Konica Minolta bizhub 363 User Manual

							bizhub 423/363/283/2234-34
4.5 HDD Backup Utility4
10Make sure that the backup procedure has been completed. Then, click [Finish].
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub 423/363/283/2234-35
4.5 HDD Backup Utility4
4.5.2 Restore
1Start the HDD Backup Utility.
2Select this machine and click [Restore].
3Click [OK].
4Click [Browse] and specify the destination, in which the backup file is to be saved.
%If a password has been set for the backup data, type the password that consists of one to 64 digits 
set during Backup and click [OK].
5Click [Next].
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub 423/363/283/2234-36
4.5 HDD Backup Utility4
6Type the 8-digit Administrator Password registered in the machine in the Administrator Password 
box.
%If the Save the administrator password check box is selected, the Administrator Password en-
tered is stored in the PC being used. If you do not want the Administrator Password stored, clear 
the Save the administrator password check box.
7Click [Next].
%If a wrong Administrator Password is entered, a message that tells that the Administrator Password 
does not match appears. Enter the correct Administrator Password.
%If the Enhanced Security mode is set to [ON], entry of a wrong password is counted as unauthorized 
access. If a wrong Administrator Password is entered a predetermined number of times (once to 
three times) or more set by the Administrator of the machine, a message appears that tells that the 
machine accepts no more Administrator Passwords because of unauthorized access for any sub-
sequent entry of the Administrator Password. The machine is then set into an access lock state. To 
cancel the access lock state, settings must be made by the Service Engineer; or, turn off, and then 
turn on, the main power switch of the machine. If the main power switch is turned off and on, the 
access lock state is canceled after the lapse of time set for [Release Time Settings]. When the main 
power switch is turned off, then on again, wait at least 10 seconds to turn it on after turning it off. If 
there is no wait period between turning the main power switch off, then on again, the machine may 
not function properly. 
Here is the sequence, through which the main power switch and sub power switch are turned on 
and off: 
Turn off the sub power switch → Turn off the main power switch → Turn on the main power switch 
→ Turn on the sub power switch
8Check the data that has been set and click [Start].
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub 423/363/283/2234-37
4.5 HDD Backup Utility4
9Click [OK]. 
Make sure that Restore procedure has been completed and then click [Finish].
Downloaded From ManualsPrinter.com Manuals 
						

							User’s Guide  [Security Operations]
http://konicaminolta.com
Copyright
2010A1UD-9610B-00
2010. 6
Ver. 1.00
A1UD-9610B-00  BK
Downloaded From ManualsPrinter.com Manuals