Yamaha As201 Manual

17 En
FM/AM TUNING
BASIC 
OPERATION
English
5Press ENTER again to confirm.
“CLEARED” is displayed on the front panel display. 
Then, another preset station is shown on the front 
panel display. When there is no more preset station, 
“NO PRESET” is displayed, and then the display 
returns to the Option menu.
To return the display to the original state, press 
MENU.
■ Clearing all preset stations
Follow the steps below to clear all preset stations.
1Press FM/AM to select TUNER as the input 
source.
2Press...

18 En
FM/AM TUNING
Radio Data System is a data transmission system used by 
FM stations in many countries. 
1Press FM to select TUNER as the input 
source.
2Tune in to the desired Radio Data System 
broadcasting station.
3Press INFO repeatedly to select the desired 
Radio Data System display mode.When you select Program Type, the following program 
types can be displayed.
Receiving Radio Data System 
information 
(Only for Europe model)
ChoiceDescription
Frequency
This unit displays the 
frequency of the...

19 En
ADVANCED 
OPERATION
English
ADVANCED OPERATION
The Option menu allows you to configure various settings for each input source and recall those settings automatically 
when an input source is selected.
1Press one of the Input selector buttons to 
select the desired input source.
2Press MENU.
3Press B  / C to select the desired menu item, 
and then press ENTER.
4Press B  / C to change the settings.
y
• For certain menu items, you must press ENTER to save  the new setting.
• To return to the screen...

20 En
ADDITIONAL INFORMATION
Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or 
if the instructions below do not help, set this unit to standby mode, disconnect the power cable, and then contact the 
nearest authorized Yamaha dealer or service center.
■General
TROUBLESHOOTING
Problem Cause RemedySee 
page
This unit fails to turn 
on. The power cable is not connected or the 
plug is not completely inserted. Connect the power cable...

21 En
TROUBLESHOOTING
ADDITIONAL 
INFORMATION
English
The sound is 
degraded when 
listening with 
headphones 
connected to a CD 
player connected to 
this unit. This unit has been set to standby mode. Turn on the power of this unit.
12
The remote control 
does not work nor 
function properly.
Wrong distance or angle. The remote control will function within a maximum 
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.8
Direct sunlight or lighting (from an 
inverter type of...

22 En
TROUBLESHOOTING
■Tuner
Problem Cause RemedySee 
page
FM FM stereo 
reception is 
noisy.
The particular characteristics of the FM 
stereo broadcasts being received may 
cause this problem when the transmitter is 
too far away or the antenna input is poor. Check the antenna connections.
Try using a high-quality directional FM antenna.
11
Switch to monaural mode.14
There is 
distortion, and 
clear reception 
cannot be 
obtained even 
with a good FM 
antenna.There is multipath interference. Adjust the...

23 En
ADDITIONAL 
INFORMATION
English
AUDIO SECTION• Minimum RMS output power (8 Ω, 40 Hz to 20 kHz, 0.2% THD) 
[North America, General, Australia and Europe models]  ...........................................................................  100 W + 100 W
[Asia model]  .........................................................  85 W + 85 W
• Input sensitivity/Input impedance (1 kHz, 100 W/8 Ω)
CD, etc.  .................................................................  500 mV/47 kΩ
• Output level/Output...

Printed in Malaysia ZH10630© 2013 Yamaha Corporation