Lexmark C 950 Service Manual

							Repair information 4-27
  5058-030
Go Back Previous
Next
10.Using a flat-blade screwdriver, release the three hooks (B) securing the ATC sensor PCB to the machine.
11.Remove the ATC sensor PCB.
Re-installation note: When replacing the ATC sensor PCB, ensure that the five connections are properly 
reconnected.
B 
						

							4-28  Service Manual 5058-030  
Go Back Previous
Next
Bridge PCBA removal
1.Remove the rear upper cover. See “Rear upper cover removal” on page 4-16.
2.Disconnect the input option cable (A).
3.Remove the eight screws (B) securing the PCBA door to the machine. 
						

							Repair information 4-29
  5058-030
Go Back Previous
Next
4.Release the two clamps (C) to release the harness.
5.Swing the PCBA door open.
6.Remove the RIP PCBA. See “RIP PCBA removal” on page 4-147. 
						

							4-30  Service Manual 5058-030  
Go Back Previous
Next
7.Disconnect all the cables from the bridge PCBA.  
						

							Repair information 4-31
  5058-030
Go Back Previous
Next
8.Remove the six screws (D) securing the bracket.
9.Gently detach the bridge PCBA from the upper engine PCBA.
10.Remove the bracket.
11.Remove the three screws (E) securing the bridge PCBA to the bracket.
12.Remove the bridge PCBA.
C toner auger removal
1.Remove the printer front door. See “Printer front door removal” on page 4-10.
2.Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-175.
3.Remove the waste toner box. 
4.Remove the four photoconductor units.
5.Remove the four toner supplies.
6.Remove the operator panel front cover. 
7.Remove the printhead retract door. See “Printhead retract door removal” on page 4-142.
8.Remove the inner cover. See “Inner cover removal” on page 4-3.
9.Remove the inner plate. See “Inner plate removal” on page 4-95. 
						

							4-32  Service Manual 5058-030  
Go Back Previous
Next
10.Lift the plastic gate, and push it in to prevent the toner from spilling.
11.Squeeze the two latches (A) to release the upper part of the auger.
12.Detach the lower portion (B) of the auger from the developer unit.
1
2 
						

							Repair information 4-33
  5058-030
Go Back Previous
Next
Warning:  The lower portion (B) of the auger is prone to damage. Extra care is required in handling this part.
A
B 
						

							4-34  Service Manual 5058-030  
Go Back Previous
Next
13.Remove the C toner auger.
Re-installation note: Ensure that the rubber sleeve (C) is attached properly to prevent toner spillage. 
Center exhaust fan removal
1.Remove the rear upper cover. See “Rear upper cover removal” on page 4-16.
2.Disconnect the input option cable (A).
C 
						

							Repair information 4-35
  5058-030
Go Back Previous
Next
3.Remove the eight screws (B) securing the PCBA door to the machine.
4.Release the two clamps (C) to release the harness.
5.Swing the PCBA door open. 
						

							4-36  Service Manual 5058-030  
Go Back Previous
Next
6.Locate the fan (D).
7.Disconnect the cable (E) and then push the two latches (F) to release the fan.
8.Remove the center exhaust fan.