Brother Ppf 3750 Plain Paper Laser Fax Owners Manual

							119TROUBLESHOOTING AND MAINTENANCE
3Remove the toner cartridge from the drum unit and keep it in a safe
place.  For more information, see ÒReplacing the Toner CartridgeÓ on
pages 112Ð116.
Toner
Cartridge
Toner
Cartridge
Discard the used drum unit according to local regulations.  If you are not
sure of them, call your local Sanitation Department.  Be sure to seal the
drum unit tightly so toner powder does not spill out of the unit.  When
discarding used drum units, keep them separate from domestic garbarage.
4Wait to unpack the new drum unit until immediately before installing it.
Place the old drum unit into the aluminum bag and discard it according to
local regulations.
Aluminum
Bag
New Toner
Cartridge
Old Toner
Cartridge 
						

							120CHAPTER THIRTEEN
5Gently rock the new drum from side to side five or six times.
      
WARNING
Do NOT remove the clear plastic starter sheet!
Clear Plastic Starter Sheet
nWait to unpack the drum unit immediately before installing it into the
fax machine.  If an unpacked drum unit is subjected to excessive direct
sunlight or room light, the unit may be damaged.
nHandle the toner cartridge and the drum unit carefully because they
contain toner.  If toner scatters and your hands or clothes get dirty,
immediately wipe or wash with cold water. 
						

							121TROUBLESHOOTING AND MAINTENANCE
6Reinstall the toner cartridge into the new drum unit.  For more
information, see ÒReplacing the Toner CartridgeÓ on pages 112Ð116.
7Holding the new drum unit by its handles, install it.  Close the top
cover.
Drum Unit
Top Cover
8The fax machine will eject the clear plastic starter sheet automatically.
Clear Plastic Starter Sheet
WARNING
nDo not touch the scanner window with your finger.
nHandle the toner cartridge and drum unit carefully because they contain
toner.  If toner scatters and your hands or clothes get dirty, immediately
wipe or wash it off with cold water. 
						

							122CHAPTER THIRTEEN
For Customer Service
USA:1-800-284-4329 (voice)
1-908-575-8790 (fax)
From within Canada:1-800-853-6660 (voice)
1-514-685-4898 (fax)
From within Montreal:1-514-685-6464 (voice) 
						

							14
CHAPTER FOURTEEN
123
Standard Telephone  and
FCC Notices (For 120V Models Only)
These notices are in effect on models sold and used in
the United States only.
This equipment is hearing aid compatible.
When programming emergency numbers and/or making test calls to
emergency numbers:
nRemain on the line and briefly explain to the dispatcher the reason for
the call before hanging up.
nPerform these activities in the off-peak hours, such as early morning or
late evening.
This equipment complies with Part 68 of FCC Rules. On the rear panel of this
equipment is a label that contains, among other information, the FCC Registration
Number and Ringer Equivalence Number (REN) for this equipment. You must,
upon request, provide this information to your telephone company.
You may safely connect this equipment to the telephone line by means of a
standard modular jack, USOC RJ11C.
An FCC compliant telephone cord with a modular plug is provided with this
equipment. This equipment is designed to be connected to the telephone line or
premiseÕs wiring using a compatible modular jack that is Part 68 compliant. See
the Installation section of this manual for details. 
						

							124CHAPTER FOURTEEN
The REN is useful to determine the quantity of devices you may connect to your
telephone line and still have those devices ring when your telephone number is
called. In most, but not all areas, the sum of the RENs of all devices connected to
one line should not exceed five (5). To be certain of the number of devices you
may connect to your line, as determined by the REN, you should contact your
local telephone company to determine the maximum REN for your calling area.
If your FAX 2750 or FAX 3750 damages the telephone line, the telephone
company may discontinue your service temporarily. If possible, they will notify
you in advance. If advanced notice is not practical, you will be notified as soon
as possible. You will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes to its facilities, equipment,
operations or procedures that could affect the proper functioning of your
equipment. If they do, you will be notified in advance to give you an opportunity
to maintain uninterrupted telephone service.
If you experience trouble with your fax machine, please contact a Brother
Authorized Service Center for information on obtaining service or repair. The
telephone company may ask that you disconnect this equipment from the line until
the problem has been corrected or until you are sure that the equipment is not
malfunctioning.
If you are not able to solve a problem with your fax machine, contact Brother
Customer Service at
USA:1-800-284-4329(voice)
1-908-575-8790(fax)
From within Canada:1-800-853-6660(voice)
1-514-685-4898 (fax)
From within Montreal:1-514-685-6464(voice)
The serial number is on the back of the unit. Please circle the model number below
and retain this OwnerÕs Manual with your sales receipt to serve as a permanent
record of your purchase, in the event of a theft, fire or warranty service.
MODEL NO:   FAX 2750 or FAX 3750 (circle one)
SERIAL NUMBER _____________________________
NAME OF DEALER ____________________________
DATE OF PURCHASE __________________________ 
						

							125IMPORTANT INFORMATION
WARNING
For protection against the risk of electrical shock, always disconnect all cables
from the wall outlet before servicing, modifying or installing the equipment.
This equipment may not be used on coin service lines provided by the
telephone company or connected to party lines.
Brother cannot accept any financial or other responsibilities that may be the result
of your use of this information, including direct, special or consequential
damages. There are no warranties extended or granted by this document.
Laser Safety (For 110Ð120V Models Only)
This equipment is certified as a Class I laser product under the U.S. Department
of Health and Human Services (DHHS) Radiation Performance Standard
according to the Radiation Control for Health and Safety Act of 1968.  This
means that the equipment does not produce hazardous laser radiation.
Since radiation emitted inside the equipment is completely confined within
protective housings and external covers, the laser beam cannot escape from the
fax machine during any phase of user operation.
FDA Regulations
U.S. Food and Drug Administration (FDA) has implemented regulations for laser
products manufactured on and after August 2, 1976.  Compliance is mandatory
for products marketed in the United States.  One of the following labels on the
back of the printer indicates compliance with the FDA regulations and must be
attached to laser products marketed in the United States.
Manufactured
BROTHER INDUSTRIES, LTD.
15-1 Naeshiro-cho Mizuho Nagoya, 467-8561 Japan
This product complies with FDA radiation performance standards, 21 CFR
Subchapter J.
Caution
Use of controls, adjustments or performance of procedures other than those
specified in this manual may result in hazardous invisible radiation exposure.
Caution
Changes or modifications not expressly approved by Brother Industries, Ltd. may
void the userÕs authority to operate the equipment. 
						

							126CHAPTER FOURTEEN
Federal Communications Commission (FCC)
Declaration of Conformity (For USA Only)
Responsible Party: Brother International Corporation
100 Somerset Corporate Boulevard
Bridgewater, NJ 08807-0911  USA
TEL: (908) 704-1700
declares, that the products
Product Name:  FAX 2750, FAX 3750
comply with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference
that may cause undesired operation.
Industry Canada Compliance Statement
(For Canada Only)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numŽrique de la classe B est conforme ˆ la norme NMB-003 du
Canada.
ImportantÑAbout the Interface Cable
A shielded interface cable should be used in order to ensure compliance with the
limits for a Class B digital device.
Changes or modifications not expressly approved by Brother Industries, Ltd.
could void the userÕs authority to operate the equipment.
Warranty
You must use the IEEE-1284 shielded cable provided by Brother Industries,
Ltd. (See ÒOrdering Accessories and Supplies,Ó p. 191)ÐÐORÐÐattach a free
filter core to your standard shielded printer cable. (To receive a free filter
core with instructions, call 1-888-879-3232 (USA) or 1-800-668-2768
(from within Canada) and order item number FCYL2.)
International Energy Star Compliance Statement
The purpose of the International Energy Star Program is to promote the
development and popularization of energy-efficient office equipment, which
includes computers, monitors, printers, facsimile receivers and copy machines
world-wide. As an International Energy Star partner, Brother Industries, Ltd.
has decided that this product meets the guidelines of the program. 
						

							127IMPORTANT INFORMATION
Important Safety Instructions
1Read all of these instructions.
2Save them for later reference.
3Follow all warnings and instructions marked on the product.
4Unplug this product from the wall outlet before cleaning. Do not use
liquid or aerosol cleaners. Use a damp cloth for cleaning.
5Do not use this product near water.
6Do not place this product on an unstable cart, stand, or table. The
product may fall, causing serious damage to the product.
7Slots and openings in the cabinet and the back or bottom are provided
for ventilation; to ensure reliable operation of the product and to
protect it from overheating, these openings must not be blocked or
covered. The openings should never be blocked by placing the product
on a bed, sofa, rug, or other similar surface. This product should never
be placed near or over a radiator or heater. This product should never be
placed in a built-in wall unit or cabinet unless proper ventilation is
provided.
8This product should be operated from the type of power source
indicated on the label. If you are not sure of the type of power
available, consult your dealer or local power company.
9This product is equipped with a 3-wire grounding type plug, a plug
having a third (grounding) pin. This plug will fit into only a grounding-
type power outlet. This is a safety feature. If you are unable to insert
the plug into the outlet, contact your electrician to replace your
obsolete outlet. Do not defeat the purpose of the grounding-type plug,
by using an adapter.
10Do not allow anything to rest on the power cord. Do not place this
product where people can walk on the cord.
11If an extension cord is used with this product, make sure that the total
ampere ratings on the products plugged into the extension cord do not
exceed the extension cord ampere rating. Also, make sure that the total of
all products plugged into the wall outlet does not exceed 15 amperes
(USA only).
12Never push objects of any kind into this product through cabinet slots,
since they may touch dangerous voltage points or short out parts
resulting in the risk of fire or electric shock. Never spill liquid of any
kind on the product. 
						

							128CHAPTER FOURTEEN
13Do not attempt to service this product yourself, as opening or removing
covers may expose you to dangerous voltage points and/or other risks, and
may void your warranty. Refer all servicing to a Brother Authorized Service
Center. A list of Brother Authorized Service Centers has been included for
your convenience, or you may contact the following Brother Customer
Service Numbers for your nearest Brother Authorized Service Center:
USA:1-800-284-4329 (voice)
1-908-575-8790 (fax)
1-800-521-2846 (Fax-Back System)
From within Canada:1-800-853-6660 (voice)
1-514-685-4898 (fax)
1-800-681-9838 (Fax-Back System)
From within Montreal:1-514-685-6464 (voice)
14This product has no main ON/OFF switch.  Therefore, it is very
important that you have easy access to the main plug and the main
socket to which the plug is connected, in case the main power to the
machine must be disconnected quickly.
15Unplug this product from the wall outlet and refer servicing to a
Brother  Authorized Service Center under the following conditions:
AWhen the power cord is damaged or frayed.
BIf liquid has been spilled into the product.
CIf the product has been exposed to rain or water.
DIf the product does not operate normally when the operating
instructions are followed. Adjust only those controls that are
covered by the operating instructions. Improper adjustment of other
controls may result in damage and will often require extensive work
by a qualified technician to restore the product to normal operation.
EIf the product has been dropped or the cabinet has been damaged.
FIf the product exhibits a distinct change in performance, indicating
a need for service.
16To protect your product against power surges, we recommend the use of
a power protection device (Surge Protector).