Inter-Tel Imx/Gmx 416/832 Installation Manual

							INTER-TELPRACTKES PROGRAMMING 
IMX/GMX 416/832 INS’IALLATION % MAINTENANCE Issue 1, November 1994 
FIGURE 5-25. TRUNK GROUPS, DID GROUPS & 
RING-IN/ANSWER PAlTERNS (Continued) 
DID Groups: Duplicate and fill out this form for each DID group. - a 
DID Group Number I 
Description I 
Tenant Group 
Music-On-Hold I 
1 
Music #l or Music #2 or Silence or Tick Tones 
start Type 
Base Number 
Starting Digits 
Number of Entries 
DISA Codes 
‘Itunksln 
DID Group 
1 Immediate or Wiuk or Delay 
Day: 
Night: Required for IC Calls? Yes or No 
Complete the following information for each DID number iu the DID group: 
DID NlJMeERS 
AND NAMES RING-IN: Enter Single (Ext n), Muttiple (Ring-in Pattern), HunWCD (Pilot tl), 
or DlSA(Toll Restktions) 
DAY RING-IN TYPE: 
NIGHT RING-IN TYPE: 
I I 
I 
I 
Page S-237  
						

							PROGRAMMING Issue 1, November 1994 INTER-TELPRACTICES 
IMWGMX 
416/832 INSTALLATION & MAINTENANCE 
FIGURE 5-25. TRUNK GROUPS, DID GROUPi dk -‘ 
RING-IN/ANSWER PATTERNS 
(Continued) .j 
i 
Ring/Answer Patterns: Duplicate and fill out this form for each Ring/Answer Pattern. 
Pattern Number 
Pattern Title 
Stations with Ring-in 
stations with Answer 
Permission 
Page 5-238  
						

							INTER-TELPRACTICES PROGRAMMING 
JMX/GMX 416/832 BWJXLLATION & MAINTENANCE Issue 1, November 1994 
FIGURE 5-26. Tl PROGRAMMING fll) 
For ALL Tl Cards: 
Thresholds: 
Dialing Feedback Configuration: 
IJTMF Dialing Gain: 
Pulse Feedback Gain: 
DEFAULT VALUE 
-4dB 
-4dB 
NEW VALUE 
Pulse Tone Channel Number: I 7 I 
Clock Backup: (List Tl Cards in order of system clock backups. The RCPU Card is always last.) 
For EACH Tl Card: (Make copies of this chart for each Tl Card. ) 
1 Card Slot Number: I I 
Card m: 
Zero-Code Suppression: 
PCM Encoding Law: 
Relay(s) Activated: 
csu: 
LB0 Attenuation: 
Line Length (in feet): 
Clock- 
Loop Operation: 
Tl From Public Network: 
Provides System Ref. Clock: D4SuperfYrame or 
ESF 
AMI (Bit 7) or B8ZS or None 
Mu-to-Mu or Mu-to-A or A-to-A or A-to-Mu 
One or Wivo 
On-Board or DSX-1 
O-133 or 133-266 or 266-399 or 399-533 or 533-655 
Master or Slave 
Yes or No 
Yes or No 
Page 5-239  
						

							PROGRAMMING 
INTER-TELPRACTICES 
Issue 1, November 1994 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
FIGURE 5-27. 
A’ITJXNDANTS - ALIAS PROGRAMMING (ALSS) 
Aliases: 
I STATION I ALIASES 
I 
I 
I I I I I I 
Page 5-240  
						

							INTER-TELPRACTICES 
PROGRAMMING 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE Issue 1, November 1994 
FIGURE 5-28. AlTENDANTS - DSS/BLF UNITS (INS) 
DSWBLF Units: 
Page S-241  
						

							PROGRAMMING 
Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
FIGURE 5-29. CALL COST (COST) 
Page 5-242  
						

							INTER-TELPRACTICES PROGRAMhIlNG 
lMX/GMX 416/832 INS’JXLLATION & MAINTENANCE Issue 1, November 1994 
FIGURE 5-30. SMDA (MDA) 
output port: 
Reporting interval: 
reelect one andjill in 
bzfonnation. 
Format - 
Account Code report 
Summary reports 
Detailed reports 
stations included: Serial 1 or Serial 
2 
Attendant Only: Yes or No 
Daily: 
Time of day: 
Weekly: Day of week: Time of day: 
Monthly: Day of month: Time of day: 
Clear account code data following report? Yes or No 
System-wide or Tenant or Tenant/Department 
Select all that apply: 
All users in tenantldept. groups Yes or No 
Top system users Yes or No 
Top users by tenant Yes 
or No 
Top users by tenant./dept. Yes 
or No 
Rank by total cost Yes 
or No 
Rank by total duration Yes 
or No 
Rank by total number of calls Yes 
or No 
Number of “top” users per report: 
Bunt Groups included: 
Ihmks included: 
Clear station/hunt/trunk data 
Following report? Yes or No 
Page 5-243  
						

							PROGKUMMING 
INTER-TELPRACTICES 
Issue 1, November 1994 
IMI4GM.X 416/832 INSTALJATION 8z MAINTENANCE 
FIGURE 5-31. SMDR (SMDR) “ 
1 
.j 
Dutput port: Serial 1 or Serial 2 
[s Output Active? Yes or No 
Zalis to be recorded in reports: 
Select all that apply: 
All Inmming Calls Yes or No 
All Local Calls Yes or No 
All Toll Calls Yes or No 
All DISA Calls Yes or No 
All Conference Calls Yes 
or No 
All DID Calls 
Yes or No 
All Ring-In Diagnostics Yes or No 
3uppress all absorbed digits? Ye-s or No 
3uppress all but the first toll digit? Yes 
or No 
Suppress all digits after end of dialing? Yes or No 
Display elapsed time in seconds? Yes or No 
List of stations to be included: 
Page 5-244  
						

							INTER-TELPRACTICES PROGRAMMING IMX/GMX 416/832 INSTALLATION & MAlNTENANCE Issue 1. November 1994 
FIGURE 5-32. ERROR REPORTS (ERR) 
output port: 
I Serial 1 or Serial 2 
Is output active? 
Report all alarms [+++I ? tY or N 
I 
IY or N I 
Report all field service diagnostics [***I ? 
Report all engineering diagnostics [---_I ? Y or N 
Y or N 
_ 
- - I 
Log all SEND messages to history queue? IY or N I 
FIGURE 5-33. PASSWORDS (PASS) 
Applications Restricted Password: 
Applications Unrestricted Password: 
Monitor Restricted Password: 
Monitor Unrestricted Password: 
Page 5-245  
						

							PROGRAMMING 
INTER-TJZLPRACTICES 
Issue 1, November 1994 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
FIGURE 5-34. 
SERIAL PORT CONFIGURATION (PORT) 
serial Port 1: 
Enable DSR Handshaking: 
Enable CTS Handshaking: 
Baud Rate (circle one): Yes or No 
Yes or No 
I 
I110 
300 600 1200 2400 4800 9600 
19200 
Serial Port 2: 
Enable DSR Handshaking: IYesorNo I 
Enable CTS Handshaking: Yes or No 
Baud Rate (circle one): 110 
300 600 1200 2400 4800 9600 
19200 
Page 5-246