GTE Omni Si Database Technical Practices Manual

							TL-130400-1001Table 21.1
CPG Error Messages (Continued)CPG ERROR
MESSAGESTITLE
DESCRIPTION OF MESSAGES
FR-65
G&lADMPIDCP
ADMP AND DCP CARDS MUST BE ON A PRIMARY BUS
CARDS MUSTSEGMENT.
BE ON PRIMARY
(A PRIMARY BUS SEGMENT CONTAINS A PACKET
BUS SEGMENT
ROUTER OR A PACKET BUS EXTENDER).
DUPLICATE
THE SPEED CALLING ACCESS CLASS MUST BE
SPEED CALLINGUNIQUE ACROSS THE GC RECORDS.
ACCESS GROUP
GC-52RANGE OF 
SP.THE SPEED CALLING LIST NUMBERS MUST BE
LIST NOS. OUT
SPECIFIED IN SETS OF FOUR STARTING WITH 0. IF
OF ORDER.
THEY ARE NOT SPECIFIED IN THE SAID ORDER, THE
NEAREST
FIRST ENTRY NUMBER AND LAST ENTRY NUMBER
MULTIPLE OF 4
ALLOTTEDWILL BE ADJUSTED ACCORDINGLY (PLUS OR MINUS)
TO THE NEAREST MULTIPLE OF FOUR. FOR
EXAMPLE, USER SPECIFIES AS FOLLOWS:
FIRST ENTRY NUMBER IS 2, LAST ENTRY NUMBER IS
6FIRST ENTRY NUMBER IS 20, LAST ENTRY NUMBER IS
50THE ENTRY NUMBERS ACTUALLY SHOULD HAVE
BEEN:
FIRST ENTRY NUMBER IS 0, LAST ENTRY NUMBER IS
7FIRST ENTRY NUMBER IS 20, LAST ENTRY NUMBER IS
51GC-53ELEMENTS
THE LAST ENTRY NUMBER CANNOT BE LESS THAN
HAVETHE FIRST ENTRY NUMBER.
INCOMPATIBLE (GCGEN)
VALUES
GS-01
GS-51VALUES TO BE
SPEED CALLING NUMBER DIGITS
FILLED LEFT TODIGITS SHOULD BE FILLED IN FROM LEFT TO RIGHT
RIGHT
WITH NO 
IMBEDDED DASHES.
DUPLICATETHE SPEED CALLING LIST NUMBER MUST BE UNIQUE
SPEED CALLING ACROSS THE GS RECORDS.
LIST NUMBER
HD-01MAXIMUM
NUMBER OF
HUNDREDS
GROUPS
EXCEEDEDTHE MAXIMUM NUMBER OF HUNDREDS GROUPS
SUPPORTEDBYTHESVRHASBEENEXCEEDED.
(GENLIN)
SVR 5210
8187D-465 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)
DESCRlPTlQl’l OF MESSAGES
(TABGEN/GENLIN)ENGINEERED ON A PREVIOUS HD RECORD.
ALLOWABLE VALUES OF
DESTINATION TYPEINTERCEPT DESTINATION
LN0000-9999 (A ROOM NUMBER)
AT0001-0255 (ANY COMBINATION OF
THE EIGHT ATTENDANTS)
RA 0000-0127
PEC AND TRUNK NUMBER,
XYW, WHERE X IS PEC AND
WY IS TRUNK NUMBER
RL 
0000-0000 (RLT NUMBER)
TI0000-0031 OR 0063 (TIE TRUNK GROUP
NUMBER
m-51DUPLICATE
INTERCEPT
ROUTING
NUMBERINTERCEPT ROUTING NUMBER MUST BE UNIQUE
ACROSS THE IR RECORDS.
IR-53REQUIRED
VALUE NOT
FOUND ON
LISTED FORM
m-53ATTENDANT
NOT FOUND
IR-53RLT NUMBER
NOT FOUND
D-4668l87SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
TRUNK GROUP
A. IF THE DESTINATION TYPE IS ‘AT’, THE
ANNOUNCERDESTINATION MUST BE A VALID ATTENDANT CIRCUIT
ON AN AT RECORD.
B. IF THE DESTINATION TYPE IS ‘RA’, THE
DESTINATION MUST BE A VALID RECORDER
ANNOUNCERONATCRECORD
C. IF THE DESTINATION TYPE IS ‘LN’, THE
DESTINATION MUST BE A VALID LINE STATION
NUMBER ON AN LD RECORD.
D. IF THE DESTINATION TYPE IS 
‘TI’, THE
DESTINATION MUST BE A VALID TRUNK GROUP
CANBE PLACEDIN THE SAME CARD’SLOT.
DEFINED ON FR
INCOMPATIBLE
WITH FCN OF
CARD
KD-52CARD TYPE
DEFINED ON FR
INCOMPATIBLE
WITH INCOMING
CARD TYPE
KD-52FUNCTION OFPHYSICAL LOCATION
CARD NOTTHE PEC, GROUP, SLOT AND CIRCUIT FUNCTION
ALLOWED FORSPECIFIED MUST BE VALID FOR THE CARD TYPE
CARD TYPEDEFINED ON FR (FOR THIS PEC TYPE).
DEFINED ONKEDU CIRCUIT MUST APPEAR ON A KEDU CARD.
FORM FR
(PHYLOC)
IF THE CARD TYPE IN THE MESSAGE IS “OVER”,
THAT INDICATES THAT A CARD IN THE PREVIOUS
LOCATION IS A WIDE CARD AND IT OVERHANGS INTO
THIS 
PYHSICAL LOCATION ON FR.
SVR 5210
8h37D-467 
						

							 rTL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
THE
PEC,GROUP, SLOT AND CIRCUIT SPECIFIED
BE VALID FOR THIS PEC TYPE.
AND CIRCUIT SPECIFIED FOR
T BE UNIQUE.
OVERHANGS
PREVIOUSLYTHIS CARD IS AN OVERSIZED CARD AND IS TRYING
TO FILL TWO SLOTS. OF THE TWO SLOTS IT FILLS,
THE RIGHT HAND ONE HAS ALREADY BEEN FILLED.
KD-54
KD-55
KD-56PEC NUMBER IS THE PEC NUMBER SPECIFIED MUST BE MARKED
NOT EQUIPPEDEQUIPPED ON THE OE OR OF RECORD.
OPI CARD NOTTHE PMS EQUIPPED FIELD IS SPECIFIED FOR THE
EQUIPPED
KEDU, BUT THE OPI CARD IS NOT EQUIPPED OF FR.
ONLY ONE
THE PMS EQUIPPED FIELD IS SPECIFIED FOR THE
KEDU MAYMORE THAN ONE KEDU.
HAVE PMS
KD-57OPI CARD ON
FOR THE PMS FEATURE TO WORK PROPERLY, BOTH
FR REQUIRESAN OPI CARD AND A KEDU WITH PMS ARE REQUIRED.
KEDU WITH
(ENDCHK)
PMS
KD-58PMS KEDU
REQUIRES
PRINTER ON
THE SAME
CARDFOR THE PMS FEATURE TO WORK PROPERLY, A
PRINTER MUST BE ENGINEERED WITH THE PMS
KEDU.
(ENDCHK)
D-4688187SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
ALLOWABLE VALUES OF
FUNCTION ACCESS DIGIT 2
IF AN ACCESSDIGIT ISINDICATEDFOR A SPECIFIC
FUNCTION CODE,
ASSIGNMENT
THAT FUNCTION ON THE AL RECORD ASSOCIATED
ON AL FORMWITH THE KEDU NUMBER.
MESSAGE METER ROOM STATUS
KEDU STATUS PRINTER STATUS PRINTER
CODE NO
IDIDAL 0 AL
01-- --
LA-51RECKEDU FUNCTIONDIGITS ALLOWED
CODE NOCODE 01 234567
KS 0 MM0 1 
- - - - - -ALLOWED
KS 0 RS0 1 
- - - I - - INCORRECT
LINE APP MUSTTHE LINE DIRECTORY NUMBER SPECIFIED AS THE
BE ONFEATUREPHONE WAS NOT SPECIFIED AS A
MULTILINEMULTILINE FEATUREPHONE ON AN LD RECORD.
FEATURE-(GENLIN)
PHONE
LA-51LINE APP MUSTTHE DIRECTORY NUMBER SPECIFIED AS THE
BE ONFEATUREPHONE IS NOT A FEATUREPHONE PRIME
FEATUREPHON CONTROL LINE.
E PRIME(GENLIN)
CONTROL LINE
SVR 5210
8187D-469 
						

							 rTL-130400-I 001
Table 21.1CPG Error Messages (Continued)DESCRIPTIQN OF MESSAGES
RECORD OR A
POTSLINE WAS SPECIFIED.
NUMBER OFMORETIMES THANTHESYSTEMSVR ALLOWS.
APPEARANCE WAS SPECIFIED AS AN IDENTICAL
APPREARANCECE ON THE FEATUREPHONE ON A
THIS IS A WARNING MESSAGE SINCESOME TYPES OF
LINE APPEARANCES ARE ENGINEERED ON LD
RECORDS AND AN LA RECORD IS A DUPLICATE
ENTRY FORDOCUMENTATIONPURPOSES.
CARD WEREEXCEEDED.
E CONFLICTSEN THE
MULTILINkFEATUREPHONEFIELD ONLM
D-4708187SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)
ZPG ERROR
MESSAGESTITLEDESCRIPTION OF MESSAGES
l-A-60SINGLE LINEIF THE MULTILINE FEATUREPHONE FIELD ON LM IS
FEATUREPHON DASHED 
’E CANNOT BE A(THE FEATUREPHONE IS A SINGLE LINE SET),
‘: LINETHEN IT CANNOT BE A LINE APPEARANCE...^APPEARANCE(GENLIN)
LA-61A VISUAL CALLA VISUAL CALL PARK LINE (SPECIFIED ON RECORD
PARK LINECODE LD AS LINE TYPE, ‘VP’, CANNOT BE A LINE
-CANNOT BE AAPPEARANCE SINCE IT IS A SINGLE LINE).
LINE(GENLIN)
APPEARANCE
LA-70FEATUREPHONTHE LINE DIRECTORY NUMBER SPECIFIED AS THE
E LINE NOTFEATUREPHONE WAS NOT SPECIFIED ON AN LD
FOUNDRECORD.
(GENLIN)
LA-99
SITE HAST7050 ENTRY FOR LINE SOFTWARE ID
INCONSISTENTAN ENTRY IN T7050, LINE APPEARANCE TABLE, FOR
DATA BASETHE INDICATED LINE SOFTWARE ID REPRESENTS AN
INVALID LINE APPEARANCE.
CPG CROSS-CHECKS INSTRUMENT TYPE, LINE TYPE
AND MULTIPLE APPEARANCE BIT IN OTHER TABLES
TO DETERMINE VALID ENTRIES.
WHILE THIS MESSAGE WILL DETECT ISOLATED DATA
BASE ERRORS,
LD-02
LD-03MULTIPLE MESSAGES CAN INDICATE A BAD DUMP
FROM THE SITE FOR PEC RESIDENT MEMORY FILES.
(REVLA).SECOND FIELDPICKUP GROUP NUMBER - PICKUP GROUP TYPE
MUST BE AIF THE PICKUP GROUP NUMBER IS DASHED,
DASHTHEN THE PICKUP GROUP TYPE MUST BE DASHED.
ELEMENTS
HAVE
INCOMPATIBLE
VALUES
LD-03ELEMENT 2 IS
MEANINGLESS
SPECIFICATION
SVR 5210
8187D-471 
						

							Table 21.1CPG Error Messages (Continued)CPG ERROR
MESSAGES
LD-04
LD-04
LD-04
LD-04
LD-04TITLE
2ND FEATURE
IS
MEANINGLESS
SP>l$ClFlCATlON
ELEMENT 2 IS
MEANINGLESS
SPECIFICATION
ELEMENTS
HAVE
INCOMPATIBLE
VALUES
ELEMENTS
HAVE
INCOMPATIBLE
VALUES
2ND FEATURE
IS
MEANINGLESS
SPECIFICATION
SECOND
ELEMENT
CONTAINS
INVALID VALUE
VALUE OF
SECOND
ELEMENT TOO
LARGEDESCRIPTION OF MESSAGES
DIVERT CONDITION 
- DIVERT DESTINATION
VALUE OFALLOWABLE VALUE OF
DIVERT CONDITIONDIVERT DESTINATION
ND
--,TO,LN,AT,RA/TR,RM,PN
BY,NA,BN, OR DATO,LN,AT,RA/TR,RM,PN
D-4728187SVR 5210 
						

							TL-l30400-1001
Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
ELEMENT TOO
ALLOWABLE VALUES OF
DIVERT DESTINATION
IDENTIFIER
-_--
00000000-9999 (A STATION
NUMBER)
0001-0255 (ANY
COMBINATION OF THE8
ATTENDANTS)
XYYY(PEC NO. AND
TRUNK NO.) WHERE:X =
PEC NUMBER YYY =
TRUNK NUMBER
XYYY(PEC NO. AND
TRUNK NO.) WHERE: X =
PEC NUMBER YYY =
TRUNK NUMBER
0000-9999 (HUNT GROUP
PILOT NUMBER)
0001-0008 (SPEED
CALLING LIST ENTRY
NUMBER)
--_-THEDIVERT DESTINATION IS CODED ON THE LM
RECORD, WHILE THE DIVERT DESTINATION
IDENTIFIER I
EQUALS FIRST
ELEMENT
LD-12THE TWO
ELEMENTS
MUST HAVE
THE SAME
VALUELINE LOCATION PEC - DATA LINK LOCATION PEC
THE PEC NUMBER OF THE DATA LINK AND THE PEC
NUMBER OF THE LINE’S PHYSICAL LOCATION MUST
MATCH.
THE DATA LINK PEC IS CODED ON THE LM RECORD
FOR AN ANALOG FEATUREPHONE AND ON THE AD
RECORD FOR AN AGENT PACET INSTRUMENT,
WHILE THE LINE LOCATION PEC IS STILL CODED ON
THE LD RECORD.
LD-13ILLEGAL CARDFEATUREPHONE DATA LINK CARDS MAY NOT BE
SLOTPLACED IN UNIVERSAL SLOT 04 OF FILES C AND D.
SVR 5210
8187D-473 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)CPG ERROR
MESSAGESTITLEDESCRIPTION OF MESSAGES
LD-14
DASHES MUSTDESCRIPTION OF DATA LINK AND LINE LOCATION
BE USED
THE DATA LINK AND LINE LOCATION FIELDS MUST BE
CONSISTENTLYALL DASHES OR ALL FIELDS MUST BE SPECIFIED.
IN--FIELD
LD-15ELEMENTS
HAVE
INCOMPATIBLE
VALUES ,eLD-15
ELEMENT 2 ISAGENT POSITION NUMBER 
- INSTRUMENT TYPE
MEANINGLESSIF THE AGENT POSITION NUMBER IS DASHES THEN
SPECIFICATIONTHE INSTRUMENT TYPE CANNOT BE ‘PACT’;
IF THE AGENT POSITION NUMBER IS NOT DASHES
THEN THE INSTRUMENT TYPE MUST BE ‘POTS’ OR
‘PACT’.
LD-16
INSTRUMENT
- INSTRUMENT TYPE = ‘POTS’:
TYPE 
- OTHER1) THE LINE TYPE MUST BE ‘Ll’ OR ‘--I.FIELDS (ON2) THE CARD LOCATION AND CIRCUIT MUST NOT BE
RECORD CODES DASHED.
LD AND LM)3) THE CLASS OF SERVICE FIELDS MUST NOT BE
DASHED.
4) THE MDR WORK GROUP FIELD MUST BE DASHED.
5) THE CONTROLLING DCP FIELD MUST BE DASHED.
6) THE 
SIGNALLING MODE MUST NOT BE ‘FP’ (LM -LD CHECK).
7) THE DATA LINK MUST BE DASHED (LM 
- LD
CHACK)
8) THE CONTROLLING FEATUREPHONE FIELD MUST
BE DASHED (LM 
- LD CHECK)
9) THE MULTILINE FEATUREPHONE FIELD MUST BE
DASHED (LM 
- LD CHECK).
D-4748187SVR 5210