Panasonic Kx Tge463 Operating Instructions Manual

Making cellular callsImportant:
R The unit can be used to talk on 2 lines at
the same time (for example, 2 cellular lines,
or the landline and 1 cellular line).
R Only 2 Bluetooth devices can be used with
the unit at the same time (for example, 2
cellular lines, or the headset and 1 cellular
line).
R Before making calls, confirm that the
corresponding 
 on the handset is
displayed (page 14).
1 Lift the handset and then dial the phone
number.
RTo correct a digit, press  MCLEAR N.
2 MCELL N
R The unit...

To switch back to the receiver, press MZ N/
MN .
R In step 1, you can store the dialed phone
number to the phonebook by pressing and
holding  MF N W  for a few seconds.
Making a call using the redial list
The last 5 phone numbers dialed are stored in
the redial list (each 48 digits max.).
1 ME N REDIAL
2 Mb N: Select the desired entry.
3 M
N
Pause (for PBX/long distance service
users)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access...

Note:
RAfter holding for 10 minutes, the call is
disconnected.
Mute
1 Press  MMUTE N during a call.
2 To return to the call, press  MMUTE N.
Note:
R M MUTE N is a soft key visible on the display
during a call.
Flash for landline calls
M FLASH N allows you to use the special
features of your host PBX such as transferring
an extension call, or accessing optional
telephone services.
Note:
R To change the flash time, see page 44.
For call waiting or Call Waiting
Caller ID service users
To use call waiting...

1Press  MMENU N while talking.
2 Mb N:  “Equalizer ” a  M SELECT N
3 Mb N: Select the desired setting.
4 Press  MOK N to exit.
Note:
R The setting you made is kept for each line
(landline and cellular lines).
R Depending on the condition and quality of
your telephone line, this feature may
emphasize existing line noise. If it becomes
difficult to hear, turn this feature off.
R This feature is not available while using the
speakerphone.
R When both the  “Equalizer ” setting and
noise reduction are...

ready to talk before transferring. For
example, if your cellular phone has a top
cover, open it beforehand.
Transferring a cellular call from a
cellular phone to the handset
During a conversation using a cellular phone,
the call cannot be transferred to the handset
by the cellular phone. Perform the following
with the handset.
1During a conversation using a cellular
phone, press  MCELL N.
R The call is transferred to the handset in
the following situations.
– Only 1 cellular phone is paired.
– A...

– Continuous use of the handset other than ahandset in power backup mode: 2 hours
max.
– Not in use in power backup mode: 2 hours max.
Making calls during a power
failure
nWhen only 1 handset is registered:
1 Lift the handset and dial the phone
number.
2 Within 1 minute, place the handset on
the base unit.
RWait until speakerphone is turned
on automatically and the call is
made.
3 When the other party answers the call,
keep the handset on the base unit and
talk using the speakerphone.
4 When you finish...

Making cellular calls
Available for:
KX-TGE470 series (page 4)
Important:
RThe unit can be used to talk on 2 lines at
the same time (for example, 2 cellular lines,
or the landline and 1 cellular line).
R Only 2 Bluetooth devices can be used with
the unit at the same time (for example, 2
cellular lines, or the headset and 1 cellular
line).
R Before making calls, confirm that the
corresponding CELL indicator on the base
unit lights up (page 15).
1 Press  MCELL 1 N or  MCELL 2 N.
2 Dial the phone number.
3...

When a cellular call is being received, the
CELL indicator and SP-PHONE indicator flash
rapidly.
1Press  MZ N when the unit rings.
R You can also answer the cellular call
by pressing  MCELL 1 N or  MCELL 2 N.
2 Speak into the microphone.
3 When you finish talking, press  MZ N.
Adjusting the base unit ringer volume
n While the base unit is ringing for an
incoming call:
Press  Mj N or  Mk N repeatedly to select the
desired volume.
n While the base unit is in standby mode:
Press  Mj N or  Mk N repeatedly...

Call shareYou can join an existing outside call.
To select the line that is being used for the call:
– for a cellular line press  MCELL 1 N or  MCELL
2 N.
– for the landline press  MZ N.
Note:
R A maximum of 3 parties (including 1 outside
party) can join a conversation using 2
extensions.  (3-way conference)
R To prevent other users from joining your
conversations with outside callers, turn call
sharing mode off (page 44).
Transferring calls, conference
calls
Outside calls can be transferred or a...

Handset locatorYou can locate a misplaced handset by
paging it.
1 Base unit:  Press MLOCATOR N or
M HANDSET LOCATOR N.
R All registered handsets beep for 1
minute.
2 To stop paging:
Base unit:
Press  MLOCATOR N or  MHANDSET
LOCATOR N.
Handset:
n KX-TGE460 series: page 4
Press  MOFF N.
n KX-TGE470 series: page 4
Press  M
N, then press  MOFF N.
Cell locator
This feature allows you to locate a misplaced
cellular phone by pressing the  MLOCATES
CELL N button on the base unit and calling
your cellular phone....