Panasonic Digital Disk Recorder Wj Hd616 Wj Hd716 Installation Guide

							151
SymptomCheck	item/RemedyRef. Page
Cannot connect via a net-
work.
	 •	 Are	the	network	settings	of	the	recorder	and	the	PC	configured	 correctly? 
Check the settings. Operating 
Instructions  (PDF)
	 •	 Is	the	host	registration	configured	correctly?  When "On" is selected for "Host authentication", it is impossi-
ble to access the recorder from PCs that are not registered as 
hosts on the setup menu. 106
Some pop-ups cannot be 
displayed.
	 •	 It	may	be	possible	that	pop-up	blocker	is	activated	by	a	pro- gram other than Internet Explorer.
    Check the installation status to cancel the pop-up blocker. –
Cannot access from the web 
browser.
	 •	 Is	the	Ethernet	cable	firmly	connected	to	the	10/100BASE-T	 port? 
Confirm the cable is firmly connected. –
	 •	 Is	the	connection	indicator	of	the	10BASE-T/-100BASE-TX	
port lit? 
When it is not lit, connection to a LAN is not established or a 
network is not working correctly. 
Confirm that the connection indicator of the 10/100BASE-T 
port is lit. 
Refer to the system administrator if it is not lit. –
	 •	 Is	the	valid	IP	address	set? 
Refer to a system administrator for further information. 100
	 •	 Are	you	accessing	the	wrong	IP	address? 
Check the connection as follows: 
>ping "IP address of this recorder" 
If there is a reply from the recorder, the connection is normal. If 
not, check the settings of the IP address and the subnet mask. –
	 •	 Is	the	same	IP	address	provided	to	other	devices? 
Refer to a system administrator for further information. 100
	 •	 Are	there	contradictions	between	the	address	and	the	network	
subnet to be accessed? 
When the recorder and the client (PC) are on the same subnet, 
is the same subnet set for the IP addresses of the recorder 
and the PC? 
Or is "Use Proxy Server" for the settings of the web browser 
checked? 
When accessing this recorder in the same subnet, entering the 
address of this recorder in the "Don’t Use Proxy For These 
Addresses" box is recommended. 100
Cannot	copy	onto	the	SDHC/
SD memory card. 
Cannot search and play from 
the	SDHC/SD	memory	card.
	 •	 Is	the	recommended	SDHC/SD	memory	card	used?
	 •	 Depending	on	the	model	or	the	manufacturer,	it	may	be	possi- ble that the SDHC/SD memory card in use will not work with 
this product. Use a recommended SDHC/SD memory card.
	 •	 Is	the	SD	memory	card	formatted?
	 •	 Are	data	copied	to	the	SD	memory	card	properly? – 
						

							152
SymptomCheck item/RemedyRef. Page
When displaying images on 
a multi-screen, images from 
two cameras or more are 
displayed in sequence on a 
screen of multi-screen.
	 •	 This	may	occur	due	to	the	display	adapter	and	driver	combina- tion. 
When	this	occurred,	update	the	driver	of	the	display	adapter	to	
the	latest	version	first. 
If	updating	the	driver	does	not	solve	the	problem,	adjust	the	
hardware	acceleration	as	follows. 
The	following	are	descriptions	when	using	Windows	XP.
	 1.	 After	closing	all	web	browser	windows,	right-click	on	the	 desktop	and	select	"Properties"	from	the	displayed	pop-up	
menu.
	 2.	 Select	"Settings"	from	"Display	Properties",	and	then	click	 the	[Advanced]	button.
	 3.	 Click	the	[Troubleshoot]	tab	and	disable	the	DirectDraw	 acceleration	by	adjusting	the	level	of	"Hardware	accelera-
tion".
Check the power cord, connector and plug periodically.
Symptom Check item/RemedyRef. Page
The power cord insulation is 
damaged.
	 •	 The	power	cord,	plug	and	connectors	are	worn	out.  This	may	result	in	electric	shock	or	a	fire. 
Unplug	the	power	plug	from	the	AC	outlet	immediately,	and	
refer	to	qualified	service	personnel.
–
The power cord, plug and 
connectors get hot during 
use.
The power cord gets hot 
when bent or stretched. 
						

							153
Specifications
•	General
Power source: 120 V AC, 60 Hz
Power consumption:  130 W
Ambient operating temperature:  +5 °C to +45 °C {+41 °F to +113 °F}
Ambient operating humidity:  5 % to 90 % (non condensing)
  When installing WJ-HDB611: 10 % to 80 % (non condensing)
Maximum operating altitude:  2 000 m {6 562 feet} or less
Dimensions (excluding rubber 
   feet and projections)  430 mm (W) x 132 mm (H) x 400 mm (D) {16-15/16"" (W) x 5-3/16" (\
H) x 15-3/4" (D)}
Weight:  When no hard disk drive is installed: 14 kg {30.91 lbs.}
  When 4 hard disk drives are installed: 17 kg {37.53 lbs.}
Finish:  Front cover: Solid metallic coating
  Top cover: Solid metallic coating
  Rear panel: Galvanized steel
•	HDD	(Locally	procured	-	Contact	your	dealer	about	purchasing	hard	disk	drives.)
Hard disk drive: 3.5" hard disk drive (Up to 4 hard disk drives can be installed.)
•	Input/output
Video
 Video input connector:  1 V [p-p]/75 Ω, x16 (1ch to 16ch) (BNC)
    Vertical timing pulse multiplexed, HD616K: x8 (1ch to 8ch), HD716K: x16\
  Cascade input connector:  1 V [p-p]/75 Ω (BNC)
    HDMI, x2
  Video output connector:  1 V [p-p]/75 Ω, active loop-thru output, x16 (1ch to 16ch) (BNC)*\
1
 Monitor output connector:  1 V [p-p]/75 Ω, x2 (BNC)
  Monitor (HDMI) connector:  HDMI, x2*8
 Video output connector (front):  1 V [p-p]/75 Ω, x1 (RCA pin)
Audio
  Audio input connector:  –10 dBv, 10 kΩ, unbalanced, x4 (RCA pin)
  Cascade input connector:  –10 dBv, 10 kΩ, unbalanced x 1 (RCA pin)
  Audio output connector:  –10 dBv, 600 Ω, unbalanced, x1 (RCA pin)
  Audio output connector (front):  –10 dBv, 600 Ω, unbalanced, x1 (RCA pin)
Others
  External storage connector:  x3
  Mouse connection port:  x1
  Alarm/control terminal:    8 to 16ch alarm output*
3, alarm reset input*2, emergency recording input*2, available 
space warning output*3, HDD trouble output*3, camera trouble output*3, trouble out-
put*3, electricity failure recovery completion output*4, time adjust input/output*5, 
sequence switching input/output*5, alarm suspension input*2, electricity failure detec-
tion input*2, external recording mode switching*2, +5 V output*6 (25-pin D-sub)
  Alarm terminal:    1ch - 16ch alarm input*2, 1 - 7ch alarm output*3 (25-pin D-sub)
  RS485 port:  RS485 (full duplex/half duplex*7), x2 (RJ-11)
  DATA port:  RS485, x2 (RJ-11)
  Network port:  10BASE-T/100BASE-TX (RJ-45)
  Maintenance port:  10BASE-T (RJ-45)
  SDHC/SD memory card slot:    SDHC/SD memory cards applicable (miniSD cards and microSD cards not applica-
ble)
  *1  When power is not supplied, the video output signal was not sent from the recorder even if a video input signal is supplied. 
  *2  Non-voltage make contact input, 50 kΩ +5 V DC pull-up 
						

							154
Standard accessories
Optional Accessories
CD-ROM*1  ........................................................................\
  1 pc.
Installation Guide (this document)   .....................................  1 pc.
Quick Reference Guide   .....................................................  1 pc.
Warranty   ........................................................................\
...  1 pc.
The following are for installation.
Power cord   .......................................................................  1 pc.
Rack mount bracket   .........................................................  2 pcs.
Screw for rack mount bracket   ..........................................  6 pcs.
Rack handle   .....................................................................  2 pcs.
Screw for rack handle   .......................................................  4 pcs.
Washer   ........................................................................\
.....  4 pcs.
HDD fixing screw for HDD canister   ...................................  24 pcs.
  *1  The CD-ROM contains the operating instructions (PDFs) and other manual\
s.
    
Built-In DVD  WJ-HDB611
RAID Board  WJ-HDB601
Extension unit  WJ-HDE400
HDD canister  WJ-HDU40K
SDHC/SD memory card    Manufactured by Panasonic
  SDHC memory card: 4 GB, 8 GB, 16 GB, 32 GB
  SD memory card: 256 GB, 512 GB, 1 GB, 2 GB
 
*3  Open Collector output, 24 V DC, –100 mA maximum
  *4  High (+12 V, 12 mA)
  *5  Either of *2 or *3 above (depending on the settings)
  *6  200 mA maximum
  *7  Changeable with the mode switch
  *8  No audio from MONITOR OUT 1
     
						

							155 
						

							Panasonic System Solutions Company,
Unit Company of Panasonic Corporation of North America
www.panasonic.com/business/
For customer support, call 1.800.528.6747
Three Panasonic Way 2H-2, Secaucus, New Jersey 07094
Panasonic Canada Inc.5770 Ambler Drive, Mississauga, Ontario, L4W 2T3 Canada 
(905)624-5010
http://www.panasonic.ca
Panasonic Sales CompanyPanasonic Puerto Rico, Inc.
AVE 65de Inf, Km 9.5 Carolina, PR 00985
(787)750-4300
© Panasonic Corporation 2009  Ns0509-1089       3TR005668BZA       Printed in China