LG Ld 9241wh Owners Manual

11
POWER
• For operating, press this
button first for power on.
• After operating, this
button automatically
switches off for safety and
energy saving.
• In case of irregular surge
disturbance to the
machine, the power may
be automatically turned off
for safety.
TIME LEFT
• Before starting, the display window shows the running time of
the selected program.
• After starting, the display window shows  the remaining time.
• If the dishwasher has a trouble, the trouble type is displayed.
If this error...

LD-925~ Series
FUNCTION OF CONTROL BUTTON
12
PROGRAM
• When you want to
select program, press
each button.
CHILD LOCK
• Used to lock or unlock the
control buttons to prevent
all the setting from being
changed by a child.
• This function is
automatically canceled
when power failure occur.
• For locking/ unlocking,
press Eco andQuick
button for a few seconds
simultaneously.
BEEP ON/OFF
• The dishwasher must be
switched on.
• The beep on/off function
can be set by pressing the
Ecoand Pre-wash
button...

INDICATOR
• Refill with
special salt
• Refill with
rinse aid
• Child Lock
13
TIME LEFT
• Before starting, the display window shows the running time of
the selected program.
• After starting, the display window shows  the remaining time.
• If the dishwasher has a trouble, the trouble type is displayed.
If this error letters are displayed, please refer to the trouble
shooting guide page 23 and follow the guide.
DELAY START
• If you want to delay the
start of selected program,
press this button before...

14
HOW TO USE AND OPERATE
1. Loading your Dishwasher
3. Using the Cutlery Basket
For better washing performance, always load
the dishwasher according to the instructions.
Before loading items into the dishwasher
clean off large particles of food, in particular
insoluble items such as bones, pips, etc.
When loading the dishwasher, please act
accordingly:
■Position crockery such that water will
contact all surfaces.
■Deep based items should be placed at an
angle to help water run off and dry
properly....

15
HOW TO USE AND OPERATE
4. Loading the Upper Rack
It is best to load this with more delicate
items such as, small plates, long cutlery,
cups, glasses and dishwasher safe plastic
items. Plates should be positioned upwards
with the plate bottom facing the front of the
rack. 
Cups, glasses and bowls must be positioned
upside down. 
Extra cups or cooking utensils can be laid
on the fold down cup racks, which also
provides support for long stem glasses. 
Take care not to obstruct the rotation of the
spray...

16
HOW TO USE AND OPERATE
6. Adding Detergent
Dispenser
• Detergent must be put into the detergent
chamber before starting every program
except the Pre-Wash.
• Please follow the manufacturer’s instructions
within the manual, when determining the
correct amount of detergent to use.
• If your dishes are moderately dirty, you may
use slightly less detergent than
recommended.
• Chambers hold 15g and 25g.
• The amount of detergent required depends on
the program. Please refer to the guide table.
• After the...

17
HOW TO USE AND OPERATE
7. Adding Rinse Aid
Dispenser
�For filling
To fill the Rinse Aid chamber, rotate the round
cap counter clockwise and remove. Fill the
container to the maximum level with a good
quality Rinse Aid, then replace and lock the
cap.
The Rinse Aid is automatically dispensed
during the final rinse cycle.
The dosage is factory set to suit most
installations. If, after washing, you notice
cloudy spots, streaks or water marks on your
glassware, it may be necessary to increase the
setting....

18
8. Salt Filling
• Check the water hardness of your area. (Your water supplier will be able to tell you this.)
• Set the water hardness according to the setting method of the water softener.
• Remove lower rack and unscrew the cap of salt container.
• Before using your dishwasher for the first time, fill with salt, the container has a capacity of 1.2kg.
Use a funnel for ease and clean filling, ensuring that coarse salt or regenerating salt intended for
dishwashers is used.
• After filling, wipe off any...

19
HOW TO USE AND OPERATE
When the salt container is empty, the salt refill lamp will automatically turn on during operation.
The salt should be refilled after the cycle has finished. We recommended the salt refill should
always be carried out, as mentioned previous page, prior to starting the next operation. This will
immediately thin and drain away any excess salt solution. ■For refilling
10. Energy Test(EN50242)
 Appliance loaded in accordance with
standard specifications.
• Example of loaded...

20
Press the “Power” button
Check there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is required.
Open the door and check
the filters
Ensure they are clean and properly
positioned (See “User Maintenance
Instructions”).
Load the dishes
Remove any excess food.
Pull the lower rack out and arrange the
dishes and cutlery.
Pull the upper rack out and arrange the
cups, glasses, etc.
Before starting, the display window shows
the running time of the selected program....