Home > Yamaha > Motorcycle > Yamaha Yzf R1 2007 Manual

Yamaha Yzf R1 2007 Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Yamaha Yzf R1 2007 Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 255 Yamaha manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    Page
    of 429
    							CHARGING SYSTEM
    8-12
    2. AC magneto
    3. Rectifier/regulator
    4. Main fuse
    8. Battery
    88.Ground
    89.Battery negative lead 
    						
    							CHARGING SYSTEM
    8-13
    EAS27230
    TROUBLESHOOTING
    The battery is not being charged.
    NOTE:
     Before troubleshooting, remove the following part(s):
    1Rider seat
    2 Fuel tank
    3 Air filter case
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓ 1 Check the fuse.
    (Main)
    Refer to CHECKING THE FUSES 
    on page 8-85.Replace the fuse.
    2 Check the battery.
    Refer to CHECKING AND 
    CHARGING THE BATTERY on 
    page 8-85. Clean the battery terminals.
     Recharge or replace the battery.
    3 Check the stator coil
    Refer to CHECKING THE STATOR 
    COIL on page 8-93. Replace the stator coil assembly.
    4 Check the rectifier/regulator.
    Refer to CHECKING THE RECTI-
    FIER/REGULATOR on page 8-93.Replace the rectifier/regulator.
    5 Check the entire charging system’s 
    wiring.
    Refer to CHARGING SYSTEM on 
    page 8-11.Properly connect or repair the charg-
    ing system’s wiring.
    This circuit is OK. 
    						
    							CHARGING SYSTEM
    8-14 
    						
    							LIGHTING SYSTEM
    8-15
    EAS27240
    LIGHTING SYSTEM
    EAS27250
    CIRCUIT DIAGRAM 
    						
    							LIGHTING SYSTEM
    8-16
    1. Main switch
    4. Main fuse
    8. Battery
    19.ECU (engine control unit)
    51.High beam indicator light
    54.Meter light
    62.Dimmer switch
    71.Headlight
    72.Auxiliary light
    74.License plate light
    76.Tail/brake light
    77.Headlight relay (on/off)
    78.Headlight relay (dimmer)
    81.Headlight fuse
    88.Ground
    89.Battery negative lead 
    						
    							LIGHTING SYSTEM
    8-17
    EAS27260
    TROUBLESHOOTING
    Any of the following fail to light: headlight, high beam indicator light, taillight, license light or meter 
    light.
    NOTE:
     Before troubleshooting, remove the following part(s):
    1Rider seat
    2 Fuel tank
    3 Side cowlings
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓ 1 Check the each bulbs and bulb 
    sockets condition.
    Refer to CHECKING THE BULBS 
    AND BULB SOCKETS on page 8-
    84.Replace the bulb(s) and bulb 
    socket(s).
    2 Check the fuses.
    (Main, headlight and park)
    Refer to CHECKING THE FUSES 
    on page 8-85.Replace the fuse(s).
    3 Check the battery.
    Refer to CHECKING AND 
    CHARGING THE BATTERY on 
    page 8-85. Clean the battery terminals.
     Recharge or replace the battery.
    4 Check the main switch.
    Refer to CHECKING THE 
    SWITCHES on page 8-81.Replace the immobilizer unit.
    5 Check the dimmer switch.
    Refer to CHECKING THE 
    SWITCHES on page 8-81.The dimmer switch is faulty. Replace 
    the left handlebar switch.
    6 Check the rear brake light switch.
    Refer to CHECKING THE 
    SWITCHES on page 8-81.Replace the rear brake light switch.
    7 Check the headlight relay (on/off).
    Refer to CHECKING THE 
    RELAYS on page 8-88.Replace the headlight relay. 
    						
    							LIGHTING SYSTEM
    8-18
    NG→
    OK↓
    NG→
    OK↓ 8 Check the headlight relay (dimmer).
    Refer to CHECKING THE 
    RELAYS on page 8-88.Replace the headlight relay.
    9 Check the entire lighting system’s 
    wiring.
    Refer to LIGHTING SYSTEM on 
    page 8-15.Properly connect or repair the lighting 
    system’s wiring.
    This circuit is OK. 
    						
    							SIGNALING SYSTEM
    8-19
    EAS27270
    SIGNALING SYSTEM
    EAS27280
    CIRCUIT DIAGRAM 
    						
    							SIGNALING SYSTEM
    8-20
    1. Main switch
    4. Main fuse
    8. Battery
    9. Fuel injection system fuse
    12.Starting circuit cut-off relay
    13.Neutral switch
    15.Fuel pump
    19.ECU (engine control unit)
    33.Speed sensor
    43.Fuel level warning light
    44.Oil level warning light
    45.Neutral indicator light
    46.Tacho meter
    47.Shift timing indicator light
    48.Multi-function meter
    50.Coolant temperature indicator light
    52.Left turn signal indicator light
    53.Right turn signal indicator light
    57.Front brake light switch
    60.Turn signal relay
    63.Horn switch
    65.Turn signal switch
    66.Horn
    67.Front left turn signal light
    68.Front right turn signal light
    69.Rear left turn signal light
    70.Rear right turn signal light
    75.Rear brake light switch
    76.Tail/brake light
    79.Ignition fuse
    80.Signal fuse
    88.Ground
    89.Battery negative lead 
    						
    							SIGNALING SYSTEM
    8-21
    EAS27290
    TROUBLESHOOTING
     Any of the following fail to light: turn signal light, brake light or an indicator light.
     The horn fails to sound.
    NOTE:
     Before troubleshooting, remove the following part(s):
    1Rider seat
    2 Passenger seat
    3 Fuel tank
    4Side cowling
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    NG→
    OK↓
    Check the signaling system
    The horn fails to sound.
    NG→
    OK↓
    NG→
    OK↓ 1 Check the fuses.
    (Main, fuel injection system, head-
    light, Turn signal light, signal)
    Refer to CHECKING THE FUSES 
    on page 8-85.Replace the fuse(s).
    2 Check the battery.
    Refer to CHECKING AND 
    CHARGING THE BATTERY on 
    page 8-85. Clean the battery terminals.
     Recharge or replace the battery.
    3 Check the main switch.
    Refer to CHECKING THE 
    SWITCHES on page 8-81.Replace the main switch/immobilizer 
    unit assembly.
    4 Check the entire signaling system’s 
    wiring.
    Refer to SIGNALING SYSTEM on 
    page 8-19.Properly connect or repair the signal-
    ing system’s wiring.
    This circuit is OK.
    1 Check the horn switch.
    Refer to CHECKING THE 
    SWITCHES on page 8-81.Replace the left handlebar switch.
    2 Check the horn.
    Refer to CHECKING THE HORN 
    on page 8-94.Replace the horn. 
    						
    All Yamaha manuals Comments (0)

    Related Manuals for Yamaha Yzf R1 2007 Manual