ATT DEFINITY Communications System Generic 1, Generic 3, System Management Instructions Manual

							Index
Index
M
AMemory Card Failures, 14
Memory Cards, 1-1
Errors, 1-4
AnnouncementsFailures, 14
restore, 1-1
P
B
Backup, 1-1
for a G3s System, 1-1
G3s System, 1-1
using Memory Cards, 1-1
Backup Memory Card(s)
for a G3s System, 1-1
Backup Recorded Announcements, 1-1
Backup System, 1-1
C
Perform Backup
for a G3s System, 1-1
R
Recorded Announcements
Backup, 1-1
command, 1-1
Remove and Replace Memory Cards
for G3s System Backup, 1-1
Restore Recorded Announcements, 1-1
commands
Used to Backup Recorded Announcements, 1-1S
Used to Save Recorded Announcements, 1-1
E
Error messages, 1-4
Errors, 1-4
H
How to Backup
Recorded Announcements, 1-1
How to Restore
Announcements, 1-1
How to Save
Recorded Announcements, 1-1
Save Announcements, 1-1
Save Changes,
Additions, 1-1
Save Data in Memory, 1-1
Save Information in Memory, 1-1
Save Recorded Announcements, 1-1
Command, 1-1
Save Translation, 1-1
Automatically, 1-1
command, 1-1
in Memory, 1-1
When to, 1-1
System,
Backup, 1-1
I-1 
						

							Index
T
Time Required
to do a Backup on Recorded
Announcements, 1-1
W
When to
Save Recorded Announcements, 1-1
I-2 
						

							AT&T 555-230-500ADD2
Issue 1, January 1992
Dated March 1993
DEFINITY
®Communications System
Generic 1 and Generic 3
System Management Addendum
(G3vs Customers Only) 
						

							©1993 AT&T
All Rights Reserved
Printed in USA
Notice
While reasonable effort was made to ensure that the information in this document was
complete and accurate at the time of printing, AT&T cannot assume responsibility for any
errors. Changes and/or corrections to the information contained in this document maybe
incorporated into future issues.
Your Responsibility for Your System’s Security
You are responsible for the security of your system.AT&T does not warrant that this product
is immune from or will prevent unauthorized use of common-carrier telecommunication
services or facilities accessed through or connected to it.AT&T will not be responsible for any
charges that result from such unauthorized use. Product administration to prevent
unauthorized use is your responsibility and your system administrator should read all
documents provided with this product to fully understand the features available that may
reduce your risk of incurring charges.
Federal Communications Commission (FCC) Statement
This equipment generates, uses, and can radiate radio-frequency energy and, if not installed
and used in accordance with the instruction manual, may cause interference to radio
communications. It has been tested and found to comply with the limits for a Class A
computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference when operated in a commercial
environment.
Operation of this equipment in a residential area is likely to cause interference, in which case
the user at his/her own expense will be required to take whatever measures maybe required
to correct the interference.
TRADEMARK NOTICE
DEFINITY is a registered trademark of AT&T.
ORDERING INFORMATION
Call:
Write:
Order:
AT&T Customer Information Center
1 800 432-6600
In Canada: 1 800 255-1242
AT&T Customer Information Center
2855 North Franklin Road
P.O. Box 19901
Indianapolis, IN 46219-1385
Document No. AT&T 555-230-500ADD2
Issue 1, January 1992
Dated March 1993
Published by
GBCSystems Product Documentation Development Group
AT&T Bell Laboratories
Middletown, NJ 07748-0076 
						

							Contents
About this Documenti
n Overviewi
n Organizationii
1SYSTEM BACKUP FOR DEFINITY G3VS1-1
n Save Translation1-1
n Save and Restore Recorded Announcements1-5
n Errors1-6
IIndexI-1
i 
						

							Screens
1SYSTEM BACKUP FOR DEFINITY G3VS
1-1.Save Translation Screen-SPEA1-2
1-2.Save Announcements Screen-SPEA1-2
1-3.Save Translation Screen-SPEA1-3
1-4.
Save Announcements Screen-SPEA1-4
ii 
						

							About this Document
Overview
This addendum provides specific information for performing a System Backup for
a DEFINITY® Communications System Generic 3vs (G3vs) switch release. Its
function is as a supplement to, and is intended to be used in conjunction with, the
information already provided in DEFINITY Communications System Generic 1
and Generic 3 System Management, 555-230-500, Issue 1.
For additional information on DEFINITY Generic 3vs, refer to DEFINITY Generic
3
VS Feature Description, 555-230-201ADD4, and DEFINITY Communications
System Generic 3vs System Description, 555-230-200ADD2.
i 
						

							About this Document
Organization
In the interest of brevity, only G3VS specific information is provided in this
addendum. Refer to the appropriate section in DEFINITY Communications
System Generic 1 and Generic 3 System Management, 555-230-500,
Issue 1, when performing other administration tasks.
This document consists of the following chapters:
Introduction —Describes this document.
System Backup for DEFINITY G3VS —Describes the tasks involved in backing
up the DEFINITY G3
VS system, including translations, saving and restoring
recorded announcements, memory card backup, and memory card errors.
ii 
						

							SYSTEM BACKUP FOR
DEFINITY G3
VS
1
The backup system for the DEFINITY G3VS system employs a Memory Card.
The standard Memory Card is a 1 Mb card for systems without a TN750
announcement circuit pack. It does not have high or critical reliability. In case of
a power failure, the system translations and announcements can be restored
using the Memory Card.
Save Translation
Translation data can be automatically saved every 24 hours. However, if your
translation data changes frequently, you should also save translations frequently
to assure that you have the most up-to-date information.
Warnings:
“Save transition” should not be performed if any Memory Card alarm
conditions occur or if the system is having problems (such as processor,
memory, or netcon alarms).
It is recommended that you save translation after business hours to
prevent dial tone delays. Or, if your business operates 24 hours, you
should save translation during slow business hours.
The following procedure is used to save transitions to the Memory Card:
1. Verify that the Memory Card is in the TN777B Netcon circuit pack.
2. Log into the administration terminal.
3. Verify that the screen displays:
enter command:
1-1 
						

							SYSTEM BACKUP FOR DEFINITY G3vs
4. Enter save translation
and press [RETURN].
 This command instructs
the system to take all translation information in memory and transfer it into
the Memory Card.
5. The screen displays:
Error Code
0
save translation
SPE A
SAVE TRANSLATION
Processor
Command Completion Status
SPE_ASuccess
Command successfully completely
enter command:
Screen 1-1. Save Translation Screen—SPEA
6. Verify that the Success
message appears in the Command Completion
Status field. If it does not, an error message will appear instead.
7. If the system is equipped with a TN750 Announcement circuit pack, the
recorded announcements can be saved using the save announcements
commands. Enter
save announcements and press [RETURN].
8. The screen displays:
save announcements
SAVE
ProcessorCommand
ANNOUNCEMENTS
Completion Status
SuccessError Code0SPE_A
Command successfully completely
enter command:
Screen 1-2. Save Announcements Screen—SPEA
9. Verify that the Success message appears in the Command Completion
Status field. If it does not, an error message will appear instead.
1-2