Canon printer PIXMA MG5720 User Manual

							The setting is enabled after this. When you want to disable this function, select Disable from the list
according to the same procedure.
Note

						

							Reducing the Printer NoiseThe silent function allows you to reduce the operating noise of this printer. Select when you wish to reduce
the operating noise of the printer at night, etc.
Using this function may lower the print speed.
The procedure for using the quiet mode is as follows:
 Quiet Settings
1.
Open the printer driver setup window
2.
Click  Quiet Settings  on the Maintenance  tab
The  Quiet Settings  dialog box opens.
Note

						

							Note
						

							Changing the Printer Operation ModeIf necessary, switch between various modes of printer operation.
The procedure for configuring  Custom Settings is as follows:
 Custom Settings
1.
Open the printer driver setup window
2.
Make sure that the printer is on, and then click  Custom Settings on the Maintenance
tab
The  Custom Settings  dialog box opens.
Note

						

							Don't detect mismatch of paper settings when printing from computerWhen you print documents from your computer and the paper settings on the printer driver and
the cassette paper information registered on the printer do not match, this setting disables the
message display and allows you to continue printing.
To disable detection of paper setting mismatches, select this check box.
Ink Drying Wait Time You can set the length of the printer rest time until printing of the next page begins. Moving the
slider to the right increases the pause time, and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page
dries, increase the ink drying wait time. Reducing the ink drying wait time speeds up printing.4.
Apply the settings
Click  OK and when the confirmation message appears, click  OK.
The printer operates with the modified settings hereafter.
245 
						

							Changing Settings from Operation Panel
Changing Settings from Operation Panel
Print settings
LAN settings
Device user settings
PictBridge print settings
Language selection
Firmware update
Cassette settings
Reset setting
ECO settings
Quiet setting
246 
						

							Changing Settings from Operation PanelThis section describes the procedure to change the settings in the  Device settings screen, taking the steps
to specify  Extended copy amount  as an example.1.
Make sure machine is turned on.
2.
Select  Setup  on HOME screen.
LCD and Operation Panel
3.
Select  Device settings  and press OK button.
The  Device settings  screen is displayed.
4.
Use  button to select setting item and press  OK button.
The setting screen for the selected item is displayed.
5.
Use  button to select menu and press  OK button.
6.
Use  button to select setting item and press  OK button.
247 
						

							You can select the setting menus below.
Print settings
LAN settings
Device user settings
PictBridge print settings
Language selection
Firmware update
Cassette settings
Reset setting
Note

						

							Print settings
						

							LAN settings