GTE Omni Scbs Installation And Maintenance Manual

							.  
						

							TEN PROGRAMMABLE FEATURE BUTTONS (TWO 
PREPROGRAMMED DATA COMMUNICATION BUTTONS: 
DATA CALL AND VOICE/DATA MODE) 
FOUR FIXED FEATURE BUTTONS: SPEAKERPHONE, MUTE, 
TRANSFER, AND HOLD 
SPEAKERPHONE 
FOUR LINE, 20 CHARACTER LCD DISPLAY 
INTERFACE THROUGH 8DTC CARD 
LINE POWERED 
TWO WIRE: 
- 2 DIGITAL TIP AND RING 
2000 FEET LOOP LIMIT 
MAY BE CONNECTED TO BLF/DSS MODULE @;;~‘;~~t:~,,,.,~ 
OPTIONAL DATA TERMINAL ADAPTER (DTA) INSTALLED 
WITHIN CSD PROVIDES RS-232-C INTERFACE TO 
CUSTOMER-SUPPLIED DATA TERMINAL 
SYSTEM CAPACITY OF 40 CSD TELEPHONES 
INTERFACE (8 CIRCUITS X 5 CARDS) OR 30 CSD 
TELEPHONES WITH DTA INTERFACE (6 CIRCUITS X 5 
CARDS) 
c c \q. $. _.” g 3 
1.26  
						

							Portable Maintenance Panel 
MICRO PRINTE 
TAPE EJECT 
SCREEN VIEW ANGLE 
0 
0 
0 
0 
CABLE CONNECTED TO l/6 PORT 0 (DEFAULT SETTING) 
1200 BAUD (DEFAULT SETTING) 
QPTlONAL FWPPY DlSKETTE DRIVE UNIT (REQUIRES EXPANSION 
RAM FOR PMP) 
1.27  
						

							tional Flo tte Drive 
. EPSON TF-20 FLOPPY DISKETTE DRIVE UNIT MAY BE USED FOR 
SAVING AND LOADING INSTEAD OF PMP’S BUILT-IN MICROCASSETTE 
TAPE DRIVE. 
@ PMP REQUIRES INSTALLATION OF EXPANSION RAM (EXPANSION 
UNIT H20 EU) FOR DISKETTE DRIVE OPERATION. 
1.28  
						

							@ SUPPORTS THE RECORDING OF 
SYSTEM CALL RECORDS 
PERTAINING TO OUTGOING TRUNK 
CALLS AND TRUNK-TO-TRUNK 
CALLS. a p tlj 
0 TRANSFERSDATAATRATESOF 
110,150,300,600,1200,2400, OR 
4800 BAUD AS DETERMINED IN THE 
SYSTEM DATA BASE. 
0 INTERFACES WITH THE SYSTEM 
MICROPROCESSOR VIA THE RS-232-C 
PORT 1 (DEFAULT SETTING). 
NOTE: SMDR OUTPUT MAY INTERFACE TO A MINI-COMPUTER, DISK 
DRIVE OR OTHER MASS STORAGE DEVICES. 
1.29  
						

							e ALLOWS INCOMING CALLS TO BE DIVERTED TO A NIGHT BELL 
ATTACHED TO A STATION EQUIPMENT NUMBER WHICH HAS BEEN 
DESIGNATED AS A NIGHT ANSWER STATION. 
8 NIGHT BELL INTERFACES TO THE SYSTEM THROUGH THE 8 SLC AND 
RGEN CARDS. 
. NIGHT BELLS ARE CUSTOMER FURNISHED. 
1.30  
						

							MUSIC SOURCE: 
@ FM RADIO 
. PACKAGED MUSIC 
PROVlDES MUSIC TO CALLNG PARTIES FOR THE DURATION OF TIME 
THE CALL IS PLACED IN THE HOLD QUEUE. 
MUSIC SOURCE INTERFACES TO THE SYSTEM VIA A UNIVERSAL 
SLOT. MUSIC SOURCE IS COUPLED THROUGH 4BWC CARD. 
MUSIC SOURCE MUST BE 600 fl IMPEDENCE. 
NOTE: NO LIMITATION EXISTS FOR THE NUMBER OF LINES OR TRUNKS 
THAT CAN BE CONNECTED TO THE MUSIC-ON-HOLD FEATURE. 
1.31  
						

							ICG 
swc 
EKI 
DTI 
SLI 
PFT 
BWT 
ETT 
LTT 
DTMFR 
SCI 
CPU 
BMEM 
MEM 
CPM INTERFACE CARD GROUP 
SWITCH CONTROL CARD 
ELECTRONIC KEY INSTRUMENT 
INTERFACE 
DIGITAL TELEPHONE INTERFACE 
SINGLE LINE INSTRUMENT 
INTERFACE 
POWER FAILURE TRANSFER 
BOTHWAY TRUNK INTERFACE 
E&M TIE TRUNK INTERFACE 
LOOP TIE TRUNK INTERFACE 
DTMF RECEIVER 
SERIAL COMMUNICATION 
INTERFACE 
CENTRAL PROCESSOR UNIT 
BASIC MEMORY 
MEMORY 
CENTRAL PROCESSING AND 
MEMORY CARD 
DTA 
R CSD 
psi+-- 
IpEp= 
FX- 
WATS C 
co 
WFAXTS __ 
PABX 
MUSIC SOURCE 
EXTERNAL PAGING 
TIE - 
(E&M) 
TIE - 
(LOOP) 
MODEM 
i-l 
SEKC 
EKI 
, 
I 
~ EKI 
ICG 
swc 
A 
[ 
N 
E 
M 
C : 
MDR 
PRINTER  
						

							ent Not 
1.33