Kyocera KM 1635 User Manual

							Troubleshooting 
OPERATION GUIDE9-11
2Check to see that the paper 
misfeed indicator lamp has gone 
out and then set the MP Tray 
paper again.
IMPORTANT: Paper misfeed in the MP Tray (except J10)
In the case where “J20 is displayed, refer to Paper misfeed in the Left 
Cover internal section and remove the paper.
In the case where “J40 is displayed, refer to Paper misfeed in the Left 
Cover internal section and remove the paper.
When removing jammed paper, do not pull it out from the MP tray side.
Paper misfeed in the Left Cover internal section 
(J20, J30, J40 to 45, J50, 
J52 to 56, J60, J61)
When the paper misfeed has occurred in the Left Cover internal section, 
use the procedure below to clear it.
NOTE: Supplementary Information
The drum section inside the main unit is sensitive to scratches and 
contaminants. When removing paper, be careful not to touch it or scratch 
it with your watch, ring, etc.
1Grasp the Left Cover handles to 
lift the cover and open it.
CAUTION: The fixation section inside the main unit of the copier is 
extremely hot. Exercise caution in handling it to prevent getting burned.
2Remove jammed sheets of paper 
carefully so as not to tear them.
Downloaded From ManualsPrinter.com Manuals 
						

							Troubleshooting 
9-12OPERATION GUIDE
NOTE: If the paper is torn, be sure to remove all remnants or fragments 
from the cassette.
3If the Duplex Unit (option) is 
installed, lift it up and remove the 
paper.
NOTE: If the paper is torn, be sure to remove all remnants or fragments 
from the cassette.
4Close the left cover.
Paper misfeed in the Document Processor (option) 
(J70 to 75)
When the paper misfeed has occurred in the optional Document 
Processor, use the procedure below to clear it.
1If there are originals on the 
Original Table, remove them.
2Open the Left Cover.
Downloaded From ManualsPrinter.com Manuals 
						

							Troubleshooting 
OPERATION GUIDE9-13
3If an original is jammed inside, 
remove it carefully so as not to 
tear it.
NOTE: If the original is torn, be sure to remove all remnants or fragments 
of it from the cassette. Failure to completely remove remnants of torn 
pages can lead to paper misfeeds.
4Lift up the Paper Supply Unit (1).
5If an original is jammed inside, remove it carefully so as not to tear it.
NOTE: If the original is torn, be sure to remove all remnants or fragments 
of it from the cassette.
6Rotate the dial as shown in the 
illustration and remove the 
original.
7Close the Left Cover to return it to its original position.
Add the original that was jammed to the originals on the Original Table and 
resume copying.
Paper misfeed in the optional cassette (J12 to 16, J22 to 24)
When the paper misfeed has occurred in the optional cassette, use the 
procedure below to clear it.
 (1)
Downloaded From ManualsPrinter.com Manuals 
						

							Troubleshooting 
9-14OPERATION GUIDE
1Remove the left cover of the 
cassette being used.
2If a sheet of paper is jammed 
inside, remove it carefully so as 
not to tear it.
NOTE: If the paper is torn, be sure to remove all remnants or fragments 
from the cassette.
3Close the left cover of the 
cassette.
4Pull the cassette out.
Downloaded From ManualsPrinter.com Manuals 
						

							Troubleshooting 
OPERATION GUIDE9-15
5If a sheet of paper is jammed 
inside, remove it carefully so as 
not to tear it.
NOTE: If the paper is torn, be sure to remove all remnants or fragments 
from the cassette.
6Gently push the cassette back into its original position.
Downloaded From ManualsPrinter.com Manuals 
						

							Troubleshooting 
9-16OPERATION GUIDE
Downloaded From ManualsPrinter.com Manuals 
						

							 
OPERATION GUIDEAppendix-1
Appendix
This appendix lists the copier specifications.
Specifications 
NOTE: Specifications are subject to change without notice.
Main Body
Item Description
Ty p e D e s k t op  Ty p e
Original Table Fixed Original Table
Copy System Indirect electrostatic system
Original Types 
AccommodatedSheets, books and 3-dimensional objects (Maximum original size: Ledger/A3)
Copy Sizes Ledger, Legal, Letter, Letter R, Statement, Oficio 2, A3, B4, A4, A4R, B5, B5R, 
A5R, B6R, A6R, Postcard, Folio, 8k, 16k and 16k R
Width that cannot be copied: 0.5 to 5.5 mm
Copying Speed
- 16-sheet copier
- 20-sheet copier1:1/Memory Copy Ledger/A3:8 sheets/minute, Legal/B4:8 sheets/minute, 
Letter/A4:16 sheets/minute, Letter R/A4R:13 sheets/minute, B5:16 sheets/
minute, B5R:13 sheets/minute, A5R:10 sheets/minute, A6R:10 sheets/minute
1:1/Memory Copy Ledger/A3:10 sheets/minute, Legal/B4:10 sheets/minute, 
Letter/A4:20 sheets/minute, Letter R/A4R:13 sheets/minute, B5:20 sheets/
minute, B5R:13 sheets/minute, A5R:10 sheets/minute, A6R:10 sheets/minute
Warm-up Time Less than 20 seconds (Room Temperature 71.6ºF/22ºC, Humidity 60% RH)
First Copy Time Less than 5.9 seconds (A4)
Copying Magnification 25 to 400% (1% increments) with variable and fixed magnifications. (25 to 
200% with the document processor)
Standard Memory 18MB bitmap memory. 14MB image storage memory.
Resolution Reading: 600 × 600 dpi
Writing: 600 × 600 dpi
Paper Supply System Automatic Cassette Feed (Sheet storage: 300 sheets [80 g/m
2]) and MP Tray 
(Sheet storage: 50 sheets [80 g/m2])
Downloaded From ManualsPrinter.com Manuals 
						

							 
Appendix-2OPERATION GUIDE Acceptable Paper
- Paper Weights
- Media TypesCassette: 64 to 105 g/m
2
Duplex Unit: 64 to 90 g/m2
MP Tray: 45 to 160 g/m2
Cassette: Standard paper, recycled paper and color paper
Duplex Unit: Standard paper, recycled paper and color paper
MP Tray: Standard paper, recycled paper, color paper, vellum paper and thick 
paper
Consecutive Copying 1 to 999 sheets
Light Source Rare gas lamp
Developing System Dry developing
Fixation System Heat roller
Cleaning System Blade cleaning system
Drum Type OPC
Standard Functions and 
ModesAutomatic Paper Selection, Image Quality Selection, Automatic Magnification 
Selection Mode, Zoom Mode, 2-Sided Copy
1, Split Copy, Margin Shift, Border 
Width, Combine mode, Collate Copy, EcoPrint, Copy Program and Job 
Accounting
1...When the Duplex Unit (option) is installed.
Ambient conditions
- Temperature
- Humidity
- Altitude
- Illumination10 to 32.5 °C
15 to 80 %RH
Maximum 2,500m
1,500 lux or less
Power Source
- Inch specifications
- Metric specifications120V AC 60Hz 9.0A
220 to 240V AC 50Hz 5.0A
Dimensions Width 22 
5/8 × Depth 21 3/4 × Height 19 3/4
Width 574 mm × Depth 552 mm × Height 502 mm
Weight Approximately 85.9 lbs/39 kg
Required Space Width 32 
9/16 × Depth 21 3/4
Width 827 mm × Depth 552 mm
Options Document Processor, Paper Feeder, Duplex Unit, Key Counter
The Original Cover is standard depending on the destination. Item Description
Downloaded From ManualsPrinter.com Manuals 
						

							 
OPERATION GUIDEAppendix-3
Document Processor (option).
Paper Feeder (option)
Duplex Unit (option)
Item Description
Original Feed SystemAutomatic feed system
Acceptable Types of 
OriginalsSheet originals
Original Sizes Maximum: Ledger/A3
Minimum: Statement/A5R
Original Thickness 
(paper weight)Single-side Originals: 45 to 160 g/m
2
Double-sided Originals: 50 to 120 g/m2
No. of Originals that can 
be loadedLess than 50 sheets (50 to 80 g/m2)
Power Source Electrically connected to the copier main unit
External Dimensions Width 21 
3/4 × Depth 19 1/8 × Height 4 11 / 1 6
Width 552 mm × Depth 483 mm × Height 120 mm
Weight Approximately 13.2 lbs/6 kg
Item Description
Paper Supply System Automatic Cassette Feed (sheet storage 300 sheets [80 g/m
2])
Paper Sizes Ledger, Legal, Letter, Letter R, Statement, Oficio 2, A3, B4, A4, A4R, B5, B5R 
and A5R
Acceptable Paper
- Paper Weights
- Media Types64 to 105 g/m
2
Standard paper, recycled paper and color paper
Power Source Electrically connected to the copier main unit
Dimensions Width 22 
7/16 × Depth 21 3/16 × Height 5 5/16
Width 570 mm × Depth 538 mm × Height 135 mm
Weight Approximately 15.4 lbs/7 kg
Item Description
System Internal type
Paper Sizes Ledger, Legal, Letter, LetterR, Statement, Folio, Oficio 2, A3, B4, A4, A4R, B5, 
B5R and A5R
Downloaded From ManualsPrinter.com Manuals 
						

							 
Appendix-4OPERATION GUIDE
Additional Memory (option).
Environmental Specifications
Power consumption
Power consumption in the Plugged-In mode can only be terminated by 
removing the power plug from the outlet.
2-Sided Copy Function
Option
Paper Transportability
Recycled paper made from 100% recycled pulp may be used with this product.
Please consult with dealer or sales representative for information on the 
recommended types of paper, etc. Acceptable Paper
- Paper Weights
- Media Types64 to 90 g/m
2
Standard paper, recycled paper and color paper
Power Source Electrically connected to the copier main unit
Dimensions Width 14 
1/2 × Depth 2 1/16 × Height 7 1/16
Width 368 mm × Depth 53 mm × Height 180 mm
Weight Approximately 1.4 lbs/0.65 kg
Item Description
Memory Type 100-pin DIMM
Memory Capacity 16MB, 32MB, 64MB and 128MB
No. of Originals that can 
be read in16MB: 250 sheets, 32MB: 250 sheets, 64MB: 250 sheets, 128MB: 250 sheets 
(Letter, blackness ratio 6% originals)
ItemInch specifications
120V AC 60HzMetric specifications
220 to 240V AC 50Hz
Recovery time from the Low Power mode 10 seconds 10 seconds
Transition time to the Low Power mode (at time 
of purchase)15 minutes 15 minutes
Transition time to the Sleep modes (at time of 
purchase)30 minutes 30 minutes Item Description
Downloaded From ManualsPrinter.com Manuals