Home > Mitel > Communications System > Mitel SX 200 IP NODE Instructions Guide

Mitel SX 200 IP NODE Instructions Guide

Add to Favourites
    Download as PDF

    View the Mitel SX 200 IP NODE Instructions Guide for free. All the Mitel manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 1 LAN Design Guidelines for the Implementation of SX-200 IP NODE This Technical Bulletin is intended for Customer Service and Installation personnel involved in the installation of Mitel Networks SX-200 IP NODE. Issued January, 2003 NOTICE The information contained in this document is believed to be accurate in all respects but is not warranted by Mitel Networks Corporation (Mitel). The information is subject to change without notice and should not be construed in any way as a commitment by Mitel or...
    Page 2 2 1. NETWORK GUIDELINES FOR VOICE OVER IP INSTALLATIONS .......................................................................... 3 1.1 EXECUTIVE SUMMARY............................................................................................................................................ 3 2. SUMMARY OF GUIDELINES ...................................................................................................................................... 3 3. GUIDELINES AND EXPLANATIONS...
    Page 3 3 1. Network Guidelines for Voice over IP Installations The following information is to be used in determining the suitability and requirements for a Voice over IP installation. The MITEL Networks SX-200 IP NODE will be used to illustrate some of these areas. The contents of this document should be used in assessing the capabilities of a particular network with respect to maintaining voice quality and usability of the IP-Phones and associated controllers. Networks by definition do not always follow...
    Page 4 4 • Only one LAN connection should be made from the ICP controller to the network • The IP NODE should be located behind a network Layer2 switch • Ensure that the PPS rate of the routers and switches is adequate for the amount of voice traffic expected • Wherever possible, provide the most bandwidth. Use Full duplex in preference to Half duplex. • If the network consists of multivendor units, do they all inter-work correctly? • Use MTU on routers especially for slower speed links (anything less...
    Start reading Mitel SX 200 IP NODE Instructions Guide

    Related Manuals for Mitel SX 200 IP NODE Instructions Guide

    All Mitel manuals