Mitel Sx 200 Ml Pabx Lightware 16 Instructions Guide

							Appendix B - Blank CDE Forms 
FFORM 09 - “EXPAND PKWSUBFORM 
Programmable Key Module Lines 
Sheet of 
PKM/KEY TYPE DIR RING 1 SEC 1 DSS EXJ NUM TRK NUM WBEL 
I 01 1 Prime 1 In/Out 1 lmmed 1 No 1 No 1 I I I 
03 
04 
05 
06 
07 
I I I I I I I I 
oq 
09 
10 
11 
12 
13 
14 
15 
16 t 
17 
18 
19 
20 
21 
22 
29 
30 
31 
32 
The PKM is only associated with SUPERSE~470, SUERSE~420, and SUPERSET telephones. 
March 1997 issue 1 Revision 0 B-19  
						

							Customer Data Entry 
FORM 10 - PICKUP GROUPS 
sheet of 
 GROUP NUMBER (I- 50): 
EXTENSION NUMBERS 
I GROUP NUMBER (1 - 50): 
GROUP NUMBER (I - 50): 
B-20 Issue 1 Revision 0 
March 1997  
						

							Appendix B - Blank CDE Forms 
FORM II - DATA CIRCUIT DESCRIPTORS 
DESCRIPTOR NUMBER OF DATA CIRCUITS ASSIGNED l COMMENTS 
1 
12 
13 
17 
18 
19 
20 
21 
22 
23 
24 
25 
*This field is automatically updated by the system based on entries in Form 12. 1 
March 1997 
Issue 1 Revision 0 B-21  
						

							Customer Data Entry 
DATA CIRCUIT DESCRIPTOR Ol=WOlVS 
‘Select Option” Subform of Form I I 
1 DATA CIRCUIT DESCRIPTOR NUMBER (1 - 25) 
OPTION NAME 1 -’ i-21 -3 l-4 l-5 1-6 l-7 l-8 l-9 I-0 
Session Inactivity Disconnect Timer 
0 - 255 minutes 
Guard Timer 
0 - 99 seconds 
Minimum Baud Rate 
110,150,300,600, 1200,2400,4800,9600 or 19.2K 
Default Baud Rate 
110,150,300,600,1200,2400,4800,9600 or 19.2K 
Maximum Baud Rate 
110, 150,300,600,1200,2400,4800,9600 or 19.2K 
Always Use Default Baud Rate When Called 
YES or NO 
DTR Off Disconnect Timer 
0 - 99 seconds 
DTR to CTS Delay Timer 
0 - 9900 msec (100 msec increments) 
DTR Forced High 
YES or NO 
RTS Forced High 
YES or NO 
DSR is Held High When Device is Idle 
YES or NO 
CTS is Held High When Device is Idle 
YES or NO 
Originate A DTRX Call With a Low +-High 
of DTR Transition 
R YES or NO I II 
I I I I I II 
Action Taken if the Idle DTE has DTR Low (Auto-An- 
swer) 
TOGGLE RI, RAISE DSR, RAISE DCD or REFUSE 
Pooled Modem Communication Established lndica- 
tor 
DCD or DSR 
First Modem Tone 
2025,210O or 2225 Hz 
Second Modem Tone 
2025,210O or 2225 Hz 
ASYNC: Keyboard Origination Allowed (Auto Baud) 
YES or NO 
$4 
ASYNC: ADL Auto Baud 
YES or NO 
ASYNC: Flow Control 
CTS, XON/XOFF, NONE, PIN 25HVCTS or PIN 
I I I I I I I I I I 
25LO/CTS 
I I 
Page 1 of 2 
B-22 Issue 1 Revision 0 March 1997  
						

							Appendix B - Blank CDE Forms 
DATA CIRCUIT DESCRIPTOR NUMBER (1 - 25) 
OPTION NAME 
ASYNC: XON Character 
0 -127, Decimal value of ASCII code 
ASYNC: XOFF Character 0 -127, Decimal value of ASCII code 
ASYNC: Break Key Function SYS ATT or TRANSPARENT 
ASYNC: PBX Attention Character 0 -127, Decimal value of ASCII code 
ASYNC: Parity ODD, EVEN, NONE, SPACE or MARK 
ASYNC: Character Length 7 or 8, 8 implies *no parity” 
ASYNC: Number of Stop Bits 
1 or2 -1 
-2 -3 -4 -5 -6 -7 -a -9 -0 
ASYNC: Autobaud to Host Character 1 0 -127, Decimal value of ASCII code 
ASYNC: Autobaud to Host Character 2 0 -127, Decimal value of ASCII code 
ASYNC: Delay Between Autobaud Characters 0 - 1270 msec (10 msec increments) 
DS2lOO:Operating Mode ASYNCHRONOUSorSYNCHRONOUS 
SYNC: Rate Adaptation Scheme MiNET or X.31 
SYNC: Clock Source INTERNAL, SYSTEM, TX EXT or TX & RX EXT 
Page 2 of : 
March 1997 issue 1 Revision 0 B-23  
						

							Customer Data Entry 
FORM 12 - DATA ASSIGNMENT 
Sheet of 
B-24 Issue 1 Revision 0 March 1997  
						

							Appendix B - Blank CDE Forms 
FORM 13 - TRUNK CIRCUIT DESCRIPTORS 
DESCRIPTOR TRUNK TYPE COMMENTS 
1 
I 
2 
I 
3 
4 
I 
5 I 
6 
I 
7 
8 
9 
10 
11 
12 
13 
14 
15 
16 
17 
18 
19 
I 
20 
I I I 
21 
I 
23 I 
24 I 
25 I 
March 1997 Issue 1 Revision 0 B-25  
						

							Customer Data Entry 
4Circuit CO/4-Circuit DISA Tanks 
‘Select Option” Subfotm of Form 13 
sheet of 
4-CIRCUIT CO TRUNK and 
TRUNK CIRCUIT DESCRIPTOR NUMBER (1 - 25) 
4-CIRCUITDISATRUNKOPTIONS 
Page 
1 of 11 
B-26 Issue 1 
Revision 0 March 1997  
						

							Appendix B - Blank CDE Forms 
6-Circuit CO/6-Circuit DISA Tanks 
‘Select Optiod Subfom of Form 13 
Sheet of 
Page I of 1 
March 1997 Issue 1 Revision 0 B-27  
						

							Customer Data Entry 
E&M Module/ E&M Module USA links 
ttSelect Option” Subfom of Form 13 
Sheet of 
E&M MODULE and 
TRUNK CIRCUIT DESCRIPTOR NUMBER- 
E&M MODULE DISA OPTIONS 
Outgoing Start Type 
Outpulse Delay Timer 100 - 2000 ms (100 ms inc) 
Flash Timer 200 - 700 ms (100 ms inc) 
Flash Type LOOP FLASH or RING GROUND 
Flash Over Trunk 
YES or NO 
Interdigit Timer 300 - 800 ms (100 ms inc) 
Wait For Delay Timer 
300 - 5000 ms (100 ms inc) 
Remote End is a Satellite 
YES or NO 
Remote End is a Satellite with OPS LinesYES or NO 
Page I of I 1 
I I 
B-28 Issue 1 Revision 0 
March 1997