Miele H 5981 Bp Manual

Electrical connection - Country
variants
Please refer to your electrical
distributor.
Single phase AC 230 V - country
variant
This device is intended for connection
to a power supply system where the
maximum value of external phase
neutral loop impedance Z
maxof
0.35 Ohms at the point of distributor
supply connection is not exceeded.
If in doubt, please ask your electrical
distributor for actual Z
maxvalue. The
user has to ensure that this device is
connected only to a power supply
system which fulfils...

Dimensions are give in mm.
Appliance dimensions and unit cut-out
Installation in a base unit
HAL 5900 trim, available as an optional accessory, is only required when
building the oven into a base unit.
Fix the HAL 5900 trim into the unit cut-out under the worktop (see lower section
of diagram).
*Appliances with glass front
**Appliances with metal front
Building-in diagrams
82 

Installation in a tall unit
Building-in diagrams
83 

Front dimensions
*Appliances with glass front
**Appliances with metal front
Building-in diagrams
84 

The oven must not be operated
until it has been correctly installed in
its housing unit. Otherwise it poses
an electric shock hazard.
To ensure adequate ventilation to
the oven once installed:
– do not fit a rear panel into the
housing unit.
– make sure that the shelf on
which the appliance is placed
does not touch the wall.
– do not fit insulation material
inside the housing unit.
When installing the appliance, do
not lift it up by the door handle as
this can damage the door.Turn off the mains...

86 

87 

Alteration rights reserved / 22 / 2611
(H 5981 BP)M.-Nr. 07 649 330 / 04