Samsung C460 User Guide

							Understanding display messages
1114. Troubleshooting
11 
Misc. messages
MessageMeaningSuggested solutions
Adjusting Color
RegistrationThe machine is adjusting the 
color registration.
Wait a few minutes.
Calibrating
image density…The machine is calibrating 
the image density. 
Wait a few minutes.
Door Open
Close itThe cover is not securely 
latched.
Close the cover until it 
locks into place. 
Scan Unit Open
or Exit JAMThe scan unit is
 not securely 
latched or paper has 
jammed in the scanner area. • Clear the jam (see 
"Clearing original 
document jams" on 
page 96).
• Close the cover until it  locks into place. 
Door of scanner is 
open. The cover of scanner is not 
securely latched. Close the cover until it 
locks into place. 
Error
 [error number]
Install  [color] toner The indicated toner 
cartridge is installed 
improperly, or the connector 
is polluted. Reinstall the Samsung-
genuine toner cartridge 
two or three times to 
confirm it is seated 
properly. Or clean the 
connector. If the problem 
persists, contact the 
service representatives.
Error [error number]
Turn off then on
The machine unit cannot be 
controlled.
Reboot the power and try 
the printing job again. If 
the problem persists, 
please call for service. 
Error [error number]
Call for service
Scanner Locked
The scanner is locked. Reboot the power. If the 
problem persists, please 
call for service.
Install TR.
belt unit.The transfer belt is not 
installed.
Install a Samsung-
genuine transfer belt.
Not compatible
transfer beltThe transfer belt of the 
machine is not for your 
machine. Install the a Samsung-
genuine part designed 
for your machine.
Not installed
Waste tank
The waste toner container is 
not installed.
Install a Samsung-
genuine waste toner 
container.
MessageMeaningSuggested solutions 
						

							Understanding display messages
1124. Troubleshooting
Check Fax LineThe fax line is not properly 
connected to the LINE port. Connect the fax line to 
the LINE port not to the 
EXT port (see "Rear view" 
on page 22).
Not proper room
temp. Move setThe machine is in a room 
with improper room 
temperature.  Move the machine to a 
room with proper room 
temperature.
Output bin Full
Remove paper
The output tray is full. Or the 
sensor is not facing down.
Remove papers from the 
output tray, the machine 
resumes printing. Or 
make sure the sensor is 
facing down. If the 
problem persists, call for 
service.
Prepare new
Transfer beltThe life of the transfer belt 
will expired soon.
Replace the transfer belt 
with a new one. Contact 
the service 
representatives.
Replace new
Transfer beltThe life of the transfer belt 
has expired.
Replace the transfer belt 
with a new one. Contact 
the service 
representatives.
Transfer Belt Error
The transfer belt cannot be 
controlled. Reboot the power and try 
the printing job again. If 
the problem persists, 
please call for service.
MessageMeaningSuggested solutions
Prepare new
Transfer rollerThe life of the transfer belt 
will expired soon.
Replace the transfer belt 
with a new one. Contact 
the service 
representatives.
Replace new
Transfer rollerThe life of the transfer belt 
has expired.
Replace the transfer belt 
with a new one. Contact 
the service 
representatives.
Replace 
Fuser SoonThe life of the fuser unit will 
be expired soon.
Replace the fuser unit 
with a new one. Contact 
the service 
representatives.
Replace new
Fuser unitThe life of the fuser unit will 
be expired.
Replace/Install 
Waste Toner Tank
The life span of the waste 
toner container has expired 
and the printer will stop 
printing until a new waste 
toner container is placed 
into the printer. Replace a waste toner 
container with a 
Samsung-genuine waste 
toner container.
MessageMeaningSuggested solutions 
						

							Understanding display messages
1134. Troubleshooting
Prepare new
Imaging unitThe life of the imaging unit 
will be expired soon.
Replace the imagingunit 
with a new one. Contact 
the service 
representatives.
Replace with
new imaging unitThe life of the imaging unit 
will be expired.
Install
imaging unitThe imaging unit is not 
installed
Error
 [error number]
Door open/close The imaging unit is installed 
improperly, or the cover is 
not securely latched. Reinstall the imaging unit 
to confirm it is seated 
properly. Close the cover 
until it locks into place.
MessageMeaningSuggested solutions 
						

							5. Appendix
This chapter provides product specifications and information concerning applicable regulations.
• Specifications 115
• Regulatory information 124
• Copyright 137 
						

							1155. Appendix
Specifications
1 
General specifications
 
The specification values listed below are subject to change without notice. See  www.samsung.com for possible changes in information.
 
 
ItemsDescription
DimensionWidth x Length x Height C46xW 406 x 362 x 288.6 mm (16 x 14.3 x 11.4 inches) 
C46xFW 406 x 362 x 333.5 mm (16 x 14.3 x 13.1 inches) 
WeightMachine with consumablesC46xW 12.80 Kg (28.22 lbs)
C46xFW 13.96 Kg (30.78 lbs)
Noise LevelabReady modebackground noise level
Print modeColor printing Less than 46 dB (A)
Black and white printing Less than 48 dB (A)
Copy modeScanner glass Less than 52 dB (A)
Document feeder Less than 53 dB (A)
Scan modeScanner glass Less than 51 dB (A)
Document feeder Less than 51 dB (A)
TemperatureOperation10 to 30°C (50 to 86°F)
Storage (packed)-20 to 40°C (-4 to 104°F) 
						

							Specifications
1165. Appendix
 
HumidityOperation20 to 80% RH
Storage (packed)10 to 90% RH
Power ratingc110 volt modelsAC 110 - 127 V
220 volt modelsAC 220 - 240 V
Power consumption dAverage operating modeLess than 290 W
Ready modeLess than 60 W
Power save mode 
•C46xW: Less than 1.7 W  (Wi-Fi Direct on: Less than 2.5 W)
• C46xFW:  Less than 2.1 W (Wi-Fi Direct on: Less than 2.9 W)
Power off mode eLess than 0.45 W
Network Standby Mode (All 
Port Activation) •
C46xW: Less than 2.48 W
• C46xFW:  Less than 2.55 W
WirelessfModule SPW-B4319S
a. Sound Pressure Level, ISO 7779. Conf iguration tested: basic machine installation, A4 paper, simplex printing.
b. China only: If the equipment's noise is louder than 63 db (A),  the equipment should be placed in region of relatively indepen dent advice.
c. See the rating label on the machine for the correct voltage (V), frequency (hertz) and of current (A) for your machine.
d. The power consumption may be a ffected by the machine’s status, setting condit ions, operating environment, and measuring equipment and method the country uses.
e. Power consumption can be completely avoided only when the power cable is not connected.
f. Wireless models only (see "Fea tures by model" on page 7).
ItemsDescription 
						

							Specifications
1175. Appendix
2 
Print media specifications 
 
TypeSizeDimensions
Print media weight/Capacitya
Tray
Plain paper Letter
216 x 279 mm (8.5 x 11 inches)
60 to 85 g/m
2 (16 to 23 lbs bond) 
• 150 sheets of 75 g/m
2 (20 lbs bond)
Legal
216 x 356 mm (8.5 x 14 inches)
US Folio 216 x 330 mm (8.5 x 13 inches)
A4 210 x 297 mm (8.27 x 11.69 inches)
Oficio 216 x 343 mm (8.5 x 13.5 inches)
JIS B5 182 x 257 mm (7.17 x 10.12 inches)
ISO B5 176 x 250 mm (6.93 x 9.84 inches) 
Executive 184 x 267 mm (7.25 x 10.5 inches)
A5 148 x 210 mm (5.83 x 8.27 inches)
A6 105 x 148 mm (4.13 x 5.83 inches)
Thick paper Refer to the Plain 
paper section  Refer to the Plain paper section 
86 to 120 g/m
2 (23 to 32 lbs bond)
• 5 sheets
Thin paper Refer to the Plain 
paper section  Refer to the Plain paper section 
60 to 70 g/m
2 (16 to 19 lbs bond)
• 150 sheets of 60 g/m
2 (16 lbs bond) 
						

							Specifications
1185. Appendix
CottonRefer to the Plain 
paper section  Refer to the Plain paper section 
75 to 90 g/m
2 (20 to 24 lbs bond)
• 150 sheets of 75 g/m
2 (20 lbs bond)
Colored, 
Pre-printed, 
Recycled Refer to the Plain 
paper section  Refer to the Plain paper section 
60 to 85 g/m
2 (16 to 24 lbs bond)
• 150 sheets of 75 g/m
2 (20 lbs bond)
Labels
b
Letter, Legal, Oficio, 
US Folio, A4, JIS B5, ISO 
B5, Executive, A5 Refer to the Plain paper section
120 to 150 g/m2 (32 to 40 lbs bond)
• 5 sheets 
Card stock Letter, Legal, Oficio, 
US Folio, A4, JIS B5, ISO 
B5, Executive, A5,
Postcard 4x6 Refer to the Plain paper section
121 to 163 g/m
2 (32 to 43 lbs bond)
• 5 sheets
Bond paper Refer to the Plain 
paper section  Refer to the Plain paper section 
105 to 120 g/m
2 (28 to 32 lbs bond)
• 10 sheets
Archive Refer to the Plain 
paper section  Refer to the Plain paper section 
70 to 90 g/m
2 (18.6 to 24 lbs bond)
• 100 sheets
Glossy Photo, 
Matte Photo Letter, A4,
Postcard 4x6 Refer to the Plain paper section
111 to 220 g/m
2 (30 to 58 lbs bond)
• 1 sheets
TypeSizeDimensions
Print media weight/Capacitya
Tray 
						

							Specifications
1195. Appendix
  
If media weight is over 120 g/m2 (32 lbs bond), load a paper into the tray one by one.
 
Minimum size (custom)76 x 152 mm (3 x 6 inches)
60 to 120 g/m2 (16 to 32 lbs bond)
Maximum size (custom) 216 x 356 mm (8.5 x 14 inches)
a. Maximum capacity may differ depending on media weight, thickness, and environmental conditions. 
b. The smoothness of the labels used in this machine is 100 to 250 (sheffield). This means the numeric level of smoothness.
TypeSizeDimensions
Print media weight/Capacitya
Tray 
						

							Specifications
1205. Appendix
3 
System requirements
Microsoft® Windows®
 
 
Operating system
Requirement (recommended)
CPURAMfree HDD space
Windows® XPIntel® Pentium® III 933 MHz (Pentium IV 1 GHz) 128 MB (256 MB) 1.5 GB
Windows Server® 2003
Intel® Pentium® III 933 MHz (Pentium IV 1 GHz) 128 MB (512 MB) 1.25 GB to 2 GB
Windows Server® 2008
Intel® Pentium® IV 1 GHz (Pentium IV 2 GHz) 512 MB (2 GB) 10 GB
Windows Vista®Intel® Pentium® IV 3 GHz512 MB (1 GB) 15 GB
Windows® 7
Intel® Pentium® IV 1 GHz 32-bit or 64-bit processor or higher 1 GB (2 GB) 16 GB
• Support for DirectX
® 9 graphics with 128 MB memory (to enable the Aero theme).
•DVD-R/W Drive
Windows Server® 2008 R2 Intel® Pentium® IV 1 GHz (x86) or 1.4 GHz (x64)  processors (2 GHz or faster) 512 MB (2 GB) 10 GB
Windows® 8
Intel® Pentium® IV 1 GHz 32-bit or 64-bit processor or higher 1 GB (2 GB) 16 GB
• Support for DirectX
® 9 graphics with 128 MB memory (to enable the Aero theme).
•DVD-R/W Drive