Panasonic Network Scan Functions Dp 190 Operating Instruction

							51
Network Scanner
1:SET MODE ?
PRESS SET TO SELECTSET MODE      (1-2)
ENTER NO. OR ∨ 
^
63:GRAY SCALE ?
PRESS SET TO SELECT
For Gray Scale
7GRAY SCALE=OFF
1:OFF    2:ON
SCAN FILE NAME
ENTER NAME
(When Custom is Selected)
2:SELECT MODE ?
PRESS SET TO SELECTSELECT MODE   (1-3)
ENTER NO. OR ∨ 
^
or
or
2:SCAN PARAMETERS ?
PRESS SET TO SELECT
6
7
When inputting a special character,
press the _/()...
 Key and use the (     /     )
Cursor Keys to select a character. (Maximum. 40)
When changing the stored character, move the cursor (   )
back to the character you wish to replace and press the
CLEAR Key then input a new character.
: Scan File Name
  When adding a file name.
: Compression
  When selecting a compression format.
: Gray Scale
  When scanning the color original with
  Gray Scale mode.
or
456
45 
						

							52
Network Scanner
Select
Scanning Size
(LGL and MIX:
with ADF  only)
LTR 
INV 
INV 
LGL 
MIX 
Select scanning
mode
● Resolution,
Contrast,
Density (Color
Scanning) only
(See page 46).
A
B
C
■  Remote Copy
or
Remote Copy
Scanned image data can be printed on other Printers through
the PC(s) connected on the network.
When using this function, register the Station (Machine Name/
Printer) (see page 48), the Panasonic-DMS should be installed
and Panasonic Communication Utility is configured on the
other PC(s).
For Panasonic Communication Utility, refer to Operating
Instructions (For Document Management System and Printer).
Network
Ex. Color Document
Ex.
Color Printer
Prints 
in Color
Default Printer
Local or Network Connection
1
5SELECT DESTINATION
LTR 
						

							53
Network Scanner
SELECT DESTINATION
LTR
REMOTECOPY
REMOTE COPY
NO. OF COPY=_
Number of
Copies
(1-99)
Scanned image data will be
transferred to the selected PC. PC will output the received data
to the default (desired) printer.
NOTE:
The paper size defaults to the
size which has been set by the
remote copy configuration and
the output printer driver. There
are times when the paper size
differs from the scanning size
assigned in Step 5.
(Refer to the Remote Copy
Section on the Operating
Instructions for Document
Management System and
Printer.)
Select the Remote
destination Printer
(PCs IP Address)
(See page 47)
2
6
3
7
4
5 
						

							54
Network Scanner
■ Direct Connection (with Crossover Cable)
Direct Connection (with Crossover Cable)
Turn OFF* the Power
Switch (Machine and the
PC).
Connect a Crossover LAN Cable between your machine
and the PC.
LAN Cable (Crossover)
To  PC
(Rear Side of Machine) (Rear Side of PC)
NOTE:Do not use Standard
LAN Cable.
Turn OFF* and ON the
Power Switch (Machine
and the PC).Input your PCs IP
Address into the Address
Book in the machine (see
page 48) or into the
Panasonic-DMS software
(refer to the enclosed CD).Scan the document(s) to
your PC. (See page 46)
NOTE:
*If the Hard Disk Drive Unit (DA-HD19) is installed, see page 13.
LINK10/100BASE-TXRXHANDSET
TELLINELAN Cable (Crossover)
To  
Machine
12
567 
						

							55
Network Scanner
Turn On the Power Switch
(Machine and the PC). Input the Network Address
(Machine and your PC).
●
IP and Gateway Address
IP: 192.168.0.1 (Machine)
192.168.0.2 (Your PC)
Subnet Mask: 255.255.255.0
(Machine & the PC)
● How to input the network address:
For your Machine: See page 44
For your PC: See below
For more detailed information, refer to Windows OS operating instruction\
s manual.
For Windows 2000
9
1
4
5
67Right click My Network
Places and select
Properties.2Right click Local Area
Connection and select
Properties.
3Select Internet
Protocol (TCP/ IP).
Click Properties.
Click OK.
4
7
5Select Use the
following IP address
then, Input IP Address
and the Subnet Mask.
Click OK.
6
For Windows XP
1Open the Control Panel.
3
2
2Select Switch to Classic
V iew, if using the
Category View Mode.
Select Network
Connections.
3
4
4Right click Local Area
Connection Enabled ........
and select Properties.
5Select Internet
Protocol (TCP/ IP).
Click Properties.
Click CLOSE.
6
5
6
7Select Use the following
IP address then, Input IP
Address and the Subnet
Mask.
8
7
8
5
9Click OK.
3
OK will be changed to CLOSE.
34
5
NOTE:
 * If you use the DHCP server, select
to disable the DHCP server.
Machine : See page 45.
Your PC : Consult your System
Administrator. 
						

							56
Problem Solving
Troubleshooting
CheckAction
Unit Does Not Operate
Check if the Power Switch (Main Power Switch
on the Left Side of the machine) is turned ON
and if the power cord is plugged into the AC
outlet. Does the display light?
Press Energy Saver key on the control panel. Does the Energy Saver key flash (or light)
and the display is turned OFF?
(See page 32)
Perform actions in accordance with each
message. Does any of the U## codes and messages
appear on the display?
(U1, U13, U16....etc.)
Add paper. (See page 14) Does the Add Paper indicator and message
appear on the display?
Remove the misfed paper. (See page 18)
Be sure to set paper as adjusted with paper
guides. (See page 42) Does the message and J## Codes appear on
the display? (J00, J01, J02,...etc.)
Turn the Power Switch on the Left Side of the
machine to the OFF* and ON position. If the
error code does not clear, call your Service
provider. Does E#-## codes and messages appear on
the display?
Turn the Power Switch on the Left Side of the
machine to the OFF* and ON position. The machine would not accept the next job
during operation, instructed job would not be
accepted for a long time period or job would
not be completed.
Light Copies
Press the DARKER Key.
(See page 25) Does the exposure indicator say
LIGHTER?
Replace the Toner Cartridge.
(See page 16) Does the Toner Cartridge replacement and
message appear on the display?NOTE:
*If the Hard Disk Drive Unit (DA-HD19) is
installed, see page 13. 
						

							57
Problem Solving
Separation 
RubberRollers ADF Cover
Paper Transport  Knob
Feed Rollers
CheckAction
Marked Copies
Clean the Platen Glass or Sheet.
(See below) Is the machine’s Platen Glass or Platen Sheet
dirty?
Cover the original with a sheet of white paper
before copying or lighten the exposure setting. Is the original a transparency film or a dark
original?
■ If the measures outlined above do not solve the problem, call your Service Provider.
Machine Care
■ As a rule, clean weekly.
Platen Glass/Platen Sheet
 Wipe marks off with a cloth and a neutral detergent.
 Wipe again with a dry cloth.
Platen
Sheet
Platen (glass)
Clean the ADF Rollers or Separation Rubber.
(See below) Are the machine’s ADF Rollers or Separation
Rubber dirty?
■ When the copies are smudged.Rollers/Separation Rubber
Open the ADF Cover.
Clean the Rollers and Separation Rubber with a wet
cloth (with water).
Close the ADF Cover.
3
Feed Rollers should be cleaned by
turning the Feed Rollers with the Paper
Transport Knob.
Clean the Corona Wire of the Drum Unit.
(See page 17) If a dark vertical 0.8-1.2
inch (2-3 cm) wide line
appears on the printed
copy. 
						

							58
Problem Solving
Replacing the Battery/Set the Date and Time
The machine has an internal battery
(Product No.: CR2032) which maintains
the date and time.
In the event the battery requires
replacement, the following message will
be displayed.
Turn the Power Switch on the
Left Side of the machine to the
OFF position.
If the Hard Disk Drive Unit
(DA-HD19) is installed, see
page 13)
12
6
REPLACE BATTERY
U90
1009 KEY OPERATOR MODE
ENTER PASSWORD=_11KEY OPR.MODE (00-31)
ENTER NO. OR ∨ 
^
or
17 (DATE & TIME)
Remove 1 Screw
Battery Holder
NOTE●The service life of the battery is approximately 1 year under normal use.3-digit
(See page 13)
Set the Date and Time continues steps 6 to 13.
CAUTION
Keep button batteries and small parts out of reach of children to prevent
chocking or poisoning. If a button battery is swallowed accidentally, get
medical treatment immediately.
When setting the Date and Time,
start from step 6.
If set in other function mode. 
						

							59
Problem Solving
Turn the Power Switch
on the Left Side of the
machine to the ON
position.
345
6
Used
New
7FUNCTION MODE (1-2)
ENTER NO. OR ∨ 
^
or
89GENERAL PARAM.(0-9)
ENTER NO. OR ∨ 
^
or
1: General Settings
9 (09 KEY OPERATOR MODE)
10
1217 DATE & TIME
   _05-02-2004 00:0113
Move the cursor (_) under
the Month/Date/Year/
Time that you wish to
change, then input the
new data using the
Keypad.Install 1 Screw
Battery Holder
CAUTION
denotes hazards that could result in minor injury or damage to the machine.
●THIS PRODUCT CONTAINS A LITHIUM BATTERY. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.
IMPROPER USE OR REPLACEMENT MAY CAUSE OVERHEATING, RUPTURE OR EXPLOSION RESULTING IN
INJURY OR FIRE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS OF YOUR LOCAL
SOLID WASTE OFFICIALS AND LOCAL REGULATIONS“+” side of battery should be
facing upwards. (Observe the
polarity, see CAUTION! below) 
						

							60
Appendix
Type: Desk Top
Platen Type: Fixed
Acceptable Originals: Sheets (Max. Legal size, with the ADF only), Books
Copying Method: Laser Electrophotography
Fusing Method: Heat Roller
Imaging Method: 1 Component Non Magnetic Dry Toner Contact Developing
Resolution: Max. 600 dpi
Operation Panel: LCD Display
Copy Size: Legal - Letter via Paper Tray / Legal - Invoice via Sheet Bypass
V oid Area: Max.  0.2 ″ (5 mm)
Wa rm Up Time: Approx. 18 seconds (68 °F/20 °C, Shutdown Mode)
First Copy Time: Approx. 10 seconds (Letter, from 1st Tray)
Multi-Copy Speed: 19 cpm (Letter size)
Enlargement Ratios: Preset: 129%, 155%
V ariable: from 101% to 200% in 1% increments
Reduction Ratios: Preset: 79%, 65%, 61%
V ariable: from 99% to 50% in 1% increments
Paper Feed: Paper Trays (250 sheets Standard + 550 sheets Option) + Single Sheet Bypass ●Transparency film should feed from standard paper tray (Tray-1/ 20 sheets) and
Sheet Bypass (1 sheet).
Paper Weight: Paper Tray: 16 - 28 lb / 20 - 24 lb (2-Sided Copy)
Bypass: 16 - 44 lb
Quantity Selector: Max. 999 sheets (Output Tray capacity is 150 sheets ∗
)
Electrical Consumption: AC 120V, 60Hz, 8A
Power Consumption: Max. 900 W
Dimensions (W)(D)(H): 18.2 x 19.9 x 20.6 (with ADF)
Mass (Weight): 48.5 lb (22  kg) (with ADF)
Operating Environment: Temperature: 50 - 86 °F (10 - 30 °C)
[Humidity should be 70% or less at 86 °F (30 °C)]
Relative Humidity: 30 - 80%
[Temperature should be 80 °F (27 °C) or less at 80% RH]
T ray Capacity: Letter, Invoice : 50 sheets (20 lb)
Legal : 30 sheets (20 lb)
Paper Size: Invoice/Letter/Legal
Paper Weight: 14 – 28 lb
Electrical Requirements: Supplied from the machine
■  DP-190 (For Copier)
Specifications
■ ADF (Standard)
∗
When used only with Panasonics recommended Letter size paper.