Oce PlotWave 300 User Manual

							Working area [Footprint]
The printing system (with or without the optional 'Océ Scanner Express') requires a floor
space / working area of at least 1710 mm x 1470 mm (67.3 inches x 57.9 inches).
Chapter 2 - Get to know the printing system
21
Working area [Footprint]
Downloaded From ManualsPrinter.com Manuals162cm63.8” 171cm
67.3”7cm
2.8”
147cm
57.9” 9cm
3.5”
60cm
23.6 ”
80c
m
31.5 ”  
						

							Approved abbreviations
#
AbbreviationName
'Océ EWT''Océ Express WebTools'
' Océ PlotWave 300 MF Ex-
press'
' Océ PlotWave 300 multifunction Express'
Chapter 2 - Get to know the printing system
22
Approved abbreviations
Downloaded From ManualsPrinter.com Manuals 
						

							The Océ PlotWave 300 hardware
The components of the printer (front)
Illustration
Component - function table
#
Description / FunctionComponentNr
Remove this cover if you want to move the
printer.
lower left front cover1
Door at the front, used for error recovery.lower front cover2
To manually feed cut-sheets up to 36"
width.
media bypass3
Compartment for toner refill.toner compartment4
Only available in printer-only version.printer top cover5
Delivery tray for the printed sheets.top delivery tray6
USB connector to use a USB mass storage
device to print from or to scan to, if a
scanner is available.
USB flash drive interface7
Chapter 2 - Get to know the printing system
23
The components of the printer (front)
Downloaded From ManualsPrinter.com Manuals8
1
2
3
4
9
10
11
12
675   
						

							Description / FunctionComponentNr
Allows the user to start copy/scan/print jobs
and to monitor the system and the job sta-
tus.
user panel8
Media drawer that contains the media roll
1 and/or 2.
media drawer9
Button to start or shut down the printer.
This button is equivalent to the 'Shut
down' button in the Océ Express
WebTools.
on / off button10
lower right front cover11 /
B
Swivel wheel with brakes.wheel12
Chapter 2 - Get to know the printing system
24
The components of the printer (front)
Downloaded From ManualsPrinter.com Manuals 
						

							The components of the printer (left side)
Illustration
Component - function table
#
Description / FunctionComponentNr
Gives access to the residual toner container.residual toner compartment1
Chapter 2 - Get to know the printing system
25
The components of the printer (left side)
Downloaded From ManualsPrinter.com Manuals1   
						

							The components of the printer (back)
Illustration
Component - function table
#
Description / FunctionComponentNr
Switch to cycle on or off the mains power.
You can find the serial number of the
printer on the sticker above the power
switch.
power switch1
Open the upper back cover with the media
jam clearance handle to access the fuser
section in case of a media jam in the fuser
section.
upper back cover2
Use this handle to access the paper in case
of a paper jam.
media jam clearance handle3
Chapter 2 - Get to know the printing system
26
The components of the printer (back)
Downloaded From ManualsPrinter.com Manuals3
1
2   
						

							The media drawer
Illustration
Component - function table
#
Description / FunctionComponentNr
Carries the media rollroll holder1
media roll 12
media roll 2 (optional)3
Groove integrated behind the front cover
of the media drawer.
roll loading station4
This button is used to trim a strip of a new
or damaged media roll.
clean cut button5
Chapter 2 - Get to know the printing system
27
The media drawer
Downloaded From ManualsPrinter.com Manuals1
2
35
4   
						

							The user panel
Illustration
Component - function table
#
Description / FunctionComponentNr
The button with a green light that allows the
operator to start a scan job, a print job or a
copy job.
The button lights up to attract attention when
it becomes relevant and it can be pressed.
green button1
Chapter 2 - Get to know the printing system
28
The user panel
Downloaded From ManualsPrinter.com Manuals1
2
3
5 4 6
7 8
9 10 11 12   
						

							Description / FunctionComponentNr
The button with a red light that allows the
operator to do the following.
■Immediately interrupt a scan job.
■Stop a print job after the page that is being
printed.
The button lights up to attract attention when
it becomes relevant.
stop button2
Button that allows the operator to select the
option displayed in the lower left corner of
the user panel display.
lower left soft key3
The USB connection is positioned at the left
side of the user panel.
You can insert a USB mass storage device do
the following.
■Print a file directly from the USB mass
storage device.
■Scan an original directly to the USB mass
storage device.
Only if a scanner is available.
The green light that illuminates the port and
the icon starts to blink during data transfer
USB flash drive interface4
The color display that displays information
for the operator.
user panel display5
Button that allows the operator to select the
option displayed in the upper left corner of
the user panel display.
upper left soft key6
Button that allows the operator to select the
option displayed in the upper right corner of
the user panel display.
upper right soft key7
Light that gives feedback on the status of the
printer.
■A green light indicates that the printer is
ready.
■A green blinking light indicates that the
printer is busy.
■A red light indicates that an error occurred.
status light8
Chapter 2 - Get to know the printing system
29
The user panel
Downloaded From ManualsPrinter.com Manuals 
						

							Description / FunctionComponentNr
Button that allows the operator to do the fol-
lowing.
■Open a template or a setting.
■Close and confirm the selected value of a
setting.
confirmation button9
Wheel on the right side of the user panel that
allows the operator to do the following.
■Scroll through the templates.
■Scroll through the settings.
■Scroll through the settings values.
scroll wheel10
Buttons with the numeric values 0-9, that al-
low the operator to do the following.
■Enter a numeric value, for example the
number of copies.
■Enter a numeric value of a setting.
numeric buttons11 /
B
With the clear button the operator can delete
the last added numeric character.
clear button(C)
Button that allows the operator to select the
option displayed in the lower right corner of
the user panel display.
lower right soft key12
Chapter 2 - Get to know the printing system
30
The user panel
Downloaded From ManualsPrinter.com Manuals