Tone Commander 30e120 Installation Instructions

CONNECTOR #5 CONNECTOR #6
PIN NO.
WIRE COLORDESIGNATION(left)DESIGNATION(right)
26·······WHT-BLU·······T61 ··········T76
1·······BLU-WHT·······R61 ··········R76
27·······WHT-ORN·······T62 ··········T77
2·······ORN-WHT·······R62 ··········R77
28·······WHT-GRN·······T63 ··········T78
3·······GRN-WHT·······R63 ··········R78
29·······WHT-BRN·······T64 ··········T79
4·······BRN-WHT·······R64 ··········R79
30·······WHT-SLT·······T65 ··········T80
5·······SLT-WHT·······R65 ··········R80...

CONNECTOR #7 CONNECTOR #8
PIN NO.
WIRE COLORDESIGNATION(left)DESIGNATION(right)
26·······WHT-BLU·······T91 ··········T106
1·······BLU-WHT·······R91 ··········R106
27·······WHT-ORN·······T92 ··········T107
2·······ORN-WHT·······R92 ··········R107
28·······WHT-GRN·······T93 ··········T108
3·······GRN-WHT·······R93 ··········R108
29·······WHT-BRN·······T94 ··········T109
4·······BRN-WHT·······R94 ··········R109
30·······WHT-SLT·······T95 ··········T110
5·······SLT-WHT·······R95 ··········R110...

Data Link Cable
1. Plug the supplied data link cable to the 30e port on the 120 CPU.
2. Plug the other end of the cable to the lower 120 port on the 30e CPU.
3. Route the cable through the slots at the bottom of the CPU housings.
4.Excess cable must be stored in the 120 CPU as shown to assure FCC Part 15 compliance.
Secure with a cable tie.
5. If this installation has two 120 CPUs (121-240 stations), connect the second 120 CPU to the upper
120 port on the 30e CPU.
Page 2413-102499 Rev. G
Tone Commander...

Reference Grounding
1. Connect telco or PABX ground to the GRD pin on the bottom of 30e block #2.
2. For each 120 CPU, connect telco or PABX ground to the GRD pin on the bottom right of 120 block #1.
These connections may be daisy chained as shown.
DO NOT connect this reference ground to the metal housing of any CPU or power supply!
CPU Chassis Grounding
This ground connection is required for safety and EMI shielding. It is usually provided by the 3rd wire on
the CPU power cords. If the integrity of the...

Connections to Telco/PABX Lines
Line Testing
Connect a test telephone to each line; verify the presence of dial tone, and break dial tone by dialing a
number.
The 30e allows DTMF tone dialing only – refer to the SYSTEM DESCRIPTION - Telco/PABX Requirements
section.
Test any additional features ordered with the lines. Open circuit voltage must be approximately 48 volts.
Station Connections
Page 2613-102499 Rev. G
Tone Commander 30e120 Installation Instructions
1. Connect Tip and Ring of each line to the...

Console Cable Installation
30e Console Cables
Console Positions #1 and #2
Wall
Jack
PinoutWall Jack
Typical
Wire ColorConsole #1
Designation
(connector 1)Console #2
Designation
(connector 1)Typical 3 Pair
Console Cable
Wire Color(actual
wire color)
1 WHT 1C3 (WHT-GRN) 2C3 (RED-BLU) WHT-GRN
2 BLK 1C1 (WHT-ORN) 2C1 (WHT-SLT) WHT-ORN
3 RED 1RN (BLU-WHT) 2RN (BRN-WHT) BLU-WHT
4 GRN 1TN (WHT-BLU) 2TN (WHT-BRN) WHT-BLU
5 YEL 1C2 (ORN-WHT) 2C2 (SLT-WHT) ORN-WHT
6 BLU 1C4 (GRN-WHT) 2C4 (BLU-RED) GRN-WHT
Table 8–...

Wall
Jack
PinoutWall Jack
Typical
Wire ColorConsole #1
DesignationConsole #2
DesignationTypical 3 Pair
Console Cable
Wire Color(actual
wire color)
1 WHT 1C+ (YEL-BLU) 2C+ (YEL-SLT) WHT-GRN
2 BLK 1C+ (BLK-SLT) 2C+ (YEL-BRN) WHT-ORN
3 RED 1C- (BRN-BLK) 2C- (GRN-YEL) BLU-WHT
4 GRN 1C+ (BLK-BRN) 2C+ (YEL-GRN) WHT-BLU
5 YEL 1C- (SLY-BLK) 2C- (BRN-YEL) ORN-WHT
6 BLU 1C- (BLU-YEL) 2C- (SLT-YEL) GRN-WHT
Table 9 –30e Console “Power” Jack Pinout, Console Positions #1 and #2
All 30e console cables from positions #1...

Console Positions #3 and #4
Wall
Jack
PinoutWall Jack
Typical
Wire ColorConsole #3
DesignationConsole #4
DesignationTypical 3 Pair
Console Cable
Wire Color(actual
wire color)
1 WHT 3C3 (RED-BRN) 4C3 (BLK-ORN) WHT-GRN
2 BLK 3C1 (RED-GRN) 4C1 (BLK-BLU) WHT-ORN
3 RED 3RN (ORN-RED) 4RN (SLT-RED) BLU-WHT
4 GRN 3TN (RED-ORN) 4TN (RED-SLT) WHT-BLU
5 YEL 3C2 (GRN-RED) 4C2 (BLU-BLK) ORN-WHT
6 BLU 3C4 (BRN-RED) 4C4 (ORN-BLK) GRN-WHT
Table 10 –30e Console “Voice/Data” Jack Pinout, Console Positions #3 and #4
Wall...

120 Console Cables
Console Positions #1 and #2
Wall
Jack
PinoutWall Jack
Typical
Wire ColorConsole #1
Designation
(connector 1)Console #2
Designation
(connector 1)Typical 3 Pair
Console Cable
Wire Color(actual
wire color)
1 WHT 1C+ (YEL-BRN) 2C+ (VIO-GRN) WHT-GRN
2 BLK 1C+ (YEL-GRN) 2C+ (VIO-ORN) WHT-ORN
3 RED 1C- (ORN-YEL) 2C- (BLU-VIO) BLU-WHT
4 GRN 1C+ (YEL-ORN) 2C+ (VIO-BLU) WHT-BLU
5 YEL 1C- (GRN-YEL) 2C- (ORN-VIO) ORN-WHT
6 BLU 1C- (BRN-YEL) 2C- (GRN-VIO) GRN-WHT
Table 12–120 Console “Power” Jack...