installed below a 
worktop, ensure there are 10 
mm between the upper panel 
of the dryer and any objects 
above it, and 15 mm between 
the sides of the machine and 
the walls or furniture units adja-
cent to it. This ensures adequate air circulation.
Ventilation
• The room must be adequately ventilated while the dryer is 
running. Make sure that...

5
On/Off 
buttonStart/Pause button 
and indicator light
Programme 
selection knob
Press  
the door
Condenser unit   
(cover open)
 
Water container  Rating plate 
Condenser cover 
handle (pull to open) 
Filter 
Air 
intake  grille
 
Description of 
the tumble dryer
Opening the door
Control panel   Features
Options buttons and 
indicator lights
DisplayDelay start button
Timed Drying button
Empty water container indicator light
Clean filter indicator light
Clean 
condenser unit 
indicator light
Cycle...

6
ON/OFF/Reset button
Pressing the button normally will cause the machine to switch on or off. If the button is pressed for 3 seconds while the dryer is in use, 
the machine will switch off and the running cycle will reset.  
Programme selection knob 
Allows for setting the programme: turn until the indicator points towards the desired programme (see Starting and selecting a programme).
Options buttons
Allows selection of the options available for the selected programme. The respective indicator lights...

7
How to carry out a 
drying cycle
Starting and selecting a programme
1. Plug the dryer into the power supply socket.
2. Select the programme according to the type of laundry (see Laundry).
3. Open the door, ensure that the filter is clean and securely placed and that the water container is empty and correctly slotted (see 
Maintenance).
4. Load the machine, making sure that no piece of laundry gets between the door and the relative seal. Close the door.
5. Press the ON/OFF button to switch on the...

8
Special/Sport/Partial Programmes
Energy Saver Cycles
The Energy Saver Cycles reduce energy consumption and so they not only help the environment, they also cut your energy bill! 
Energy Saver Cycles are available for several different types of fabric, there is one you can use with cottons, there is one specially 
for shirts and there is one for use with synthetic fabrics. They have all been designed to \
guarantee excellent drying performance for 
small loads.
Energy Saver Cycles give the best drying...

9
Jeans Programme  
This programme is suited for drying cotton denim jeans. Turn the front pockets inside out before drying the jeans. It is suitable for 
loads of up to 3 kg (about 4 pairs). 
Garments dried using this programme are usually ready to be worn, though edges and seams may be slightly damp. If this occurs, 
turn the jeans inside out and reactivate the programme for a short while.
! The duration of this program will depend on the size of the load and the spin speed used in you\
r washer.
Use...

10
Options 
The options allow for customising the selected programme according to one’s own needs.
Timed drying 
 
After selecting a programme, press the “Timed drying” button to en\
ter a drying time. Every time this button is pressed, the duration of 
the selected drying cycle appears on the display. When pressed the first\
 time, the highest allowed value for the selected cycle appears 
on the display. When pressed each of the following times, the set time i\
s reduced until OFF appears. 
The buzzer...