Singer Serger Professional 5 Manual

 
  
Two-Thread Wrapped Edge Overlock (narrow) 
 
The Two-Thread Wrapped Edge Overlock provides  an elegant fine finish to lightweight  
fabrics.  When using clear threads in c onjunction with the Two-Thread stitch, the  
fabric appears to have an invisible edge.  Th is gives a couture effect and looks  
beautiful on finer fabrics. The Two-Thread  Stitch requires the lower looper thread and 
one overlock needle thread.  The lower loop er thread wraps around the fabric’s edge. 
There are 2 different ways...

 
  
    
 
Needle
: 
 
 
ATD: 
Auto Tension Dial  
         “D” 
Left Cover Stitch 
Needle “C” Unthreaded and 
Remove Needle 
Middle Cover Stitch 
Needle “D” Unthreaded and 
Remove Needle 
Right Cover Stitch 
Needle “E” Unthreaded and 
Remove Needle 
Overedge Left  
Needle “A” Unthreaded and 
Remove Needle 
Overedge Right Needle 
(Blue) “B”      Threaded 
Upper Looper 
  Looper Engaged  
and Not Threaded  
Lower Looper 
(Red)      Threaded 
Chain Stitch Looper  
(Brown)    Not Threaded 
Upper Knife...

 
  
  3. Thread the top cover thread guide by pulling the thread towards the left until    
                it slips under the guide.  Then pull the thread along the right side of the  
       button as illustrated.  
 
 
 
 
 
 
 
  4. While holding the thread firmly,  pull the thread between the tension disks. 
 
 
  
 
 
 
 
 
 
   
  5. Turn the handwheel toward you unt il the lower looper extends 5-10mm  
       (approximately ½ inch ) from the needle plate edge.  
 
  6. Thread the looper area of...

 
 10. Thread the looper eye (A)  from front to back.  Pull about 4 inches of thread. 
                 Position thread into V cutout (B) on thr eader.  Firmly hold thread tail with left   
                  hand and pull Threader lever (C) up into place (D).  
 
 
 
 
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
  
 

 
  
  3. Thread the top cover thread guide by pulling the thread towards the left until 
       it slips under the guide.  Then pu ll the thread along the right side of the  
       button as illustrated.  
 
 
 
 
 
 
 
 
 
  4. Continue to thread point s 4-8.  Slip the thread into the rear slot of the  
      thread guide  g.  Go over the take up lever  h.  Continue by slipping the  
               thread into the right  slot of the thread guides i and  j.  
 
  
 
 
 
 
 
 
 
 
 
 
 
  
  5. Before...