Ricoh Mp C3000 Service Manual

							 
INSTALLATION 
SECTION 1    INSTALLATION REVISION HISTORY 
Page Date Added/Updated/New 
57    11/09/2006  Key Counter Bracket 
58 ~ 60  11/09/2006  Key Card Interface Unit 
59      09/05/2009  Key Card Interface Unit 
61    11/09/2006  Anti Condensation Heater 
64    03/23/2007  Controller Options 
72 ~ 73  05/07/2008  Installation 
76      03/30/2007  Data Overwrite Security Unit 
79    03/30/2007  DOS Installation 
83 ~ 84  03/23/2007  VM Card Type C 
85 ~ 86  03/30/2007  Remote Communication Gate 
87 ~ 106  04/22/2008  Fiery E3000 
 
  
						

							Installation Requirements 
SM 1-1 B230/B237/D042 
Installation 
1. INSTALLATION 
1.1 INSTALLATION REQUIREMENTS 
1.1.1 ENVIRONMENT 
 
1.  Temperature Range: 10°C to 32°C (50°F to 89.6°F) 
2.  Humidity Range: 15% to 80% RH 
3.  Ambient Illumination: Less than 1500 lu x (do not expose to direct sunlight) 
4.  Ventilation: 3 times/hr/person or more 
5.  Do not let the machine get exposed to the following:    1) Cool air from an air conditioner 
2) Heat from a heater 
6.  Do not install the machine in areas  that are exposed to corrosive gas. 
7.  Install the machine at locations lowe r than 2,500 m (8,200 ft.) above sea level. 
8.  Install the machine on a strong, level bas e. (Inclination on any side must be no more 
than 5 mm.) 
9.  Do not install the machine in  areas that get strong vibrations. 
1.1.2 MACHINE LEVEL 
Front to back: Within 5 mm (0.2) 
Right to left: Within 5 mm (0.2)  
						

							 
B230/B237/D042 1-2 SM 
1.1.3  MACHINE SPACE REQUIREMENTS 
 
ƒ  This machine, which uses high volt age power sources, can generate ozone gas. 
High ozone density is harmful  to human health. Therefore, the machine must be 
installed in a well-ventilated room. 
 
A: Over 100 mm (3.9) 
B: Over 100 mm (3.9) 
C: Over 100 mm (3.9) 
D: Over 100 mm (3.9) 
Put the machine near the power source with the clearance shown above. 
1.1.4 POWER REQUIREMENTS 
 
ƒ  Insert the plug firmly in the outlet. 
ƒ  Do not use an outlet extension plug or cord. 
ƒ  Ground the machine. 
1.  Input voltage level:    120 V, 60 Hz: More than 12 A   
220 V to 240 V, 50 Hz/60 Hz: More than 8 A 
2.  Permissible voltage fluctuation: ±10 % 
3.  Do not put things on the power cord.  
						

							  
SM 1-3 B230/B237/D042 
Installation 
1.2  OPTIONAL UNIT COMBINATIONS 
1.2.1 MACHINE OPTIONS 
 
No.   Options  Remarks 
1  2-tray paper feed unit 
2  Large capacity tray  One from No.1 or No.2 
3 Platen cover 
4 ARDF 
One from No.3 or No.4 
5  1-bin tray unit 
- 
6 Bridge unit 
7 Shift tray  One from No.6 or No.7 
8  1000-sheet booklet finisher   One from No.8, No.10 or No.11; 
Requires No.6 and one from No.1 and 
No.2. 
9  *Punch kit (3 types) 
No. 8 required; One of the three types 
10 1000-sheet finisher   One from No.8, No.10 or No.11; 
Requires No.6 and one from No.1 and 
No.2. 
11 500-sheet finisher 
One from No.8, No.10 or No.11; 
Requires No.6. 
*: Child options (Child opti
ons require a parent option.)  
						

							 
B230/B237/D042 1-4 SM 
1.2.2 CONTROLLER OPTIONS 
No.  Options  Remarks 
1 IEEE 1394 
2  USB Host Interface Unit  One from the two (I/F Slot A) 
3 IEEE 802.11b 
4 IEEE 1284 
5 Bluetooth One from the three (I/F Slot B) 
6 File Format Converter 
I/F Slot C 
Requires fax unit option (B786) 
7 PostScript 3 
8 PictBridge Option 
9  Data Overwrite Security Unit One from the three (SD card slot 2) 
11  Browser Unit 
SD card slot 3 (during installation only) 
12  Copy Data Security Unit  - 
  
						

							  
SM 1-5 B230/B237/D042 
Installation 
1.3 COPIER INSTALLATION 
 
ƒ  Make sure that the image transfer belt is  in its correct position before you move the 
machine. Otherwise, the image transfer  belt and the black PCU can be damaged. 
1.3.1  POWER SOCKETS FOR PERIPHERALS 
 
ƒ  Rating voltage for peripherals.   
ƒ  Make sure to plug the cables into the correct sockets. 
  
						

							 
B230/B237/D042 1-6 SM 
1.3.2 INSTALLATION FLOW CHART 
This flow chart shows the best procedure for installation. 
 
You need the optional paper tray unit or the LCT  if you want to install the finisher (B408 or 
B793). 
The punch unit is for 1000-sheet booklet finisher (B793).  
						

							  
SM 1-7 B230/B237/D042 
Installation 
1.3.3 ACCESSORY CHECK 
Check the quantity and condition of these accessories. 
 
 Description  Qty Destination  
1.  Operating Instruction - Troubl eshooting  1  -57 -29 -58 -21 -19 
2.  Operating Instruction - About This Machine  1  -57 -29 -58 -21 -19 
3.  Operating Instruction - Security  1  -57 -29 -58 -21 -19 
4.  Operation Instruction - Quick Reference Guide  1  -29 -21 -19 
5.  Operation Instruction - Printer Quick Reference  1  -29 -21 -19 
6.  Operation Instruction - Scanner Quick Reference 1  -29 -21 -19 
7.  CD-ROM - Instruction  1  -29 
8.  CD-ROM - Printer Instruction - RIC 1  -67 -29 -26 
9.  CD-ROM - Printer Instruction - NRG  1  -67 
10.  CD-ROM - Printeer Instruction - LAN  1  -67 
11.  CD-ROM - Scanner Instruction - RIC 1  -67 -29 -26 
12.  CD-ROM - Scanner Instruction - NRG  1  -67 
13.  CD-ROM - Scanner Instruction - LAN 1  -67 
14.  Model Name Decal 1  -57 -67 -29 -58 
15  Stamp 1  -57 -29 -28 -19 -58 
16 Cloth Holder 1 -57 -67 -29 -28 -21 -19 
-58 -26 
17  Exposure Glass Cleaning Cloth 
1 -57 -67 -29 -28 -21 -19 
-58 -26 
18 Rivet 
2 -57 -67 -29 -28 -21 -19 
-58 -26  
						

							 
B230/B237/D042 1-8 SM 
 Description Qty Destination  
19  Operating Instructions Holder  1 -57 -67 -29 -28 -21 -19 
-58 -26 
20 Ferrite Core 
1 -57 -67 -29 -28 -21 -19 
-58 -26 
21  Power Supply Cord 
1 -57 -67 -29 -28 -21 -19 
-58 
22 Cover 
1 -57 -67 -29 -28 -21 -19 
-58 -26 
23  Decal - Paper Size 
1 -57 -67 -29 -28 -21 -19 
-58 -26 
24  Emblem Cover 
1  -57 -67 -29 -58 
25  Sheet - Eula: 16 Languages 1  -57 -67 -29 -26 -58 
26  Sheet - Caution 16 Languages 1  -57 -67 -29 -26 -58 
27  Decal - Safety Sheet  1  -67 -26 
28  Decal - Caution - Original 1  -67 -29 -28 -26 -57 -58
29  Sheet Data  1  -67 -29 -28 -26 -21 
30  Decal - Caution - Inkjet 1  -67 -26 (14 Lang.) 
31  Sheet - Caution - Security Reference  1  -29 
32  Warranty Sheet (Chinese)  1  -21 
33  Sheet - Name - Tel  1  -21