GTE Omni Si Database Technical Practices Manual

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
FOR DESTINATION TYPE ‘SCC’, THE DESTINATION
TYPE IDENTIFIER MUST BE A VALID TRUNK GROUP
WITH AN APPLICATION TYPE OF ‘COT’, ‘FXT’, ‘TIE’, OR
INCOMPATIBLE
FIELD IS IN A RANGE OF ‘00’ TO 
‘03’,MARY DESTINATION FIELDS CANNOT
FIELD IS IN A RANGE OF ‘04’ TO 
‘07’,MARY DESTINATION FIELDS MUST BE
MEANINGLESS
SPECIFICATION
RT-02ELEMENTS
HAVE
INCOMPATIBLE
VALUES
RT-022ND FEATUREUSAGE FIELD 
- SECONDARY X.25 ROUTE
REQUIRED IFDESTINATION
FIRSTIF THE USAGE FIELD IS ‘01’ OR 
‘02’, THEN THE
SPECIFIEDSECONDARY DESTINATION FIELDS CANNOT BE
DASHED.
IF THE USAGE FIELD IS NOT ‘01’ OR 
‘02’,THEN THE SECONDARY DESTINATION FIELDS MUST
BE DASHED.
RT-03INVALIDX.1 21 ADDRESS
CHARACTERIF THE X.121 ADDRESS IS LESS THAN 14 DIGITS, THEN
STRINGTHE DIGITS MUST BE PACKED TO THE LEFT WITH THE
REMAINING FIELDS DASHED.
SVR 5210
8/87D-51 5 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)
DESCRIPTION OF MESSAGESCHARACTER
SECONDARY X.25 ROUT
DASHES MUST BE USED
THE ENTIRE PHYSICAL L
(PEC, GROUP, CARD SLOT, AND CIRCUIT).
IF ANY OF THE FIELDS ARE DASHED,
THEN ALL MUST BE DASHED.
INCOMPATIBLE
DEFINED ON FR
INCOMPATIBLE
WITH INCOMING
TBEVALIDFOR THECARD TYPE
DEFINED ON FR
(FOR THIS PEC TYPE).
FOR USAGE 00 AND 01,
THE PRIMARY X.25 ROUTE DESTINATION MUST
APPEAR ON A VPLO, 
VPLl, VP20 (VOICE AND DATA OR
DATA), VP21 OR NIC CARD.
FOR USAGE 02,
THE PRIMARY AND SECONDARY X.25 ROUTE
DESTINATION MUST APPEAR ON A VPLO, 
VPLl, VP20
(VOICE AND DATA OR DATA), VP21 OR NIC CARD.
FOR USAGE 03,
THE PRIMARY X.25 ROUTE DESTINATION MUST
THAT INDICATES THAT A CARD IN THE PREVIOUS
LOCATION IS A WIDE CARD AND IT OVERHANGS INTO
HISPHYSICAL 
LOCATI
D-51 68187SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
THE PECGROUPSLOTAND CIRCUIT SPECIFIED
DEFINED ON AN
FRRECORD.
FR
X.1 21 ADDRESS
THE X.121 ADDRESS FOR THE ADMP MUST BE
ADDR MAY BELIMITED TO ONE. ADMP CAN ONLY HAVE ONE
RT-64MUST BEIF ADMP IS SPECIFIED FOR THE USAGE FIELD OF
DEFINED ONDATA SYSTEM ROUTING DATA, THEN AN ADMP CARD
RECORDCODEMUST BE DEFINED ON FR.
FR(ADMPCK)
ADMP NOTUSAGE FIELD-CARD TYPE
SPECIFIED ONIF THE CARD TYPE ADMP IS DEFINED ON RECORD
RTCODE FR THEN AN ADMP MUST BE SPECIFIED ON
RT.
SA-5 1DTMFSELF-EXPLANATORY
RECEIVERS NOT
EQUIPPED ON
RECORD CODE
FR
SA-51DUPLICATE SCCTHE SCC NUMBER WAS SPECIFIED ON A PREVIOUS
NUMBERSA RECORD.
SD-01DASHES MUSTSECONDARY DIRECTORY NUMBERS
BE USEDTHESE FIELDS MUST BE FILLED FROM LEFT TO
CONSISTENTLYRIGHT, WITH DASHES BEING CONSISTENT.
IN FIELD
SVR 5210
Em?D-5? 7 
						

							TL-130400-1001Table 21.1
CPG Error Messages (Continued).
DESCRIPTION 
OF MESSAGES CPG ERROR
MESSAGES
rSD-54
a-01
s-51
SI-52
9-52
w-53
SI-60
SI-61
i
D-51 8TITLE
CLASS OF
SERVICE NOT
DEFINED
.=.PRIMARY DIRECTORY NUMBER 
-THE PRIMARY DIRECTORY NUMBER MUST HAVE AN
N-DISPLAYABLE CLASS OF SERVICE WITH ‘SD’ (CAS
SECONDARY NUMBER) SPECIFIED.
(GENLIN)SD-51
. . .SD-51 
_DIRECTORY
NUMBER 
NO?FOUNDPRIMARY DIRECTORY NUMBER
THIS NUMBER MUST BE A VALID DIRECTORY
NUMBER APPEARING ON AN LD RECORD. (GENLIN)
REQUIRED
DATA NOT
FOUNDA LINE NUMBER WAS FOUND ON AN LD RECORD
WITH A CLASS OF SERVICE SPECIFYING SECONDARY
DIRECTORY NUMBER,
BUT THE LINE NUMBER DID NOT APPEAR AS THE
PRIMARY DIRECTORY NUMBER ON AN SD RECORD.
(GENLIN)
ELEMENTS
HAVE
INCOMPATIBLE
VALUESSKIP 
- OTHER FIELDS
IF THE VALUE ‘SK’ IS SPECIFIED FOR THE SKIP FIELD
THEN ALL FIELDS TO THE RIGHT OF THE SKIP FIELD
MUST CONTAIN DASHES.
DUPLICATE
SENDING
INST./SELECT
ORDERTHE SENDING INSTRUCTION/SELECT ORDER
1;IllNG/T - SELECT ORDER
COMBINATION MUST BE UNIQUE ACROSS ALL 
SlSENDING 
INSTNOT USED ON
TR, NR, OR ST
FORM
SENDING INST.
NOT USEDSENDING INSTRUCTION
A SENDING INSTRUCTION LIST NUMBER WHICH IS
SPECIFIED ON AN SI RECORD SHOULD BE
REFERENCED ON A NR, NT, ST OR TR RECORD.
(ENDCHK)
VALUES MUST
E~NTINU~USSELECT ORDER
SELECT ORDERS MUST BE CONTINUOUS WITH NO
GAPS FOR EACH SENDING INSTRUCTION LIST.
(ENDCHK)
PREFIX INDEXTHE PREFIX INDEX REFERENCED ON THE SI RECORD
NOT FOUNDMUST BE DEFINED ON A PC RECORD.
PREFIX INDEX
NOT FOUNDTHE LDN PREFIX INDEX REFERENCED ON THE SI
RECORD MUST BE DEFINED ON AN LP RECORD.1
8187SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
CODE OF AND MUST THEREFORE BE
D FOR EVERY MERS ROUTE ON RECORD
THE SYSTEM AND NOT OTHERS.
ENSURE THAT ALL ATTENDANTS, LINES, TRUNK
GROUPS, MERS ROUTES, ETC. HAVE FRLS ENTIRELY
ENABLED OR DISABLED.
BER MUST BE UNIQUE
THE DATA SYSTEM USER SECURITY LEVEL MUST BE
UNIQUE ACROSS ALL SL RECORDS.
VEL CAN ONLY
S DEFINED BY THE
SM-52REQUIREDSOURCE GROUP
VALUE NOTFOR EACH SOURCE GROUP APPEARING ON A TC
FOUND ONRECORD THERE SHOULD BE A CORRESPONDING
LISTED FORMSOURCE GROUP MESSAGE ON A SM RECORD.
(ENDCHK)
SP-51DUPLICATE
MESSAGE
NUMBERTHE MESSAGE NUMBER APPEARED ON A PREVIOUS
SP RECORD. 
’SP-52REQUIREDSOURCE GROUP NUMBER
VALUE NOTA SOURCE GROUP NUMBER USED ON A TC RECORD
FOUND ONWAS NOT DEFINED ON AN SP RECORD.
LISTED FORM(ENDCHK)
SVR 5210
8187D-519 
						

							TL-130400-1001
CPG ERROR
MESSAGESTable 21.1CPG Error Messages (Continued)TITLEDESCRIPTION OF MESSAGES
SR-01
. . .INVALID
CHARACTER
STRING
.i_SYMBOLIC REPLACEMENT WORD STRING
CHARACTERS
THE SYMBOLIC REPLACEMENT WORD/STRING
CHARACTER FIELDS ARE COMPOSED OF SYMBOLIC
REPLACEMENT WORD PLUS THE SYMBOLIC
REPLACEMENT STRING.
THE FIRST ‘N’ ASCII CHARACTERS BEFORE THE FIRST
BLANK CHARACTER WILL BE THE SR WORD. THE
NEXT ‘M’ ASCII CHARACTERS FOLLOWING THE FIRST
BLANK CHARACTER WILL BE THE SR STRING. ‘N’ +
‘M’ HAVE TO BE LESS THAN OR EQUAL TO THE TOTAL
OF 63 SYMBOLIC REPLACEMENT
WORDiSTRINGCHARACTERS.
SR-51DUPLICATESYMBOLIC REPLACEMENi ENTRY NUMBER
SYMBOLICTHE SYMBOLIC REPLACEMENT ENTRY NUMBER
REPLACEMENTMUST BE UNIQUE ACROSS ALL SR RECORDS.
ENTRY NUMBER
ST-01ELEMENTS
HAVE
INCOMPATIBLE
VALUES
ST-01ELEMENT 2 IS
MEANINGLESS
SPECIFICATION
ST-012ND FEATURE
REQUIRED IF
FIRST
SPECIFIED
ST-01VALUE OF
SECOND
ELEMENT TOO
SMALL
ST-01VALUE OF
SECOND
ELEMENT TOO
LARGE
ST-01INVALIDINVALID SERVICE CODE
SYNTAXTHE SERVICE CODE MUST BE OF THE FORM 
‘llN’,
‘Nil’, ‘555’, ‘00-l OR ‘OOO’, WHERE ‘N’ IS A NUMBER
BETWEEN 2 AND 9.
D-5206l87SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)
DESCRIPTION OF MESSAGESIST NUMBER AND THE ROUTING LIST
BOTH BE DASHED OR BOTH CONTAIN
NPA/OFFICE/SENOT DEFINED
BERS MUST BE
CONTINUOUS
TIVE WITH NO GAPS.
TIME PERIOD
VALUES MUSTSAME SENDING INSTRUCTION LIST NUMBER AND
NUMBER OF
IT IS POSSIBLE 
i0HAVE ERRONEOUS VALUES IN THE
NUMBER OFROUTING LIST OR SENDING INSTRUCTIONS IF THEY
DO NOT HAVE THE SAME NUMBER OF SELECT
SVR 52108187D-521 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)
SPG ERROR
MESSAGES
ST-60
. . .
SY-01SY-02
SY-03
SY-04
SY-05
SY-06
Sl-51Sl-52
Sl-53
D-522TITLE
#OR 
* BEING
OUTPULSED ON
NON-DTMF
TRUNK GROUP
BLANKSON .
INPUT RECORD
INVALID
CHARACTER
STRING
NUMERIC FIELD
CONTAINS
NON-NUMERIC
DATA
INVALID
CHARACTER
STRING OR
NUMERIC
VALUE
INVALID
CHARACTER
DUPLICATE
SCREENING
TABLES
MDR WORK
GROUP
NUMBER NOT
FOUND ON LD
FORM
MDR DEVICE
NOT ON MD
FORM
8187DESCRIPTION OF MESSAGES
A ROUTING LIST SENDING INSTRUCTION
COMBINATION ASSOCIATES A TRUNK GROUP
(RECORD CODES RP AND Tl) WITH AN OUTGOING
SIGNALING MODE OF ‘DP’ OR 
‘--I WITH A PREFIX
INDEX (RECORD CODES SI, LP AND/ OR PC) THAT
SPECIFIES THE OUTPULSING OF DIGITS 
‘ # ’ AND/ORc*rBLANKS WERE FOUND IN SOME FIELD (OTHER THAN
THE COMMENTS FIELD) ON THE INPUT RECORD.
THE FIELD BEGINNING IN THE LISTED COLUMN
CONTAINS AN INVALID STRING.
THE FIELD BEGINNING IN THE LISTED COLUMN IS TO
CONTAIN NUMERIC DATA (DIGITS O-9) ONLY.
NON-NUMERIC DATA WAS FOUND.
A NUMERIC FIELD CONTAINS A VALUE THAT IS NOT IN
THE ALLOWABLE RANGE OF VALUES FOR THAT
FIELD.
THE FIELD BEGINNING IN THE LISTED COLUMN
CONTAINS AN INVALID VALUE. THE FIELD CAN
CONTAIN EITHER A NUMERIC VALUE OR SOME
CHARACTER STRING (USUALLY L 
- ‘).THE COLUMN LISTED IS TO CONTAIN A CHARACTER
(A-Z), A DIGIT 
(O-9), OR A DASH. AN INVALID
CHARACTER WAS FOUND IN THE COLUMN.
SCREENING TABLE 
- MDR WORK GROUP NUMBER
THE COMBINATION OF SCREENING TABLE AND MDR
WORK GROUP NUMBER MUST BE UNIQUE ACROSS
ALL 
Sl RECORDS.
THE MDR WORK GROUP NUMBER MUST BE
SPECIFIED ON AT LEAST ONE LD RECORD.
THE MDR DEVICE SPECIFIED ON AN 
Sl RECORD
MUST BE A DEVICE ENGINEERED ON AN MD RECORD.
SVR 5210 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
INATION OF MDR DEVICE AND TRUNK
MBER MUST BE UNIQUE ACROSS ALL S2
A 
TlRECORD.
R MAY BE‘Y’MING OR TWO-WAY TRUNK
THE
OtiTGOiNGSCREENING THE OUTGOING
ELEMENT IS
BER MUST BE IN THE
ELEMENT ISRANGE 000 TO 103 ONLY.
TC-51TRUNK GROUPTRUNK GROUP NUMBER
NOT FOUNDTHIS NUMBER MUST BE A TRUNK GROUP DEFINED
ON A 
Tl RECORD.
TC-52TRUNK GROUPTHERE SHOULD BE AT LEAST ONE TRUNK CIRCUIT
DOES NOTON A TC RECORD FOR EACH TRUNK GROUP.
HAVE ANY(GENTRK)
TRUNK
CIRCUITS
TC-55FIELDSUPERVISORY INCOMING SIGNAL
CONFLICTSTRUNKS MARKED FOR FAST ACCESS (‘FA’) IN THE
WITH TRUNKSUPERVISORY INCOMING SIGNAL MUST HAVE A
DIRECTIONDIRECTION OF INCOMING ONLY (‘IN’) ON THE 
TlRECORD FOR THE SPECIFIED TRUNK GROUP.
TC-56CARD TYPE
DEFINED ON FR
INCOMPATIBLE
WITH FCN OF
INCOMING
CARD
SVR 5210
8187D-523 
						

							TL-130400-1001Table 21.1CPG Error Messages (Continued)DESCRIPTION OF MESSAGES
DEFINED ON FR
INCOMPATIBLE
OT, AND CIRCUIT FUNCTION
VALID FOR THE CARD TYPE
DEFINED ON FR (FOR THIS PEC TYPE).
PHYSICAL TRUNK TYPE OF ‘EM’ MUST APPEAR ON AN
‘EMT OR ‘EMT4 TRUNK CARD.
PHYSICAL TRUNK TYPE OF ‘GS’, ‘LP’, AND ‘LD’
(OUTGOING) MUST APPEAR ON A COT TRUNK CARD.
PHYSICAL TRUNK TYPE OF ‘LD’ (INCOMING) MUST
APPEAR ON AN ILT TRUNK CARD.
PAGING/DICTATION CIRCUITS (TRUNK APPLICATION
‘DIC’ OR ‘PAG’ MUST APPEAR ON A 
PDIC CARD.
TRUNKS WITH TRUNK APPLICATION ‘NIC’ MUST
APPEAR ON A NIC CARD.
IF THE CARD TYPE IN THE MESSAGE IS “OVER”,
THAT INDICATES THAT A CARD IN THE PREVIOUS
T OVERHANGS INTO
OT, AND CIRCUIT SPECIFIED
VALID FOR THIS PEC TYPE.
PHYSICALPHYSICAL LOCATION
LOCATION NOTTHE PEC, GROUP, AND SLOT SPECIFIED MUST BE
DEFINED ONDEFINED ON AN FR RECORD.
RECORDCODE
FRTC-56
TC-56PHYSICAL
LOCATION
PREVIOUSLY
FILLED
CARD
OVERHANGS
INTO A
PREVIOUSLY
FILLED SLOTPHYSICAL LOCATION
THE PEC, GROUP, SLOT, AND CIRCUIT SPECIFIED FOR
THE TRUNK CIRCUIT MUST BE UNIQUE.
(PHYLOC)
THIS CARD IS AN OVERSIZED CARD AND IS TRYING
TO FILL TWO SLOTS.
OF THE TWO SLOTS IT FILLS, THE RIGHT HAND ONE
HAS ALREADY BEEN FILLED.
D-5248187SVR 5210
z