D-Link Router DIR-810L User Manual

							57
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
DHCP \feservation
If you want a computer or device to a\fways have the same IP address assi\bned, you can create a DHCP reservation. The router 
wi\f\f assi\bn the specified IP a\uddress on\fy to that computer or device. 
Note: This IP address must be within the DHCP I\ffP Address \bange.
Check this box to enab\fe the reservation.
Enter the computer name or se\fect from the drop-down 
menu and c\fick 
						

							58
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
IPv6
On this pa\be, the user can confi\bure the IPv6 Connection type. There are two ways to set up the IPv6 Internet connection. You 
can use the Web-based IPv6 Internet Connection Setup Wizard, or you can manua\f\fy confi\bure the connection.
For be\binner users that have not confi\bured a router before, c\fick on the  IPv6 Internet 
Connection Setup Wizard. button and the router wi\f\f \buide you throu\bh a few simp\fe 
steps to \bet your network up and runnin\b.
For the advanced user that has confi\bured a router before, c\fick on the  Manual IPv6 
Internet Connection Setup button to input a\f\f the settin\u\bs manua\f\fy.
To confi\bure the IPv6 \foca\f settin\bs, c\fick on the  IPv6 Local Connectivity Setup button.
DIR-850L  
						

							59
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
IPv6 Internet Connection Setup Wizard
On this pa\be, the user can confi\bure the IPv6 Connection type usin\b the IPv6 Internet Connection Setup Wizard.
C\fick the  IPv6 Internet Connection Setup Wizard button and the router wi\f\f \buide 
you throu\bh a few simp\fe steps to \bet your network up and runnin\b.
C\fick  Next  to continue to the next pa\be. C\fick  Cancel to discard the chan\bes made 
and return to the main pa\be.
The  router  wi\f\f  try  to  detect  whether  its  possib\fe  to  obtain  the  IPv6  Internet 
connection type automatica\f\fy. If this succeeds then the user wi\f\f be \buided throu\bh 
the input of the appr\uopriate parameters for the connection type found.  
						

							60
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
However, if the automatic detection fai\fs, the user wi\f\f be prompt to either  Try again.
or to c\fick on the  Guide me through the IPv6 settings button to initiate the manua\f 
continua\f of the wizard.
There  are  severa\f  connection  types  to  choose  from.  If  you  are  unsure  of  your 
connection method, p\fease contact your IPv6 Internet Service Provider. 
Note:  If  usin\b  the  PPPoE  option,  you  wi\f\f  need  to  ensure  that  any  PPPoE  c\fient 
software on your computers has been removed or disab\fed. The 3 options avai\fab\fe 
on this pa\be are IPv6 over PPPoE, Static IPv6 address and \foute, and  Tunneling 
Connection. 
Choose  the  required  IPv6  Internet  Connection  type  and  c\fick  on  the  Next button 
to  continue.  C\fick  on  the  Prev button  to  return  to  the  previous  pa\be.  C\fick  on  the 
Cancel button to discard a\f\f the chan\bes mad\ue and return to the main pa\be.
C\fick on the Next button to continue. C\fick on the Prev button to return to the previous pa\be.
C\fick on the Cancel button to discard a\f\f the chan\bes mad\ue and return to the main pa\be.  
						

							61
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
IPv6 over PPPoE
After  se\fectin\b  the  IPv6  over  PPPoE  option,  the  user  wi\f\f  be  ab\fe  to  confi\bure  the 
IPv6  Internet  connection  that  requires  a  username  and  password  to  acess  the 
Internet. Most DSL modems use \uthis type of connection.
The fo\f\fowin\b parameters wi\f\f be avai\fab\fe for confi\buration:
PPPoE Session: Se\fect  the  PPPoE  Session  va\fue  used  here.  This 
option  wi\f\f  state  that  this  connection  shares  it’s 
information  with  the  a\fready  confi\bured  IPv6 
PPPoE  connection,  or  the  user  can  create  a  new 
PPPoE connection here.
User Name: Enter the PPPoE username used here. If you do not 
know your user name, p\fease contact your ISP.
Password: Enter the PPPoE password used here. If you do not 
know your password, p\fease contact your ISP.
\berify Password: Re-enter the PPPoE password used here.
Service Name: Enter  the  service  name  for  this  connection  here. 
This option is option\ua\f.  
						

							62
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
Static IPv6 Address Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not chan\be. The IPv6 information is manua\f\fy entered in your 
IPv6  confi\buration  settin\bs. You  must  enter  the  IPv6  Address,  Subnet  Prefix  Len\bth,  Defau\ft  Gateway,  Primary  DNS  Server,  and  Secondary  DNS 
Server. Your ISP provides you with a\f\f this information.
Use Link-Local  Address:
IPv6 Address: Subnet Prefix  Length:
Default Gateway:
Primary IPv6 DNS  Address:
Secondary IPv6 DNS  Address:
LAN IPv6 Address: The  Link-\foca\f  address  is  used  by  nodes  and  routers  when 
communicatin\b  with  nei\bhborin\b  nodes  on  the  same  \fink. 
This  mode  enab\fes  IPv6-capab\fe  devices  to  communicate 
with each other on the \uLAN side.
Enter the WAN IPv6 address for the router here.
Enter the WAN subnet prefix \fen\bth va\fue used here.
Enter the WAN defau\ft \bateway IPv6 address used here.
Enter the WAN primary DNS Server address used here.
Enter the WAN secondary DNS Server address used here.
These  are  the  settin\bs  of  the  LAN  (Loca\f  Area  Network) 
IPv6  interface  for  the  router. The  router’s  LAN  IPv6  Address 
confi\buration  is  based  on  the  IPv6  Address  and  Subnet 
assi\bned by your ISP. (A subnet with prefix /64 is supported 
in LAN.)  
						

							63
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
6rd IPv6 Prefix: Enter the 6rd IPv6 address and prefix va\fue used 
here.
IPv4 Address: Enter the IPv4 address used here.
Mask Length: Enter the IPv4 mask \fen\bth used h\uere.
Assigned IPv6  Prefix:Disp\fays the IPv6 assi\bned prefix va\fue here.
6rd Border \felay  IPv4 Address: Enter the 6rd border re\fay IPv4 address used here.
IPv6 DNS Server: Enter the primary DNS Server address used here.
The IPv6 Internet Connection Setup Wizard is comp\fete. 
C\fick on the Connect button to continue. C\fick on the  Prev button to return to 
the previous pa\be. C\fick on the  Cance\b button to discard a\f\f the chan\bes made 
and return to the main pa\be.
Tunneling Connection (6rd)
After se\fectin\b the Tunne\fin\b Connection (6rd) option, the user \ucan confi\bure the IPv6 6rd connection settin\bs.
The fo\f\fowin\b parameters wi\f\f be avai\fab\fe for confi\buration:  
						

							64
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
IPv6 Local Connectivity Settings
Enable ULA:
Use Default  ULA Prefix:
ULA Prefix:
Current IPv6 
ULA Settings: C\fick here to enab\fe\u Unique Loca\f IPv6 \u
Unicast Addresses s\uettin\bs.
Checkin\b this box wi\f\f\u automatica\f\fy confi\bur\ue 
the ULA prefix for th\ue defau\ft settin\b.
If you wish to choose\u your own ULA prefix,\u enter it here.
This section with dis\up\fay the current 
settin\bs for your IP\uv6 ULA.
This  option  can  be  used  to  manua\f\fy  confi\bure  IPv6  settin\bs  for  \foca\f 
connectivity. These settin\bs are used on\fy on the \foca\f network, and wi\f\f 
not be used to access the internet.  
						

							65
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
IPv6 Manual Setup
There are severa\f connection types to choose from: Auto Detection, Static IPv6, Autoconfi\buration (SLAAC/DHCPv6), PPPoE, 
IPv6 in IPv4 Tunne\f, 6to4, 6rd, and Link-\foca\f. If you are unsure of your connection method, p\fease contact your IPv6 Internet 
Service Provider. 
Note:  If usin\b the PPPoE option, you wi\f\f need to ensure that any PPPoE c\fient software on your computers has been removed 
or disab\fed.
Auto Detection
Se\fect  Auto.Detection   to  have  the  router  detect  and  automatica\f\fy 
confi\bure your IPv6 settin\b from your ISP.  
						

							66
D-Link DIR-810L User Manua\f
Section 3 - Confi\buration
Static IPv6
Se\fect Static.IPv6 from the drop-down menu.
Enter the address settin\bs supp\fied by your Internet provider 
(ISP). 
Enter the LAN (\foca\f) I\uPv6 address for the router. 
Disp\fays the Router’s LAN Link-Loca\f Address.
Check to enab\fe the Autoconfi\buration feature.
Se\fect  Statefu\b .(DHCPv6) , SLAAC .+ .RDNSS   or SLAAC .+.
State\bess.DHCPv6. 
Enter the start IPv6 Address for the DHCPv6 ran\be for your 
\foca\f computers.
Enter  the  end  IPv6  Address  for  the  DHCPv6  ran\be  for  your 
\foca\f computers.
Enter the IPv6 Address Lifetime (in minutes).
My IPv6 Connection:
WAN IPv6 Address  Settings:
LAN IPv6 Address:
LAN Link-Local Address: Enable 
Autoconfiguration:
Autoconfiguration Type:
IPv6 Address \fange  Start:
IPv6 Address \fange  End:
IPv6 Address Lifetime: