Panasonic Kx Dt390 Information Manual

							Document Version 2009-03
Model No. KX-DT390
Thank you for purchasing a Digital DSS Console. Please read this 
manual carefully before using this product and save this manual for 
future use. This manual is designed to be used with your Digital 
DSS Console and a Panasonic PBX.
The Digital DSS Console can be used with the following Panasonic 
Digital Proprietary Telephones (DPTs): KX-DT333, KX-DT343, and 
KX-DT346.
The Digital DSS Console must be connected directly to the main 
unit.
Accessories (included)
*1This telephone comes with the wall mounting adaptor already attached. 
To remove the adaptor, refer to step 1 on page 4.
 Telephone Line 
 
Cord: 1  Plate: 1
 Wall Mounting 
Adaptor
*1: 1
 Screws for wall: 2  Screws for plate: 4
Quick Reference Guide
Digital DSS Console
DT390M_QRG.fm  Page 1  Friday, February 27, 2009  11:02 AM 
						

							2                                                                                             Document Version 2009-03
Location of Controls
Connection
Operation Board Angle Adjustment
DSS Buttons with Busy Lamp Field (BLF):
To access an extension, simply press a DSS 
button.
These buttons also can be assigned for the 
One-touch Dialing and reassigned to other 
features.
The BLF indicates the current status of the 
corresponding extension.
CAUTION:
Ensure the cord is inserted in the grooves and the hook ( ) to prevent 
damage to the connector or the cord itself.
The angle of the operation board can be set to one of eight angles   
(level 1 = 0°, level 8 = 45°).
CAUTION:
Hold the operation board until the operation board is secured at the 
desired angle. Make sure you do not pinch your fingers when 
raising or lowering the operation board.
To raise:
Gently lift the operation board one level at a time.
39 
38 
37 
36 
35
34 
33 
32 
31
30 
29
28 
27 
26 
25 54
53
52
51
50
49
48
47
46
45
44
43
42
41
4069
68
67
66
65
64
63
62
61
60
59
58
57
56
5584 
83
82
81
80
79
78
77
76
75
74
73
72
71
70
Connect to a PBX.
The telephone line cord 
(included)
A
DT390M_QRG.fm  Page 2  Friday, February 27, 2009  11:02 AM 
						

							Document Version 2009-03                                                                                                   3
Operation Board Angle AdjustmentAttaching a DPT
To lower:
Raise the operation board to level 8. Next, with one hand on the 
base of the unit, lift the operation board again to release the latch, 
then slowly push the operation board down to level 1. If the 
operation board cannot be lowered to level 1, repeat this step.
1.Fit the protrusions on the KX-DT390 and a DPT into the 
4 holes on the plate (included).2.Attach the plate with the 4 
screws (included).
DT390M_QRG.fm  Page 3  Friday, February 27, 2009  11:02 AM 
						

							4                                                                                             Document Version 2009-03
Wall Mounting
CAUTION:
Do not mount this unit on a wall while attached to a DPT.
Doing so may damage the wall mounting adaptor or, may cause 
the unit to fall, possibly resulting personal injury. 
1.Remove the wall mounting 
adaptor from the unit as shown.
2. Set the operation board to level 
1, then connect and secure the 
telephone line cord.
3. Attach the wall mounting adaptor 
as shown.
•Make sure the cord is not pinched 
by the wall mounting adaptor. 
When running the cord from the top 
of the unit, look through the 
opening in the wall mounting 
adaptor ( A) to confirm that the 
cord is not being pinched.
4.Drive the 2 screws (included) into 
the wall either 83 mm (3-1/4 in) or 
100 mm (3-15/16 in) apart, and 
mount the unit on the wall.
• You can find a wall mounting 
template on page 8.
• Make sure that the wall that the unit 
will be attached to is strong enough 
to support the unit (approx. 1 kg 
[2.2 lb]).
• Make sure the cord is securely 
fastened to the wall.
• When this unit is no longer in use, 
make sure to detach it from the 
wall.
83 mm
(3-1/4 in)
100 mm
(3-15/16 in)
Washer
Drive the screw
to this point.
DT390M_QRG.fm  Page 4  Friday, February 27, 2009  11:02 AM 
						

							Document Version 2009-03                                                                                                   5
Important Information
When using a KX-DT390 Digital DSS Console, keep the 
following conditions in mind.
•If you are having problems making calls, unplug the extension line and 
connect a known working Digital DSS Console. If the known working DSS 
Console operates properly, have the  defective DSS Console repaired by 
an authorized Panasonic factory service center. If the known working 
DSS Console does not operate properly, check the PBX and the internal 
extension wiring.
• Wipe the unit with a soft cloth. Do not clean the unit with abrasive 
powders or with chemical agents such as benzene or thinner.
Take special care to follow the safety suggestions listed below. 
Installation
Environment
1) Do not use this unit near water, for example, near a bathtub, washbowl 
or sink. Damp basements should also be avoided.
2) Keep the unit away from heating appliances and devices that generate  electrical noise, such as fluorescent lamps, motors, and televisions. 
These noise sources can interfere with the performance of the unit. It 
also should not be placed in rooms  where the temperature is less than 
5 °C (41 °F) or greater than 40 °C (104 °F).  
Allow 10 cm (3-15/16 in) clearance around the unit for proper 
ventilation.
Placement 
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall onto, and liquids are  not spilled into, the unit. Do not subject this unit to excessive smoke, 
dust, moisture, mechanical vibrati on, shock, or direct sunlight. 
3) Place the unit on a flat surface.
WARNING:
TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT 
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
DISCONNECT THE TELEPHONE LINE  CORD FROM THIS PRODUCT IF 
THIS PRODUCT EMITS SMOKE, AN ABNORMAL SMELL OR MAKES 
UNUSUAL NOISE. THESE CONDITIONS CAN CAUSE FIRE OR 
ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND 
CONTACT AN AUTHORIZED SERVICE CENTER.
DT390M_QRG.fm  Page 5  Friday, February 27, 2009  11:02 AM 
						

							6                                                                                             Document Version 2009-03
Important Information
When you ship the product:Carefully pack and send it prepaid, adequately insured and preferably in the 
original carton. Attach a postage-paid letter, detailing the symptom to the 
outside of the carton.
DO NOT send the product to the Executive or Regional Sales offices. They 
are NOT equipped to make repairs.
Product service:Panasonic factory service centers for th is product are listed in the service 
center directory.
Consult your authorized Panasonic  dealer for detailed instructions.
Important Safety Instructions
When using this unit, basic safety precautions, including those below, 
should always be followed to reduce the ri sk of fire, electric shock and injury 
to persons.
1. Do not use the unit near water, for example, near a bathtub, wash bowl, 
kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
2. Avoid using a wired telephone during an  electrical storm. There is a 
remote risk of electric shock from lightning.
3. Do not use a telephone in the vicinity of a gas leak to report the leak.
SAVE THESE INSTRUCTION
FCC Information
F.C.C. REQUIREMENTS AND RELEVANT INFORMATIONThis equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable prot ection against harmful interference 
in a residential installation.
This equipment generates, uses, and  can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio comm unications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful  interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following 
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
DT390M_QRG.fm  Page 6  Friday, February 27, 2009  11:02 AM 
						

							Document Version 2009-03                                                                                                   7
Important Information
CAUTION:To assure continued compliance with FCC rules, do not make any 
unauthorized changes or modifications to this equipment would void the 
user’s authority to operate this device.
When programming emergency numbers and/or making test calls to 
emergency numbers:
1) Remain on the line and briefly explain to the dispatcher the reason for the call before hanging up.
2) Perform such activities in the off peak hours, such as early morning  hours or late evenings.
Customer Information
If trouble is experienced with this  equipment KX-DT390, for repair or 
warranty information, please contact:
Panasonic Service and Technology Company-BTS Center
415 Horizon Drive Bldg. 300 Ste. 350-B
Suwanee, GA 30024-3186
If the equipment is causing harm to the telephone network, the telephone 
company may request that you disconn ect the equipment until the problem 
is resolved.
DT390M_QRG.fm  Page 7  Friday, February 27, 2009  11:02 AM 
						

							PSQX4707ZA-UU (A) KK0309YH0 (M)
83 mm (3-1/4 in)   
100 mm (3-15/16 in)  
100 mm (3-15/16 in)   
83 mm (3-1/4 in)  
for DPT
for KX-DT390 DSS Console (with 60 Keys)
157 mm (6-1/5 in) 
One screw here
One screw at either point One screw at either point One screw here
WALL MOUNTING TEMPLATE1.
Drive the screws into the wall as indicated.
Note:•If the KX-DT390 is mounted beside a 
DPT, leave 157 mm (6-1/5 in) of 
space between the 2 screws for the 
DPT and the 2 screws for the KX-
DT390, as indicated above. This 
space is abbreviated in this template 
and must be measured.
2.Hook the unit onto the screw heads.
Panasonic Consumer Electronics Company,
Division of Panasonic Corporation of North 
America
One Panasonic Way Secaucus, New Jersey 07094
http://www.panasonic.com/csd
Copyright:This material is copyrighted by Panasonic 
Communications Co., Ltd., and may be reproduced for 
internal use only. All other reproduction, in whole or in 
part, is prohibited without the written consent of 
Panasonic Communications Co., Ltd.
© Panasonic Communications Co., Ltd. 2009
DT390M_QRG.fm  Page 8  Friday, February 27, 2009  11:02 AM