Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual

							r 
TB loo-8502 
February 10, 1985 Page 1 of 2 
ersio -03 ms 
Some software errors have been discovered in the 
Version A-03A 
software that could cause difficulty in some applications. 
LCR will not advance tothemostexpensive route more than 15 times if the Warning 
Tone Allowed (WTA) prompt in the PAR sub-program of the DLCI Program is set to 
N. To correct this problem, set WTA prompt to Y. 
End-to-end signalling is not possible from an EKT when using LCR, and the most 
expensive route is selected when Warning Tone Allowed (WTA) prompt in DLCl- 
PAR is set to Y. When WTA is set to N end-to-end signalling is possible. 
It is not possible, usin 
to dial a Direct Distance Dialing Prefix (DDP) before a 
service code (such as 1 and still have the ability to dial a service code without a 
prefix (such as 911) on-interchangeable area code (ICC = N in the PAR 
sub-program of the DLCl Program). If ICC must be N, a direct trunk access for a 
1 ‘I call is suggested. 
ttendant Console operation: 
The Attendant Console, with a call on a loop key(LPK), cannot use the System Speed 
Dial feature to conference or provide a trunk-to-trunk connection. 
The Attendant Console cannot use LCR to add calls to an attendant conference-the 
attendant must use direct trunk access. 
Toll restricted stations (TOL = 0 - 8) that require the attendant console to access a 
trunk or LCR and dial a number (through dialing) will cause the trunk to disconnect 
after the DPT (DSYS Program) has timed out, unless the attendant depresses the 
loop key m before the release key m. 
Attendant Overflow: 
1) The Call Waiting (CW) LED on the attendant console does not extinguish when 
the incoming call is sent to the overflowfacility. Also, if the overflowcall returns 
to the console there is no tone burst. 
2) During an overflow call, the ring no answer timeout (RNA) does not agree with 
the programmed RNA prompt. 
Example: DSYS Program RNA= 12, but actual RNA timeout for the overflow 
station is 22 seconds. 
Toshiba America, km. 
Telecommunication Systems Division 
2441 Michelle Drive, Twtin, CA 92680 (714) 730-5000  
						

							TB 100-8502 
February 10, 1985 Page 2 of 2 
Traffic Measurement (DTRF Program): 
The trunk group outgoing usage (CCS) is calculated incorrectly. The value indicated 
must be divided by a factor of 2. 
Peripheral Equipment Test (TPER Program): 
When using the remote trunk test (CALLTNNX) portion of this program, the system 
will not dial some directory numbers (DN) properly. When a directory number with the 
digit “0” is entered, the system will pause instead of outputting the digit “0”. 
Conference Key: 
After an outgoing trunk call has been made via direct trunk access, the m/ key 
cannot be used until the Dial PauseTimer (DP,T) has timed out. When using LCR to place 
an outgoing call, the pl key can be used immediately. 
ccess to Services: 
If LCR is accessed to make an outgoing call and it selects a Specialized Common 
Carrier (SPCC) when using Remote Access to Services (incoming), only the first seven 
digits are dialed (the SPCC Authorization Code and dialed number are not output). 
irect Inward Dialing (DID) Station: 
The call forward busy (CFB) feature for a DID station, even though removed from 
the station class of service (DUOS Program), still forwards to the console when the DID 
station is busy. 
tandard 2500 set (DT 
If the QTRK Program answer supervision (ANS) prompt is set to Y, and a 2500 set 
station accesses an outgoing TIE trunk, then accesses an outgoing CO trunk through a 
second PBX, the DTMF receiver will remain connected to the station. Therefore, the CO 
trunk’s terminating end cannot hear the 2500 set station. Changing the ANS prompt to 
N allows the DTMF receiver to disconnect after the push-button timer (DSYS Program) 
has timed out. 
,  
						

							TB 100-8410 Page 1 of 2 
December I, 1984 
NEW SOFTWARE INT 
systems shipped after December 1,1984 will be equipped with 
Version A-03 software. 
Version A-03 offers all of the features available in the present Version A-02D plus 
the following: 
Least Cost outing-Provides automatic routing over alternate trunk facilities 
based on the dialed number and a customer-specified selection algorithm. 
Stated briefly; the LCR capabilities are as follows: 
Routing Tables - 15 
Routes (choices) per Route Table - 6 
Time of Day changes - 3 
Area Code Tables - 15 
Area/Office Code Tables - 16 
Modify Digit Tables - 12 
Enhanced Toll Restriction-provides toll restriction with 10 station classes. The 
6-digit restriction has 32 area/office code tables and can also deal with two 
Specialized Common Carriers (MCI, SPRINT, etc.) in either the present “Access 
Number and I.D. Code” method or the Equal Access (1 OXXX) method. 
LCD Display EKT-with Version A-03 software, erceptiun is compatible 
with the soon to be released EKT 2205 LCD telep ne. A maximum 
ofthirty(3()) 
of these 20-key LCD Display EKTs can be equipped. The features of the display 
Time and date 
Dialed number (manual or speed dial) 
Speed dial verification 
Availability of the EKT 2205 LCD will be announced via a separate bulletin. 
Direct Inward Dialing (DID)-requires a new LoopTrunk PCB called the DLSU. The 
DLSU occupies one DCOU position; serves four DID trunk lines and has a list 
price of $600. Availability of the DLSU will be announced via separate bulletin. 
CCSA Access* 
Remote Access to Services* 
DN lncrease- will accept up to 200 directory numbers. 
*See General Description 
Division of Toshiba America. Inc. 
2,441 >Iichelle Drive. Tustin, C.4 92680 (71.&I 730-x)00 
I I I l3usiness Park Drive. Armonk. K.Y lOSO-$ (9141 273. I750  
						

							TB 100-8410 Page 2 of 2 
December 1, 1984 
INT~OQ~~TI OFTVWARE (continued) 
Station Set Mix-automatic bridging (no privacy) is provided when a DN is shared 
by an EKT and a standard telephone. 
Chain Dialing From Standard Telephone-prior to the dialing timeout, multiple 
speed dial codes can be used from a 500/2500-type telephone. 
Call Waiting-changed to give the calling party MOH or silence instead of ringback 
tone. 
§MDF? Date Output-the date is printed once every hour. 
SMDFI/SPCC--the SMDR feature is enhanced to deal with SPCC (MCI, SPRINT, 
etc.) calls by absorbing the access number and authorization code and printing 
only the final DDD number. 
SMQFI-the following condition codes are added: 
P = Date/Time Change 
Q = System Initialize 
S = Date Printed (occurs at 60-minute intervals) 
Toshiba Telecom intends to update all existing systems with Ver- 
sion A-03 software, and is presently formulating a progra hat will accomplish this 
plan. Shortly, via a separate bulletin, all dealers will be informed of the specific details. 
Version -03 Installation Procedure-if the system is operating with Version 
A-02D software, proceed as follows: 
1) Remove Version from disk drive and insert Version A-03. 
2) Perform data dump (DDMP) procedure. 
3) Customer data is now on Version 
-03 by depressing load switch. (System down for approximately 30 
seconds.) 
EKT, DSTT, and DTGP Programs willequal None-which 
means No Toll Restrict!on. 
5) Program customer data to include new features as required. 
Programming Procedures, Section 00-100-300, of the erceptiorf ln- 
stallation 24 Maintenance Manual is being revised to include the new software. A 
preliminary version of the revised manual section is attached, and will be replaced with 
a finalized version as quickly as possible. 
IlWPORTANT NOTE: 
Do not dwmp data (~5~P) from Version A-03 to Version A-02D diskette.  
						

							LDN #I Night Number NT1 
LDN #2 Night Number NT2 
Busy Lamp Field #1 BLfl 
Busy Lamp Field #2 
8LF2 
Overflow DN-Attendant Console ##O 
ClFLl 
Overflow DN-Attendant Console #I 
OFL2 
Message Center-Tenant #O 
MC0 
Message Center-Tenant #l 
flC1 
Meet-me Page DN NNP 
Remote Access DN 
REtI 
Remote Access Change Code 
RW 
‘I*” Access Code 
FCC* 
“#“ Access Code 
FCC~ 
Camp-on (or CWT) Timeout 
COT 
Ring No Answer Timeout 
RN$ 
Attendant Overflow Timeout 
flOF 
Call Forward No Answer Timeout 
CFD 
Hold (500/2500) Timeout 
HLD 
’ [CR 1~ Depress Carriage Return.  
						

							Feature 
*Enter the name and access code in this column.  
						

							Not Used 
HFA Ewipped? 
Display EKT? 
Prime DN only! MTQ N N 
N N N N N N 
HFR 
DIS 
KEY 0 
KEY 1 
UEY 2 
KEY 3 
l
						

							IVOTE: Use multiple sheets as required. Sheet 
of  
						

							NOTE: Use multiple lines as required.