NEC Neax 2400 Ipx Office Data Specification

NDA-24298 CHAPTER 4
Page 537
Issue 1
ARTDN : Assignment of Route Class Data for NDM
6TCLTrunk Class
Specify the kind of trunk
  1 = DDD Line  2= FX
  3 = WATS Line
  4 = Tie Line/Announcement Trunk
  5 = CCSA  6 = Toll Terminal
  7 = CAS Line  8= Paging
  9 = Code Call Trunk 10 = Dictation Trunk
11 = General Paging Trunk
12 = Radio Paging Trunk 13 - 31 = Not used
7L/TLine/Trunk Identification
0 = Not used (Line) 1 = Trunk11111Always assign data “1.”
8RLPTrunk Release Pattern
0 = Calling Party Release...

CHAPTER 4 NDA-24298
Page 538
Issue 1
ARTDN : Assignment of Route Class Data for NDM
15 LSGLine Signal
0=Loop
1 = Ground Start C.O. Line
2=CDH
3 = Caller ID (Loop)
4=Loop
5 = E&M Tie Line
6=DX
7=24V4
8 = Loop DID 9 - 11 = Not used
12 = Speech Line (for CCIS No. 7 or Bch of ISDN)
13 = Signal Line (for CCIS No. 7 or Dch of ISDN)
14 = Not used 15 = Not used
16 SMDR2 Detailed Billing InformationSee Figure 4-16 and 
Table 4-22.
17 H/MHotel Service in CCIS No. 7
0 = Out of Service 1 = In Service
18MC...

NDA-24298 CHAPTER 4
Page 539
Issue 1
ARTDN : Assignment of Route Class Data for NDM
Figure 4-16    SMDR2 (ARTDN)
Table 4-22 SMDR2 (ARTDN)
CONTENTS/INPUT 0123456789101112131415
b00-Detailed billing is not required for incoming calls.××××
1-Detailed billing is required for incoming calls.××××
b10-Detailed billing is required for toll and local 
outgoing calls.
×× ××
1-Detailed billing is required only for toll outgoing 
calls.×× ××
b2, 30-
1-Metering pulses are used.××××
2-
3-
b0b1b2b3 
0/1: -/Incoming...

CHAPTER 4 NDA-24298
Page 540
Issue 1
ARTDN : Assignment of Route Class Data for NDM
LGRT
 1-899
FUNCTIONREMARKS
24 OC 0= -  
1 = Originating Category Information is used For MFC signaling
(Brazil and Mexico)
25 R/LAttendant-Identification of Incoming Trunk Display.
0 = TN, RT, TK display
1 = C.O. Line Number display
26 RVSDTrunk Reversal Identification 
This data is necessary when a specific Trunk route provides 
battery reversal for answer supervision.
0 = Battery Reversal System
1=Third Wire System
27...

NDA-24298 CHAPTER 4
Page 541
Issue 1
ARTDN : Assignment of Route Class Data for NDM
3 2 ICRLRelease timing for incoming trunk connections.
  0 = 288 msec.Note  1 = 224 msec.
  2 = 288 msec.   3 = 352 msec. 
  4 = 416 msec.   5 = 480 msec. 
  6 = 544 msec.   7 = 608 msec. 
  8 = 672 msec.   9 = 736 msec. 
10 = 800 msec. 11 = 864 msec. 
12 = 928 msec. 13 = 992 msec. 
14 = 1056 msec. 15 = 1120 msec. Normally assign 
data “0”. 
For ISDN, see Table 
4-23 (Example of 
Route Class Set-
tings).
Note:160 msec....

CHAPTER 4 NDA-24298
Page 542
Issue 1
ARTDN : Assignment of Route Class Data for NDM
39 BCC.O Line Idle Balance Condition.
0 = Not balanced 1 = BalancedFor Australia only
40 TCMTravel Class Mark
0 = Out of Service 1 = In Service
41 TDMQTandem Off Hook OG Queuing
0 = Out of Service 1 = In Service
42 TRSCTrunk Restriction class
0 = Out of Service 1-15= In ServiceSee AEFR command.
43 BT Inter-office Busy Service
0 = Out of Service 1 = In ServiceFor CCIS voice route, 
assign data “1.
44 PRVLine Trunk Privacy...

NDA-24298 CHAPTER 4
Page 543
Issue 1
ARTDN : Assignment of Route Class Data for NDM
56 SMDR3Detailed billing for outgoing in tandem connection. 
0 = Required 1 = Not requiredAssign this for the 
incoming route (ICRT), 
if necessary.
5 7 HDTHeterogeneous Data Trunk
0 = Not Heterogeneous Data Trunk
1 = Heterogeneous Data Trunk
58 CDConsecutive Dialing
0 = Out of Service 1 = In Service
59 CCHCommon Channel Handler 
0 = CCH is not mounted (normal setting)
1 = CCH is mounted (ISDN or CCIS line ) 0000Always...

CHAPTER 4 NDA-24298
Page 544
Issue 1
ARTDN : Assignment of Route Class Data for NDM
68 SCFSplit Call Forwarding 
The call is forwarded to the desired destination assigned at
0 = Split C. F. - All Calls (SSC, SID = 8), Split C. F. - 
Busy Line (SSC, SID = 10), Split C. F. - Don’t 
Answer (SSC, SID = 12)
1 = C. F. - All Calls (SSCA, SIDA = 86), C. F. - Busy 
Line (SSCA, SID = 87), C. F. - Don’t Answer (SS
CA, SIDA = 88)This data is valid when 
ASYDN, SYS,INDEX 
79, b2 = 1. 
69 SMDR4Detailed billing for...

NDA-24298 CHAPTER 4
Page 545
Issue 1
ARTDN : Assignment of Route Class Data for NDM
7 3 KPSTDuration of KP sending  
  0 = 48 msec.   1 = 56 msec. 
  2 = 64 msec.   3 = 72 msec. 
  4 = 80 msec.   5 = 88 msec. 
  6 = 96 msec.   7 = 104 msec. 
  8 = 112 msec.   9 = 120 msec.
10 = 128 msec.  11 = 136 msec. 
12 = 144 msec. 13 = 152 msec. 
14 = 160 msec. 15 = 168 msec.
(In case of MFC) 
  0 = 12.0 sec.   1 = 5.5 sec. 
  2 = 7.0 sec.    3 = 8.5 sec. 
  4 = 10.0 sec.   5 = 11.5 sec. 
  6 = 13.0 sec.   7 = 14.5...

CHAPTER 4 NDA-24298
Page 546
Issue 1
ARTDN : Assignment of Route Class Data for NDM
7 9 PPTMSender Prepares 
  0 = Standard   1 = 600 msec. 
  2 = 800 msec.   3 = 1000 msec. 
  4 = 1200 msec.   5 = 1400 msec.
  6 = 1600 msec.   7 = 1800 msec.
  8 = 2000 msec.   9 = 2200 msec.
10 = 2400 msec. 11 = 2600 msec. 
12 = 2800 msec. 13 = 3000 msec. 
14 = 3200 msec. 15 = 3400 msec.
(In case of MFC) 
  0 = 24.0 sec.   1 = 5.5 sec. 
  2 = 7.0 sec.   3 = 8.5 sec. 
  4 = 10.0 sec.   5 = 11.5 sec. 
  6 = 13.0 sec.   7...