Indesit Idce G45 B Manual

11
Sorting laundry
• Check the symbols on the care labels of the various gar-
ments to verify whether the garments can be safely tumble 
dried.
• Sort laundry according to the type of fabric.
• Empty all pockets and check for loose buttons.
• Close zips and hooks and fasten belts and strings without  tightening them.
• Wring out garments to remove the maximum amount of  water possible.
!
 Do not load the dryer when garments are dripping wet.
Maximum load sizes
Do not overload the drum.
The following...

12
Special garments 
Blankets and bedcovers: acrylic items (Acilian, Courtelle, 
Orion, Dralon) must be dried with great care at low heat. 
Avoid drying for long periods.
Creased or pleated garments: read the drying instructions 
supplied by the manufacturer.
Starched garments: do not dry together with non-starched 
items. Remove the maximum amount of starch solution pos-
sible before placing these items in the dryer. Do not over-dry: 
starch turns powdery leaving garments limp – this defeats its...

13
Warnings  
and suggestions
! This appliance has been designed and built according to 
international safety standards. These warnings are given for 
safety reasons and must be followed carefully.
General safety
• This tumble dryer is not intended for use by persons (including children) with reduced physical, sensory or 
mental capabilities , or lack of experience and knowledge, 
unless they have been given supervision or instruction 
concerning use of the appliance by a person responsible 
for there...

14
Water container 
Condenser unitCondenser cover
Catches Filter
Handle Air intake Ta p
Rear
Front
Condenser 
unit
Care and maintenance
Disconnecting the power supply
! Disconnect the dryer when not in use or during cleaning 
and maintenance operations.
Cleaning the filter after each cycle  
The filter is a fundamental component of the dryer: its function 
is to collect lint and fluff that form during drying.
Clean the filter once drying is completed, by rinsing it under run -
ning water or cleaning it...

15
Troubleshooting 
Possible causes / Solutions:•  The plug has not been inserted far enough into the socket to make contact.
•  There has been a power cut.
•  The fuse has blown. Try connecting another appliance to the same socket.
•  If an extension cord is used, try connecting the dryer plug directly into the socket.
•  The door has not been closed properly.
•  The programme has not been set correctly (see How to carry out a drying cycle).
•  The 
START/PAUSE button has not been pressed (see How to...

16
Before calling the Technical Assistance Centre:
• Follow the troubleshooting guide to check whether pro-
blems can be solved personally  (see Troubleshooting).
• If not, switch the dryer off and contact the Technical Assi -
stance Centre closest to you. 
Provide the following data when contacting the 
Technical Assistance Centre:
• name, address and postal code
• telephone number
• type of malfunction
• date of purchase
• the appliance model (Mod.)
• the dryer’s serial number (S/N)
This information...

17
Español
Índice
Información importante, 18-19
Instalación, 20
Dónde instalar la secadora
Aireación
Conexión eléctrica
Información preliminar
Descripción de la secadora, 21-22
Características
Panel de control
Cómo realizar un secado, 23
Puesta en funcionamiento y selección del programa
Programas y opciones, 24-25-26
Tabla de programas
Programas especiales
Opciones
Abertura de la puerta
Ropa, 27-28
Subdivisión de la ropa
Etiquetas de mantenimiento
Prendas especiales
Tiempos de secado
Advertencias y...

18
2
Información importante
Para el funcionamiento eficiente de la secadora por 
condensación es necesario respetar el esquema de 
mantenimiento ordinario indicado a continuación:
Filtro para la pelusa – ES NECESARIO quitar la 
pelusa que se deposita en el filtro al finalizar cada 
ciclo de secado. Fase 1
Abra la puerta de la secadora 
presionándola como se indica en 
la figura.   
Fase 2
Extraiga el filtro (utilizando dos 
dedos).
Fase 3
Quite la pelusa de la superficie 
interna de la red del filtro....

19
Unidad de condensación - Es necesario limpiar 
la pelusa del condensador cada mes.
Fase 1
Abra la tapa del condensador
- sostenga la manija y tire hacia 
Ud.
Fase 2
Quite el condensador girando 
los 3 ganchos y luego tire del 
condensador hacia Ud. (Podría 
haber agua en los tubos: esto es 
normal).
Fase 3
Limpie el condensador con agua 
haciéndola pasar por la parte 
posterior para extraer posibles 
depósitos de pelusa. 
Fase 4
Vuelva a instalar la unidad 
de condensación, controle 
que el grupo esté...

20
Dónde instalar la secadora 
• Las llamas pueden averiar la 
secadora, por lo tanto, debe 
estar alejada de cocinas a gas, 
estufas, radiadores o encime-
ras.
Si el electrodoméstico debe 
instalarse debajo de una 
encimera, es necesario dejar 
un espacio de 10 mm entre 
el panel superior del electro-
doméstico y los otros objetos 
dispuestos encima de la misma, 
y un espacio de 15 mm entre 
los lados del electrodoméstico y las paredes o las decora-
ciones dispuestas al costado del mismo. De este modo...