Lexmark C 950 Service Manual

							Diagnostic aids 3-39
  5058-030
Go Back Previous
Next
Paper jam in the top cover
1.Gently move the tray to the left until it stops.
2.Open the top cover.
12
2 
						

							3-40  Service Manual 5058-030  
Go Back Previous
Next
3.Firmly grasp the jammed paper on each side, and then gently pull it out.
4.Close the top cover.
5.Gently put the tray back into position.
6.If necessary, touch Continue, jam cleared from the printer control panel. 
						

							Diagnostic aids 3-41
  5058-030
Go Back Previous
Next
250 paper jam
1.Remove any jammed pages from the multipurpose feeder.
2.Load paper into the multipurpose feeder.
3.If necessary, touch Continue, jam cleared from the printer control panel.
281 paper jam
Paper jam in door A
1.Open door A.
2.Determine where the jam is located, and then remove it:
2.1If the paper is visible under the fuser, then firmly grasp it on each side, and pull it out.
Note:  Make sure all paper fragments are removed.
2.2If the paper is not visible, then you will need to remove the fuser unit.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow 
the surface to cool before touching. 
						

							3-42  Service Manual 5058-030  
Go Back Previous
Next
Warning:  Do not touch the center of the fuser unit. Doing so will damage the fuser.
a.Remove the thumbscrew from each side of the fuser unit by rotating each one 
counterclockwise.
b.Lift the handles on each side of the fuser, and then pull to remove the fuser unit.
2.3Firmly grasp the jammed paper on each side, and then gently pull it down and out.
Notes:  
•Make sure all paper fragments are removed.
•If the paper is in the fuser, then lower the fuser nip release lever, and switch it to envelope 
mode.
•After removing the jammed paper, return the lever to the proper position.
2.4Align the fuser unit using the handles on each side, and then place it back into the printer.
3.Close door A.
4.If necessary, touch Continue from the printer control panel.
2
11
2
1
1
22 
						

							Diagnostic aids 3-43
  5058-030
Go Back Previous
Next
Paper jam in cover F (paper transport)
1.Open cover F.
2.Firmly grasp the jammed paper on each side, and then gently pull it out.
Note:  Make sure all paper fragments are removed.
Note:  If the paper jam is difficult to remove, then rotate the knob counterclockwise.
3.Close cover F.
4.If necessary, touch Continue from the printer control panel. 
						

							3-44  Service Manual 5058-030  
Go Back Previous
Next
4yy.xx paper jams
Paper jam in door H
1.Open door H.
Note:  Door H is located between the finisher exit bins.
2.Firmly grasp the jammed paper on each side, and then gently pull it out.
Note:  Make sure all paper fragments are removed.
3.Close door H.
4.If necessary, touch Continue from the printer control panel. 
						

							Diagnostic aids 3-45
  5058-030
Go Back Previous
Next
Paper jam in door G
1.Open door G.
2.Lift cover G1 lever.
3.Firmly grasp any jammed paper, and then gently pull it out.
Note:  Make sure to remove all paper fragments after gently pulling out any jammed paper inside door G.
4.Move cover G2 to the right, and then remove any jammed paper.
Note:  If the paper is jammed in the rollers, then rotate knob G3 counterclockwise.
AreaCover, knob, or handle name
1Cover G1
2Cover G2
3Knob G3
4Cover G4
5Cover G7
6Knob G8
7Handle G9
1
2
3
4
5
6
7 
						

							3-46  Service Manual 5058-030  
Go Back Previous
Next
5.Move cover G4 down, and then remove any jammed paper.
6.Move cover G7 to the left, and then remove any jammed paper.
7.Pull handle G9 until the tray is completely open.
8.Lift the inside cover. If the paper is jammed in the rollers, then rotate knob G8 counterclockwise, and then 
remove the jammed paper.
9.Close door G.
10.If necessary, touch Continue from the printer control panel. 
						

							Diagnostic aids 3-47
  5058-030
Go Back Previous
Next
Paper jam in cover F (paper transport)
1.Open cover F.
2.Firmly grasp the jammed paper on each side, and then gently pull it out.
Note:  Make sure all paper fragments are removed.
Note:  If the paper jam is difficult to remove, then rotate the know counterclockwise.
3.Close cover F.
4.If necessary, touch Continue from the printer control panel. 
						

							3-48  Service Manual 5058-030  
Go Back Previous
Next
455 staple jam
1.Open door G.
2.Press the latch to open the stapler door.
Note:  The stapler door is located behind the finisher.
3.Lower the latch of the staple cartridge holder, and then pull the staple cartridge holder out of the printer.