Samsung Dcs 50si General Description Manual

CONTENTS
SYSTEM TONES
3.3
Ringback Tone—Indicates the station you dialed is ringing.
Busy Tone—Indicates the station you dialed is busy.
DND/No More Calls Tone—Fast busy tone indicates the station you
dialed is in the Do Not Disturb mode or cannot receive any more calls.
Transfer/Conference Tone—Indicates your call is being held and you can
dial another party.
Confirmation Tone—Very short beeps followed by dial tone indicate you
have correctly set or canceled a system feature.
Error Tone—A distinctive...

3.6KEYSET LED INDICATIONS
CONDITION LED COLOR LED ON LED OFF
LINE IDLE OFF – OFF
LINE IN USE RED/GREEN STEADY –
RECALL AMBER 500 ms 500 ms
CALL ON HOLD RED/GREEN 500 ms 500 ms
RINGING C.O. CALL GREEN 100 ms 100 ms
RINGING INTERNAL CALL GREEN 100 ms 100 ms
DND INDICATION RED 112 IPM for 500 ms 500 ms
3.7ARESERVE POWER DURATION ESTIMATES (in minutes)*
     NO. OF UPS CAPACITY IN VOLT AMPS
 STATIONS250 400 450 600 900 1250 2000
4 65 160 200 245 360 490 930
8 45 110 135 160 240 320 625
12 40 90 115...

3.7BRESERVE POWER DURATION ESTIMATES
     NO. OF
 STATIONS WITHOUT CADENCE WITH CADENCE
8 83 Hours 57 Hours
16 49 Hours 39 Hours
24 35 Hours 29 Hours
32 27 Hours 23 Hours
40 22 Hours       –
The table above gives estimated system hold up times for a 50si system. These times are
based on an idle system equipped with a fully charged 40 Amp Hour / 48 Volt battery pack.
The hold up times stated above are approximate and will be reduced the busier the sys-
tem becomes. In addition different battery...

PART 4. FEATURES
SYSTEM FEATURES
4.1.1
Account Code EntryForcedVoluntaryAll Call Voice PageAttention ToneAuthorization CodesForcedVoluntaryAuto Attendant†
Automatic HoldBackground MusicCaller Identification†
Name/Number DisplayNext CallSave CIDStore CIDInquire Park/HoldCID Review ListInvestigateAbandon Call List (50)CID on SMDRNumber to Name Translation (350)Call ForwardingAll CallsBusyForward DNDNo AnswerBusy/No AnswerFollow MeExternalTo Voice MailCall HoldExclusiveSystemRemoteCall Park and...


4.1.2
4.1 SYSTEM FEATURE DESCRIPTIONS
ACCOUNT CODE ENTRY
Station users may enter an account code (maximum 12 digits) before hanging up
from a call. This account code will appear in the SMDR printout for that call record.
Keyset users may enter this code using an account (ACCT) key without interrupt-
ing a conversation. Single line telephone users must temporarily interrupt the call
by hook-flashing and dialing the feature access code. Account codes can be up to
12 digits long.
FORCED
When...


4.1.3
AUTO ATTENDANT
The SMISC2 card for the DCS 50si includes four ports of auto attendant for simul-
taneous answering and call processing. Sixteen professionally recorded prompts
inform callers of the progress of their calls. Several examples are the following: “I’m
sorry. There is no answer”, “That station is busy” and “Invalid number. Please try
again”, Two minutes of battery-backed random access memory (RAM) provide up
to 48 customer recordings for announcements or greetings. Twelve...


call in queue at your station. Either the CID name or CID number will show in the
display depending on your N/N selection.
SAVE CID
At any time during an incoming call that provides CID information, you may press
the SAVE key. This saves the CID number in the Save Number feature. Pressing
the SAVE number redial key will dial the CID number. The system must be using
Least Cost Routing (LCR) to dial the saved number.
STORE CID
At any time during an incoming call that provides CID, you may press...


NUMBER TO NAME TRANSLATION (350)
The system provides a translation table for 350 entries. When the CID number is
received, the table is searched. When a match is found, the system will display the
corresponding name. This will allow users in areas that do not support deluxe Caller
ID to provide names for regular callers.
CALL FORWARDING
This feature allows the user to redirect (forward) incoming calls. The calls can be
redirected to the attendant, a hunt group, voice mail, external number or...


EXTERNAL
This feature forwards C.O. calls to an external number via a central office trunk if
allowed by class of service. These C.O. calls forward only after the programmable
external call forward delay timer expires.
TO VOICE MAIL
Each station may be programmed to allow or deny the ability to forward intercom
calls to voice mail. When denied, valuable message time in the voice mail system
can be saved.
CALL HOLD (EXCLUSIVE)
Outside calls can be placed on exclusive hold at any keyset by...


4.1.7
CALL WAITING/CAMP-ON
Busy stations are notified that a call is waiting (camped-on) when they receive a
tone. The tone is repeated at a programmable interval. Keysets receive an off-hook
ring signal through the speaker and single line stations receive a tone in the hand-
set. The volume of the camp-on tone can be set by the station user. Camped-on
calls follow Forward No Answer if a Forward No Answer destination has been set.
CENTREX/PBX USE
CENTREX and PBX lines can be installed in lieu of...