Stiga PARK Silent Residence Instructions Manual

51
DEUTSCHDE
5. Bringen Sie das Fahrpedal in die Vorwärtsstel-lung, indem Sie es mit einem Holzkeil o.s.ä. 
blockieren. Siehe Abb. 22. Befüllen Sie an-
schließend den Ölbehälter mit neuem Öl.
6. Lassen Sie das Gerät eine Minute im Vorwärts- betrieb laufen.
5.7 RIEMENÜBERTRAGUNGÜberprüfen Sie nach 5 Betriebsstunden, ob sämtli-
che Riemen intakt und unbeschädigt sind.
5.8 LENKUNGDie Lenkung ist nach 5 Betriebsstunden zu kon-
trollieren/nachzustellen. Anschließend ist dies alle 
100 Betriebsstunden zu...

52
DEUTSCHDE
5.10 LUFTFILTER, MOTORDen Luftfilter alle 3 Monate oder alle 50 
Betriebsstunden reinigen, je nachdem, was zuerst 
eintrifft.
Den Papierfilter einmal pro Jahr oder alle 200 
Betriebsstunden austauschen, je nachdem, was 
zuerst eintrifft.
ACHTUNG! Wenn die Maschine unter staubigen 
Bedingungen eingesetzt wird, beide Filter häufiger 
reinigen.
1.  Den Luftfilterdeckel entfernen. Siehe Abb. 18. 
2.  Papierfilter und Vorfilter (Schaumstofffilter) demontieren. Vorsichtig arbeiten, damit kein...

53
ENGLISHEN
1 GENERAL
This symbol indicates WARNING. Seri-
ous personal injury and/or damage to 
property may result if the instructions 
are not followed carefully.
You must read these instructions for use 
and the accompanying pamphlet 
“SAFETY INSTRUCTIONS” careful-
ly, before starting up the machine.
1.1 SYMBOLSThe following symbols appear on the machine. 
They are there to remind you of the care and atten-
tion required during use and maintenance.
This is what the symbols mean:Wa r n i n g !
Read...

54
ENGLISHEN
2.4.2 Clutch-parking brake (3:B)Never press the pedal while driving. 
There is a risk of overheating in the 
power transmission. The pedal (3:B) has the follow-
ing three positions:
Released . The clutch is not ac-
tivated. The parking brake is not 
activated.
 Depressed halfway . Forward drive disengaged. 
The parking brake is not activated.
 Fully depressed . Forward drive disengaged. 
The parking brake is fully activated but not 
locked. This position is also used as emergency 
brake....

55
ENGLISHEN
Silent:1. Stop position – the engine is short-
circuited. The key can be removed.
2/3. Operating position. 
4. Start position – the electric start motor 
is activated when the key is turned to the 
spring-loaded start position. Once the en-
gine has started, let the key return to oper-
ating position 2/3.
2.4.9 Power take-off (4,5:K) The power take-off must never be 
engaged when the front-mounted 
implement is in transport position. This 
will destroy the belt transmission.
A lever for...

56
ENGLISHEN
2.4.15 Quick-release mounting (11:H)
The quick connections can be separated, 
which makes it very easy to shift between 
the different implements.
The quick connections allow the deck to 
be moved easily between the two posi-
tions:
 Normal position with fully tensioned belt.
 4 cm behind the normal position with slackened  belt so that the deck gets closer to the base ma-
chine.
As the belt idler is released from the belt, the quick 
connections simplify belt and deck replacement, 
and also...

57
ENGLISHEN
4 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is closed and 
locked. Risk of burns and crushing in-
juries.
4.1 FILLING WITH PETROLAlways use lead-free petrol. You must never use 2-
stroke petrol mixed with oil.
The tank holds 12 litres. The level can easily be 
read through the transparent tank.
NOTE! Ordinary lead-free petrol is a perishable 
and must not be stored for more than 30 days.
Environmental petrol can be used, i.e. alkylate pet-
rol. This...

58
ENGLISHEN
5.  Put the throttle control at full throttle. Starting cold engine – pull the choke control out 
fully. 
Starting warm engine – the choke control 
should be pressed in.
6.  Depress the clutch-brake pedal fully.
7.  Turn the ignition key and start the engine.
8 Once the engine has started, push the choke  control in gradually if it has been used. 
9. When starting from cold, do not make the ma- chine work under load immediately, but let the 
engine run for a few minutes first. This will al-...

59
ENGLISHEN
5 MAINTENANCE
5.1 SERVICE PROGRAMMEIn order to keep the machine in good condition as 
regards reliability and operational safety as well as 
from an environmental perspective, STIGA’s Serv-
ice programme should be followed.
The contents of this programme can be found in 
the attached service log.
Basic service
 must always be carried out by an au-
thorised workshop.
First service and intermediate service
 should be 
carried out by an authorised workshop, but can 
also be carried out by the...

60
ENGLISHEN
2. Moisten the new filter’s gasket with oil.
3. Install the filter. First screw in the filter so that the gasket comes into contact with the engine. 
Then screw in the filter a further 1/2-3/4 turn.
4. Continue with point 7 in accordance with 5.4.2  Engine Oil above.
5.5 FUEL FILTER (16:Z)Replace the fuel filter every season.
5.6 TRANSMISSION, OIL (RESIDENCE)
The oil in the hydraulic power transmission must 
be checked/adjusted and changed at the intervals 
given in the table below.
Type of...