Canon printer PIXMA MG7520 User Manual

							(D) 0.25 inch (6.3 mm)
181 
						

							EnvelopesSizeRecommended Printing Area (width x height)Envelope DL3.88 x 7.07 inches (98.8 x 179.6 mm)Envelope Com 103.68 x 7.90 inches (93.5 x 200.9 mm)
 Recommended printing area
(A) 0.12 inch (3.0 mm)
(B) 1.47 inches (37.4 mm)
(C) 0.22 inch (5.6 mm)
(D) 0.22 inch (5.6 mm)
182 
						

							Printable DiscsThe printing area of the printable disc is from 0.67 inch (17 mm) of the internal diameter to 0.04 inch (1 mm)
from the external diameter of the printing surface.
 Recommended printing area
(A) 0.67 inch (17.0 mm)
(B) 0.04 inch (1.0 mm)
183 
						

							Placing a Printable Disc
Cautions When Printing on a Printable Disc
Before Placing a Printable Disc
Placing a Printable Disc
Removing a Printable Disc
How to Detach / Attach the Disc Tray
184 
						

							Cautions When Printing on a Printable Disc•
Be sure to use the disc tray supplied with this machine. It has a "J" on the upper side.
•
Do not print on printable discs that are not compatible with inkjet printing. The ink will not dry and may
cause problems with the disc itself or devices which the disc is loaded onto.
•
Do not print on the printable discs' recording surface. Doing so will make data recorded on discs
unreadable.
•
Hold the printable discs by their edges. Do not touch either the label surface (printing surface) or recording surface.
•
Remove any dirt from the disc tray before placing printable discs on the disc tray. Loading discs in a
dirty disc tray may scratch the recording surface of the discs.
•
After printing, allow the printing surface of the disc to dry naturally. Do not use hairdryers or expose the disc to direct sunlight to dry the ink. Do not touch the printing surface until the ink has dried.
•
Do not attach the disc tray while the machine is in operation.
•
Do not remove the disc tray while printing on printable discs. Doing so may damage the machine, thedisc tray, or the disc.
•
Do not get dirt or scratches on the reflectors of the disc tray. The machine may not be able to recognizeloading of the printable disc, or printing may become misaligned. If the reflectors on the disc tray
become dirty, wipe the reflector clean with a soft and dry cloth, taking care not to scratch the plate.
•
The disc tray may become dirty if software other than My Image Garden is used.
•
Always close the disc tray guide after printing on printable discs.
•
To keep the print quality at an optimal level, it is recommended to stop printing discs once every ten discs when printing more than ten discs continuously.
To stop the printing operation, detach the disc tray from the machine, then close the disc tray guide.
After approximately three minutes have elapsed, open the disc tray guide, attach the disc tray to the
machine, then resume printing.
185 
						

							Before Placing a Printable DiscThe following items are needed to print onto the printable disc:•
disc tray (supplied with the machine)
* Use the disc tray with "J" on the surface.
The disc tray is attached in the back of the cassette 1.
How to Detach / Attach the Disc Tray
•
4.72 inches (12 cm) printable disc
Obtain a printable disc with a label surface compatible with inkjet printing.
Note
•
A "printable disc" differs from regular disc (BD/DVD/CD, etc.) in that its label surface has been specially processed to be printed on by an inkjet printer.
186 
						

							Placing a Printable DiscTo print onto a printable disc, place it on the disc tray supplied with the machine, then insert it into the
machine.
This procedure also applies to printing from a computer.
Important
•
Do not attach the disc tray until the message asking you to load the printable disc is displayed. Doing
so can damage the machine.
1.
Detach the disc tray from the cassette 1.
How to Detach / Attach the Disc Tray
Note
•
If a message is displayed on the screen after inserting the cassette into the machine, tap Register .
2.
Holding both sides of the paper output tray (A), gently open it.
3.
When the message asking you to load the printable disc is displayed, open the disc tray
guide (B) and push it down all the way to the bottom.
4.
Place the printable disc with the printable surface facing up.
Important
•
Make sure that there is no dirt on the disc tray before placing a printable disc on the disc tray.
•
When placing a printable disc on the disc tray, do not touch the printing surface of the disc or the reflectors (C) on the disc tray.
187 
						

							5.
Attach the disc tray to the machine.
Note
•
The disc tray may be ejected after a specified period of time has elapsed. In this case, follow the
on-screen instructions to attach the disc tray.
1.
Place the disc tray on the disc tray guide.
2.
Insert the disc tray straight until the arrow () on the disc tray guide is almost aligned with
the arrow (
) on the disc tray.
Important
•
Do not insert the disc tray beyond the arrow () on the disc tray guide.
188 
						

							Removing a Printable Disc1.
Pull out the disc tray.
2.
Close the disc tray guide.
Important
•
If the disc tray guide is opened, you cannot print on paper as it will not feed properly. Make sure
that the disc tray guide is closed.
3.
Remove the printable disc from the disc tray.
Important
•
Do not touch the printing surface when removing the disc from the disc tray.
Note
•
Dry the printing surface sufficiently before removing the disc. If you see printing on the disc tray or
the transparent parts on inner or outer diameter of the printable disc, wipe them off after the
printing surface has dried.
189 
						

							4.
Close the paper output tray.
5.
Attach the disc tray onto the cassette 1.
How to Detach / Attach the Disc Tray
Note
•
If a message is displayed on the screen after inserting the cassette into the machine, tapRegister .
190